Part No: A1-009 - A1 Series Tilt Switch - Mercury Features: * * * * Insulated * Form: NO/NC/SPST/Mount dependant * Angles Referenced from Horizontal Single Electrode Hermetically Sealed * Small Package Size * Extremely Narrow Included Angle * High Current Capability * Low Contact Resistance Long Life Drawing dimensions in inches. Tilt switches “make” when the electrode is tilted below horizontal and “break” when tilted above the horizontal. Total travel from “make” to “break” is the “Maximum included angle” shown below. The component to which the switch is attached must have a total tilt angle greater than the “Maximum included angle” for proper operation. Must Break Angle * : Maximum included Angle: Switch Ratings: Max Switching Voltage Max Switching Current Initial Contact Resistance (Max). Stand Off Voltage (contact to contact) Operating Temperature Storage Temperature Typical number of operations at specified load G-Force Activation G-Level/Range Dimensions: Weight per 100pcs. Lbs / Kgs: Body Length (less leads). Inches / Millimeters: Maximum width over bracket. Inches / Millimeters: Materials: Lead Wire Type Lead wire length/skive/termination Finish: © American Electronic Components Inc 2012 Specifications are subject to change without notice. E&OE. + 0.7º 1.4º * Make/break angles are electrode + (above) / (below) 0° horizontal reference 120V 60Hz 1 Amp max @ 120VAC, 1 million operations 50 milli Ohms 1500 VAC -38º to 220ºF / -38º to 105ºC -40º to 356ºF / -40º to 180º C 10,000,000 N/A 1.220 / 31.0 1.07 / 27.18 # 18AWG silicon grey 6” / ring terminals Nylon 6/12 (33% glass filled) American Electronic Components Inc., 1101 Lafayette Street, Elkhart, Indiana. USA Tel: +1-574-295-6330 Fax: +1-574-293-8013 Email: [email protected] http://www.aecsensors.com A1 009 060612