AZ733 DPDT MINIATURE POWER RELAY FEATURES • • • • • • • Dielectric strength 5000 Vrms Low cost Epoxy sealed version available 12 Amp switching — double pole contacts Isolation spacing greater than 8mm UL, CUR file E44211 TÜV certificate R50129285 CONTACTS Arrangement DPST (2 Form A) DPDT (2 Form C) Ratings Resistive load: Max. switched power: 300 W or 3324 VA Max. switched current: 12 A Max. switched voltage: 250 VDC* or 400 VAC * Note: If switching voltage is greater than 30 VDC, special precautions must be taken. Please contact the factory. Rated Load UL 10 A at 250 VAC, 85°C, 100k cycles [1] 8 A at 30 VDC, 85°C, 100k cycles [1] 1/4 HP at 240 VAC, 85°C [1] 1/8 HP at 120 VAC, 85°C [1] TV-3 at 125 VAC, 85°C, 25k cycles [1] 2 Form A 10 A at 30 VDC, 85°C, 100k cycles [1] 3/4 HP at 250 VAC [3] 2 Form C 10 A at 250 VAC, 85°C, 100k cycles [1][2][3] 10 A at 30 VDC, 85°C, 50k cycles [1] 10 A at 30 VDC, 85°C, 30k cycles [2] 1/3 HP at 125 VAC [2][3] 2 Form C - normally open contacts 12 A at 277 VAC resistive, 70°C, 80K cycles [2][3] 10 A at 30 VDC, 85°C, 25k cycles [3] 2 Form C - normally closed contacts 12 A at 277 VAC resistive, 70°C, 10K cycles [2][3] 10 A at 30 VDC, 85°C, 100k cycles [3] TÜV 10 A at 250 VAC resistive, 70°C, 30k cycles [1][2] 10 A at 30 VDC, 70°C, 20k cycles [1][2] 2 Form A 12 A at 250 VAC resistive, 70°C, 10k cycles [2][3] 10 A at 250 VAC resistive, 70°C, 50k cycles [3] Material Silver cadmium oxide [1], silver nickel [2], silver tin oxide [3] Resistance < 50 milliohms initially GENERAL DATA Life Expectancy Mechanical Electrical Minimum operations 1 x 107 1 x 105 at 10 A 250 VAC Res. Operate Time (typical) 8 ms at nominal coil voltage Release Time (typical) 5 ms at nominal coil voltage (with no coil suppression) Dielectric Strength 5000 Vrms coil to contact (at sea level for 1 min.) 1000 Vrms between open contacts 3000 Vrms between contact sets Insulation Resistance 1000 megohms min. at 20°C, 500 VDC, 50% RH Dropout Greater than 10% of nominal coil voltage Ambient Temperature Operating Storage -40°C (-40°F) to 85°C (185°F) -40°C (-40°F) to 105°C (266°F) Vibration 0.062" (1.5 mm) DA at 10–55 Hz Shock 10 g Enclosure P.B.T. polyester Terminals Tinned copper alloy, P.C. Max. Solder Temp. 270°C (518°F) Max. Solder Time 5 seconds Max. Solvent Temp. 80°C (176°F) Max. Immersion Time 30 seconds Weight 18 grams Packing unit in pcs 50 per plastic tray / 500 per carton box COIL Power At Pickup Voltage (typical) 257 mW Max. Continuous Dissipation 1.9 W at 20°C (68°F) ambient Temperature Rise 34°C (61°F) at nominal coil voltage Temperature Max. 130°C (266°F) NOTES 1. All values at 20°C (68°F). 2. Relay may pull in with less than “Must Operate” value. 3. Specifications subject to change without notice. ZETTLER electronics GmbH Junkersstrasse 3, D-82178 Puchheim, Germany Tel. +49 89 800 97 0 Fax +49 89 800 97 200 [email protected] www.ZETTLERelectronics.com 2010-12-17 AZ733 RELAY ORDERING DATA COIL SPECIFICATIONS Nominal Coil VDC 3 5 6 9 12 18 24 48 60 110 Must Operate VDC 2.1 3.5 4.2 6.3 8.4 12.6 16.8 33.6 42.0 79.3 ORDER NUMBER* Max. Continuous VDC 5.7 9.4 11.4 17.4 22.8 27.9 45.7 89.0 115.3 170.5 Coil Resistance Ohm 17 ± 10% 47 ± 10% 68 ± 10% 160 ± 10% 275 ± 10% 650 ± 10% 1,100 ± 15% 4,170 ± 15% 7,000 ± 15% 22,900 ± 15% Form A (DPST) AZ733–2A–3D AZ733–2A–5D AZ733–2A–6D AZ733–2A–9D AZ733–2A–12D AZ733–2A–18D AZ733–2A–24D AZ733–2A–48D AZ733–2A–60D AZ733–2A–110D Form C (DPDT) AZ733–2C–3D AZ733–2C–5D AZ733–2C–6D AZ733–2C–9D AZ733–2C–12D AZ733–2C–18D AZ733–2C–24D AZ733–2C–48D AZ733–2C–60D AZ733–2C–110D * Add suffix “B” to “2A” or “2C” for silver nickel contacts. Add suffix “E” to “2A” or “2C” for silver tin oxide contacts. Add suffix “E” for epoxy sealed version. MECHANICAL DATA PC BOARD LAYOUT .590 (15) .51 (13) .197 .197 (5) (5) .295 (7.5) 0.015 (0.38) 1.02 (25.9) .160 ± .015 (4.2 ± .4) 1.14 (29) .08 (2.1) 8 x ø .05 [ø 1.3] (Form C only) Viewed toward terminals WIRING DIAGRAM Terminal No. Dimensions Tol.: ± 0.005 (0.13) 1,2,4,5,7,8 0.018 (0.457) x 0.038 (0.965) 3,6 0.011 (0.279) x 0.038 (0.965) Form A Form C 1 3 4 1 2 3 4 8 6 5 8 7 6 5 Viewed toward terminals Dimensions in inches with metric equivalents in parentheses. Tolerance: ± .010" ZETTLER electronics GmbH Junkersstrasse 3, D-82178 Puchheim, Germany Tel. +49 89 800 97 0 Fax +49 89 800 97 200 [email protected] www.ZETTLERelectronics.com 2010-12-17