CONDUCTIVE POLYMER ALUMINUM SOLID CAPACITORS PXF TM NPCAP - Surface Mount Upgrade! Series ・Super low ESR, impedance and high heat resistance have been obtained by using conductive polymer as electrolyte. ・Rated voltage range : 2 to 10Vdc, Capacitance range : 120 to 1,000µF ・Case size range :φ5×3.9L toφ8×7.7L ・Suitable for DC-DC converters, voltage regulators and decoupling applications used on computer motherboards etc. ・Solvent resistant type (see PRECAUTIONS AND GUIDELINES) ・RoHS Compliant ・Halogen Free PXF Lower ESR PXE P40 ◆SPECIFICATIONS Items Characteristics Category Temperature Range Rated Voltage Range Capacitance Tolerance Surge Voltage Leakage Current Dissipation Factor (tanδ) Low Temperature Characteristics (Max. Impedance Ratio) Endurance -55 to +105℃ 2 to 10Vdc ±20% (M) Rated voltage×1.15 Shall not exceed values shown in STANDARD RATINGS. (at 20℃, 120Hz) (at 105℃) (at 20℃ after 2 minutes) 0.12 max. (at 20℃, 120Hz) Z(-25℃)/Z(+20℃)≦1.15 Z(-55℃)/Z(+20℃)≦1.25 (at 100kHz) The following specifications shall be satisfied when the capacitors are restored to 20℃ after the rated voltage is applied for 15,000 hours (E40, E46, F45 : 3,000 hours ) at 105℃. Appearance No significant damage Capacitance change ≦±20% of the initial value D.F. (tanδ) ≦150% of the initial specified value ESR ≦150% of the initial specified value Leakage current ≦The initial specified value The following specifications shall be satisfied when the capacitors are restored to 20℃ after subjecting them to the DC rated voltage at 60℃, 90 to 95% RH for 1,000 hours (E40, E46, F45 : 500 hours ) . Appearance No significant damage Capacitance change ≦±20% of the initial value D.F. (tanδ) ≦150% of the initial specified value ESR ≦150% of the initial specified value Leakage current ≦The initial specified value The capacitors shall be subjected to 1,000 cycles each consisting of charge with the surge voltage specified at 105℃ for 30 seconds through a protective resistor(R=1kΩ) and discharge for 5 minutes 30 seconds. Appearance No significant damage Capacitance change ≦±20% of the initial value D.F. (tanδ) ≦150% of the initial specified value ESR ≦150% of the initial specified value Leakage current ≦The initial specified value 0.5% per 1,000 hours maximum (Confidence level 60% at 105℃) Bias Humidity Surge Voltage Failure Rate *Note : If any doubt arises, measure the leakage current after the following voltage treatment. Voltage treatment : DC rated voltage is applied to the capacitors for 120 minutes at 105℃. ◆DIMENSIONS [mm] ●Terminal Code : A EX) 2.5V390µF P 0.3max. L±0.3 (Note) Size Code E40 E46 E61 F45 C±0.2 B±0.2 φD±0.5 W F61 F80 H70 H80 A±0.2 Note : L+0.1/-0.2 for E40, E46 and F45 ◆PART NUMBERING SYSTEM 1 2 3 4 A PXF 5 6 7 8 9 ◆MARKING 10 A RA 11 12 13 14 M 15 16 17 φD 5 5 5 6.3 6.3 6.3 8 8 L 3.9 4.5 5.8 4.4 5.8 7.7 6.7 7.7 A 5.3 5.3 5.3 6.6 6.6 6.6 8.3 8.3 B 5.3 5.3 5.3 6.6 6.6 6.6 8.3 8.3 C 5.9 5.9 5.9 7.2 7.2 7.2 9.0 9.0 W 0.5 to 0.8 0.5 to 0.8 0.5 to 0.8 0.5 to 0.8 0.5 to 0.8 0.5 to 0.8 0.7 to 1.1 0.7 to 1.1 P 1.4 1.4 1.4 1.9 1.9 1.9 3.1 3.1 F69A 390 2.5V 18 G Supplement code Size code Capacitance tolerance code Capacitance code (ex. 330µF:331, 1,000µF:102) Taping code Terminal code Voltage code (ex. 2.5V:2R5, 10V:100) Series code Category Please refer to "Product code guide (conductive polymer type)" Product specifications in this catalog are subject to change without notice.Request our product specifications before purchase and/or use. Please use our products based on the information contained in this catalog and product specifications. 38 CAT. No. E1001P CONDUCTIVE POLYMER ALUMINUM SOLID CAPACITORS TM NPCAP Surface Mount PXFSeries Upgrade! - ◆STANDARD RATINGS WV (Vdc) Cap (µF) Size code Leakage current (µA max./after 2min.) 2 680 220 220 330 330 390 390 470 560 560 560 680 1,000 330 390 470 560 680 150 150 150 220 220 270 330 330 330 390 470 560 120 270 F61 E40 E46 E61 F45 E61 F61 F80 F61 F80 H70 H70 H80 F61 F80 H70 H70 H80 E40 E46 E61 E61 F61 F80 F61 F80 H70 H70 H80 H80 E61 F61 700 700 700 700 700 700 292 352 700 420 420 510 750 396 468 564 672 816 700 700 700 700 415 510 700 623 623 737 888 1,050 240 540 2.5 4 6.3 10 ESR Rated ripple current (mΩ max./20℃, 100k to 300kHz) (mArms/105℃, 100kHz) 12 12 25 10 12 10 10 9 10 9 10 10 9 10 9 10 10 9 20 25 12 12 10 9 10 9 10 10 9 9 22 20 3,500 3,300 2,100 3,900 3,500 3,900 3,900 4,200 3,900 4,200 4,500 4,500 4,500 3,900 4,200 4,500 4,500 4,500 2,700 2,100 3,500 3,500 3,900 4,200 3,900 4,200 4,500 4,500 4,500 4,500 2,600 2,800 Part No. APXF2R0ARA681MF61G APXF2R5ARA221ME40G APXF2R5ARA221ME46G APXF2R5ARA331ME61G APXF2R5ARA331MF45G APXF2R5ARA391ME61G APXF2R5ARA391MF61G APXF2R5ARA471MF80G APXF2R5ARA561MF61G APXF2R5ARA561MF80G APXF2R5ARA561MH70G APXF2R5ARA681MH70G APXF2R5ARA102MH80G APXF4R0ARA331MF61G APXF4R0ARA391MF80G APXF4R0ARA471MH70G APXF4R0ARA561MH70G APXF4R0ARA681MH80G APXF6R3ARA151ME40G APXF6R3ARA151ME46G APXF6R3ARA151ME61G APXF6R3ARA221ME61G APXF6R3ARA221MF61G APXF6R3ARA271MF80G APXF6R3ARA331MF61G APXF6R3ARA331MF80G APXF6R3ARA331MH70G APXF6R3ARA391MH70G APXF6R3ARA471MH80G APXF6R3ARA561MH80G APXF100ARA121ME61G APXF100ARA271MF61G Product specifications in this catalog are subject to change without notice.Request our product specifications before purchase and/or use. Please use our products based on the information contained in this catalog and product specifications. 39 CAT. No. E1001P