THE REVISION STATUS OF ALL SHEETS OF THIS DRAWING IS THE SAME AS SHEET 1 LTR - DESCRIPTION Released DATE BY 3/22/04 JCL I. MATERIALS & FINISHES center contact: Gold Plated Brass outer contact: Nickel Plated Brass coupling nut: Nickel Plated Brass body: Nickel Plated Brass crimp sleeve: Nickel Plated Copper dielectric: Teflon PTFE gasket: Silicone Rubber shrink sleeve: Adhesive Lined Polyolefin attachment: braid crimp (.429”hex) II. ELECTRICAL PROPERTIES impedance: 75 ohms working voltage: 1000 vrms (max) vswr: 1.35:1 (max) up to 2.0 GHz insertion loss: 0.10 x √Fghz Unless otherwise specified, dimensions are in inches. Tolerances are applicable when specified. These drawings and specifications contain proprietary information which is the property of Times Microwave Systems. Approvals TIMES MICROWAVE SYSTEMS Wallingford, CT 06492 Drawn JCL (203) 949-8400; (203) 949-8423.Fax 3/22/04 www.timesmicrowave.com EZ-400-NM-75 Type-N male Straight Plug for LMR-400-75 Cable Size A CAGE CODE 68999 Scale: NA Drawing No.: Rev. (-) 3190-1618 Sheet: 1 of 1 TIMES MICROWAVE SYSTEMS EZ-400-NM-75 (stock code: 3190-1618) Type N PLUG Non-solder center contact Crimp-on (.429" hex. die) outer contact INSTALLATION INSTRUCTIONS (Cable Types: LMR-400-75) SLIGHT CHAMFER 3/16” (.180) 9/32” 5/8”(.590) ( 280) STEP 1 WEATHER SEAL 1. (A) Trim cable to dimensions shown. (B) Remove any residual plastic from center conductor. (C) Deburr center conductor using a fine file or Times DBT-01 tool. (D) Avoid nicking aluminum tape. 2. (A) Slide weather seal and crimp ferrule over cable. (B) Flare braid and insert cable into connector body until dielectric is seated with all braid wires on outside of connector body and aluminum tape inside connector body. (C) Braid should assemble flush to within 1/16” (.06) of connector shoulder. Trim excess if necessary. CRIMP FERRULE TRIM BRAID STEP 2 STEP 3 3. (A) Slide crimp ferrule over braid and crimp as close to body as possible using hex. die indicated in a Times HX-4 crimp tool or equivalent. Do not crimp rear of crimp ferrule.