CM15MD1-12H Powerex, Inc., 200 Hillis Street, Youngwood, Pennsylvania 15697-1800 (724) 925-7272 CI Module Three Phase Converter + Three Phase Inverter 15 Amperes/600 Volts A G L L J H K K K NOT CONNECTED K L K K H (4 PLACES) K P1 A K GU EU GV EV GW EW GU GV GW E C Q U D R B LABEL D Q F E R S T N P "T" THICK S N W V U V W P H H H H X Y 30° MAIN TERMINAL Z CONTROL TERMINAL K P1 GU GV GW EU EV EW GU GV R S T A GW N E U V W Outline Drawing and Circuit Diagram Dimensions Inches Millimeters Dimensions Inches Millimeters A 3.54 90.0 N 0.65 16.5 B 2.52 64.0 P 0.49 12.5 C 1.26 32.0 Q 1.04 26.5 D 0.35 9.0 R 2.09 53.0 E 3.15 80.0 S 0.08 2.0 Description: Powerex CI Modules are designed for use in switching applications. Each module consists of a three phase diode converter section and a three phase IGBT inverter section. All components and interconnects are isolated from the heat sinking baseplate, offering simplified system assembly and thermal management. Features: □ Low Drive Power □ Low VCE(sat) □ Discrete Super-Fast Recovery (70ns) Free-Wheel Diodes □ High Frequency Operation (20-25 kHz) □ Isolated Baseplate for Easy Heat Sinking Applications: □ AC Motor Control □ Motion/Servo Control □ General Purpose Inverters □ Robotics Ordering Information: Example: Select the complete nine digit module part number you desire from the table below - i.e. CM15MD1-12H is a 600V (VCES), 15 Ampere CI Power Module. F 0.20 5.0 T 0.02 0.5 G 0.30 7.5 U 2.13 54.0 H 0.32 8.0 V 0.04 1.0 J 0.48 12.28 W 0.03 0.8 K 0.10 2.54 X 0.32 8.0 Type Current Rating Amperes VCES Volts (x 50) L 0.30 7.62 Y 0.21 5.3 CM 15 12 M 0.19 4.8 Z 0.20 5.0 1 Powerex, Inc., 200 Hillis Street, Youngwood, Pennsylvania 15697-1800 (724) 925-7272 CM15MD1-12H CI Module Three Phase Converter + Three Phase Inverter 15 Amperes/600 Volts Absolute Maximum Ratings, Tj = 25°C unless otherwise specified Characteristics Symbol CM15MD1-12H Units °C Power Device Junction Temperature Tj -40 to 150 Tstg -40 to 125 °C Mounting Torque, M4 Mounting Screws — 13 in-lb Module Weight (Typical) — 60 Grams Isolation Voltage, AC 1 minute, 60Hz VRMS 2500 Volts Converter Part Repetitive Peak Reverse Voltage VRRM 800 Volts Recommended AC Input Voltage Ea 220 Volts DC Output Current IO 20 Amperes IFSM 300 Amperes I2t 375 A2s Storage Temperature Surge (Non-repetitive) Forward Current I2t for Fusing IGBT Inverter Part Collector-Emitter Voltage (G-E Short) VCES 600 Volts Gate-Emitter Voltage (C-E Short) VGES ±20 Volts Collector Current IC 15 Amperes ICM 30 Amperes IE 15 Amperes Emitter Current** (Pulse)* IEM 30 Amperes Maximum Collector Dissipation PC 45 Watts Collector Current (Pulse)* Emitter Current** Electrical and Mechanical Characteristics, Tj = 25°C unless otherwise specified Characteristics Converter Sector Repetitive Reverse Current Forward Voltage Drop Thermal Resistance (Junction-to-Fin) IGBT Inverter Sector Collector Cutoff Current Gate-Emitter Threshold Voltage Gate-Emitter Cutoff Current Collector-Emitter Saturation Voltage Test Conditions Min. Typ. Max. Units IRRM VR = VRRM, Tj = 150°C — — 8 mA VFM IF = 20A — — 1.5 Volts Rth(j-f) Per Diode — — 3.6 °C/W ICES VCE = VCES, VGE = 0V — — 1 mA VGE(th) VCE = 10V, IC = 1.5mA 4.5 6.0 7.5 Volts IGES VGE = VGES, VCE = 0V — — 0.5 µA VCE(sat) VGE = 15V, IC = 15A, Tj = 25°C — 2.1 2.8 Volts VGE = 15V, IC = 15A, Tj = 150°C — 2.15 — Volts — — 1.5 nF — — 1.2 nF — — 0.3 nF Input Capacitance Cies Output Capacitance Coes Reverse Transfer Capacitance Cres Total Gate Charge Resistive Turn-on Delay Time Load Rise Time Switching Turn-off Delay Time Times Fall Time VGE = 0V, VCE = 10V QG VCC = 300V, IC = 15A, VGE = 15V — 45 — nC td(on) VGE1 = VGE2 = 15V, — — 120 nS tr VCC = 300V, IC = 15A, — — 300 nS td(off) Rg = 42Ω, — — 200 nS tf Resistive Load — — 300 nS VEC IE = 15A, VGE = 0V — — 2.8 Volts Reverse Recovery Time trr IE = 15A, VGE = 0V, — — 110 nS Reverse Recovery Charge Qrr diE/dt = -30A/µs — 0.04 — µC Per IGBT — — 2.8 °C/W Per FWDi — — 3.5 °C/W Emitter-Collector Voltage Thermal Resistance (Junction-to-Fin) 2 Symbol Rth(j-f) *Pulse width and repetition rate should be such that device junction temperature does not exceed maximum rating. **Characteristics of the anti-parallel emitter-collector free-wheel diode. Powerex, Inc., 200 Hillis Street, Youngwood, Pennsylvania 15697-1800 (724) 925-7272 CM15MD1-12H CI Module Three Phase Converter + Three Phase Inverter 15 Amperes/600 Volts 30 5 VCE = 10V Tj = 25°C Tj = 125°C 12 15 VGE = 20V 20 11 10 10 9 7 20 10 8 0 0 0 2 4 6 8 10 4 3 2 1 0 0 4 8 12 16 0 20 10 20 30 GATE-EMITTER VOLTAGE, VGE, (VOLTS) COLLECTOR-CURRENT, IC, (AMPERES) COLLECTOR-EMITTER SATURATION VOLTAGE CHARACTERISTICS (TYPICAL) FREE-WHEEL DIODE FORWARD CHARACTERISTICS (TYPICAL) CAPACITANCE VS. VCE (TYPICAL) 101 102 Tj = 25°C IC = 30A 6 IC = 15A 4 2 CAPACITANCE, Cies, Coes, Cres, (nF) 8 EMITTER CURRENT, IE, (AMPERES) Tj = 25°C 101 Cies 100 Coes 10-1 10-2 100 4 8 12 16 0 20 2.4 3.2 HALF-BRIDGE SWITCHING CHARACTERISTICS (TYPICAL) REVERSE RECOVERY CHARACTERISTICS (TYPICAL) REVERSE RECOVERY TIME, t rr, (ns) 103 td(off) td(on) VCC = 300V VGE = ±15V RG = 42Ω Tj = 125°C tr 101 COLLECTOR CURRENT, IC, (AMPERES) 102 100 t rr 101 100 101 EMITTER CURRENT, IE, (AMPERES) 101 102 GATE CHARGE, VGE di/dt = -30A/µsec Tj = 25°C Irr 100 COLLECTOR-EMITTER VOLTAGE, VCE, (VOLTS) 101 102 10-3 10-1 4.0 EMITTER-COLLECTOR VOLTAGE, VEC, (VOLTS) tf 101 100 1.6 GATE-EMITTER VOLTAGE, VGE, (VOLTS) 103 102 0.8 10-1 102 20 GATE-EMITTER VOLTAGE, VGE, (VOLTS) 0 0 Cres VGE = 0V f = 1MHz IC = 6A REVERSE RECOVERY CURRENT, Irr, (AMPERES) COLLECTOR-EMITTER SATURATION VOLTAGE, VCE(sat), (VOLTS) VGE = 15V Tj = 25°C Tj = 125°C COLLECTOR-EMITTER VOLTAGE, VCE, (VOLTS) 10 SWITCHING TIME, (ns) COLLECTOR-EMITTER SATURATION VOLTAGE, VCE(sat), (VOLTS) Tj = 25oC COLLECTOR CURRENT, IC, (AMPERES) COLLECTOR CURRENT, IC, (AMPERES) 30 COLLECTOR-EMITTER SATURATION VOLTAGE CHARACTERISTICS (TYPICAL) TRANSFER CHARACTERISTICS (TYPICAL) OUTPUT CHARACTERISTICS (TYPICAL) 16 VCC = 200V 12 VCC = 300V 8 4 0 0 10 20 30 40 50 60 GATE CHARGE, QG, (nC) 3 Powerex, Inc., 200 Hillis Street, Youngwood, Pennsylvania 15697-1800 (724) 925-7272 10-3 101 TRANSIENT THERMAL IMPEDANCE CHARACTERISTICS (IGBT) 10-2 10-1 100 100 10-1 10-1 10-2 10-2 10-3 Zth = Rth • (NORMALIZED VALUE) 10-5 TIME, (s) 4 101 Single Pulse TC = 25°C Per Unit Base = R th(j-f) = 2.8°C/W 10-4 10-3 10-3 NORMALIZED TRANSIENT THERMAL IMPEDANCE, Z th(j-f) NORMALIZED TRANSIENT THERMAL IMPEDANCE, Z th(j-f) CM15MD1-12H CI Module Three Phase Converter + Three Phase Inverter 15 Amperes/600 Volts 10-3 101 TRANSIENT THERMAL IMPEDANCE CHARACTERISTICS (FWDi) 10-2 10-1 100 101 Single Pulse TC = 25°C Per Unit Base = R th(j-f) = 3.5°C/W 100 10-1 10-1 10-2 10-2 10-3 Zth = Rth • (NORMALIZED VALUE) 10-5 TIME, (s) 10-4 10-3 10-3