SINGLE PHASE BRIDGE RECTIFIER VOLTAGE RANGE CURRENT FBPC25005WN THRU FBPC2510WN 50 to 1000 Volts 25 Ampere FEATURES • Low cost This series is UL recognized under component index file number E127707 High forward surge current capability Fast switching for high efficiency Integrally molded heatsink provide very low thermal resistance High isolation voltage from case to leads High temperature soldering guaranteed: 260℃ / 10 seconds,at 5 lbs. (2.3kg) tension. • • • • • • 1.13(28.8) 0.47(11.9) 1.11(28.2) 0.43(10.9) 0.732(18.6) 0.692(17.6) 0.205(5.2) 0.197(5.0) 0.732(18.6) 0.692(17.6) 1.13(28.8) 1.11(28.2) METAL HEAT SINK 0.46(11.7) 0.41(10.5) EXOPY CASE 0.78(19.8)MIN MECHANICAL DATA • 0.042(1.10)DIA 0.038(0.97)TYP • Case: Molded plastic body Terminal: Plated 0.04″(1.02mm)diameter Polarity: Polarity symbols marked on case Mounting: Thru hole for #10 screw, 20 in,-lbs Torque Max. Weight: 0.47 ounce, 13.4 gram • MAXIMUM RATINGS AND ELECTRICAL CHARACTERISTICS • Ratings at 25OC ambient temperature unless otherwise specified Single Phase, half wave, 60Hz, resistive or inductive load For capacitive load derate current by 20% • • • • • SYMBOL FBPC 25005WN FBPC 2501WN FBPC 2502WN FBPC 2504WN FBPC 2506WN FBPC 2508WN FBPC 2510WN UNIT Maximum Repetitive Peak Reverse Voltage VRRM 50 100 200 400 600 800 1000 Volts Maximum RMS Voltage VRMS 35 70 140 280 420 560 700 Volts Maximum DC Blocking Voltage VDC 50 100 200 400 600 800 1000 Volts Maximum Average Forward Rectified Output Current, at TC = 50℃ (Note 1,2) I(AV) 25 Amps IFSM 300 Amps I2t 373 A2s Peak Forward Surge Current 8.3mS single half sine wave superimposed on rated load (JEDEC method) Rating for Fusing (t<8.3mS) Maximum Instantaneous Forward Voltage Drop per Bridge element at 12.5 A Maximum DC Reverse Current at Rated DC Blocking Voltage per element Typical Thermal Resistance (Note 1,2 ) Operating Temperature Rang Storage Temperature Rang 1.2 1.3 TA = 25 ℃ TA = 100 ℃ Maximum DC Reverse recovery time(Note3) Isolation Voltage from case to lead VF IR Trr 10 µA 1.0 mA 150 250 VISO Volts 2500 500 NS VAC O RθJc 2.0 TJ (-65 to +150) O (-65 to +150) O TSTG C/W C C Notes: 1. 2. 3. Unit mounted on 5” x 6” x 4.9” (12.8cm x15.2cm x 12.4cm) AL finned Plate Bolt down on heat-sink with silicon thermal compound between bridge and mounting surface for maximum beat transfer efficiency with #10 screw Reverse recovery test conditions: IF=0.5A,IR=1.0A,IRR =0.25A 1 E-mail: [email protected] Web Site: www.cnmic.com SINGLE PHASE BRIDGE RECTIFIER FBPC25005WN THRU FBPC2510WN VOLTAGE RANGE CURRENT 50 to 1000 Volts 25 Ampere FORBIDDEN 2 E-mail: [email protected] Web Site: www.cnmic.com