D-TYPE ACTIVE MODULE E5771-01 for 28 mm Side-on PMT The E5771-01 is a voltage divider to operate a 28 mm Side-on photomultiplier tube. The compact configuration is convenient to attach directly on tracing circuit board. Additionally, the built-in circuit utilizes transistor devices in the final three stages, so that the E5771-01 can give superior DC linearity characteristic under a low power consumption. SPECIFICATIONS Parameter Description / Value Unit 28 mm Side-on type — Applicable PMT 1500 V Max. Supply Voltage between Case and Pins V 1500 Max. Supply Voltage between Pin#1 and #11 mA 0.29 Max. Divider Current between Pin#1 and #11 0.44 (at 1500 V) W Max. Power Consumption Between Pin#1 and #11 Ω 1 × 1011 Insulation Resistance between Case and Pins Min. Voltage Distribution Ratio among Pin#1 to #11 1: 1: 1: ...... : 1: 1: 1 — 100 µA Max. Linear Output in DC Mode Typ. Operating Temperature -20 to +50 °C Figure 2: Maximum Output under ±1 % DC Linearity of E5771-01 Figure 1: DC Linearity of E5771-01 TACCB0051EC (In the case of R928 with negative high voltage usage) TACCB0053EB 20 E5771-01 ANODE OUTPUT CURRENT (A) DEVIATION (%) CONVENTIONAL D-TYPE : SUPPLY VOLTAGE = -1000 V 10 E5771-01 : SUPPLY VOLTAGE = -300 V 0 E5771-01 : SUPPLY VOLTAGE = -1000 V -10 10-7 (In the case of R928 with negative high voltage usage) 10-3 10-6 10-5 10-4 OUTPUT ANODE CURRENT (A) 10-3 10-4 10-5 CONVENTIONAL D-TYPE 10-6 10-7 -300 -400 -500 -600 -700 -800 -900 -1000 -1100 -1200 -1300 SUPPLY VOLTAGE (V) Subject to local technical requirements and regulations, availability of products included in this promotional material may vary. Please consult with our sales office. Information furnished by HAMAMATSU is believed to be reliable. However, no responsibility is assumed for possible inaccuracies or omissions. Specifications are subject to change without notice. No patent rights are granted to any of the circuits described herein. ©2011 Hamamatsu Photonics K.K. D-TYPE ACTIVE MODULE E5771-01 Figure 3: Dimensional Outline and Circuit Diagram of E5771-01 (Unit: mm) Figure 4: The Example of Completed Divider Circuit with E5771-01 (TOP VIEW) 1 2 3 11 HAMAMATSU 4 10 E5771-01 9 5 8 7 6 +0.8 15 -0.2 LEAD PINS 2 3 4 5 6 7 9 8 10 11 〈 FOR –HV〉 DY1 DY2 DY3 DY4 DY5 DY6 DY7 DY8 DY9 -HV *A *A MARK OF PIN #1 PIN # 1 2 510 kΩ 510 kΩ 510 kΩ 510 kΩ 510 kΩ 510 kΩ 2 5 6 8 7 E5771-01 10 11 0.01 µF 0.022 µF 0.047 µF TRANSISTOR CIRCUIT E5771-01 0.8 (PCD = 12.2) 9 〈 FOR +HV〉 *A 30° DY1 DY2 DY3 DY4 DY5 DY6 DY7 DY8 DY9 (BOTTOM VIEW) SIGNAL OUTPUT *A *A 2 3 4 5 6 7 8 9 10 11 *A +HV 11 10 9 7 *A P PMT K 1 3 4 5 6 4 510 kΩ 510 kΩ 510 kΩ 510 kΩ 510 kΩ 510 kΩ PIN # 1 *PIN # 3 TRANSISTOR CIRCUIT 0.4 12.2 SIGNAL OUTPUT P PMT K 0.01 µF 0.022 µF 0.047 µF 10 ± 1 12.5 ± 0.5 PLASTIC CASE (UL 94V-0) PIN # 1 510 kΩ 510 kΩ 510 kΩ 510 kΩ 510 kΩ 510 kΩ 8 SUGGESTED PRINTED CIRCUIT BOARD LAYOUT FOR E5771-01 E5771-01 0.01 µF 0.022 µF 0.047 µF TRANSISTOR CIRCUIT *A: To be installed outside E5771-01 TACCA0180EC TACCC0108EB Figure 5: The Example of How to Use SOLDERING E5771-01 TRACING CIRCUIT BOARD (TO BE FURNISHD BY USER) DIRECTLY MOUNTABLE SOCKET TO TRACING CIRCUIT BOARD 28 mm (1-1/8") SIDE ON PMT TYPE; E678-11M SOCKET PINS SOCKET PMT TACCC112EB CAUTION • When getting output anode current over operating area shown at Figure 2, there may be a sudden change in output. It would be caused by divider current but not lead E5771-01 to break down. • When supplying high voltage with opposite polarity by mis-handling in connection with E5771-01 mounted on a printed circuit board, it might lead an internal damage in E5771-01. Therefore, please take care to see the polarity of high voltage and correct electro-connections before operation. • Also, if short-circuit should be produced by mistake or something among pin#1 to #11 in operation, it may lead an internal Damage in E5771-01. • The specifications described herein are subject to change without notice. HAMAMATSU PHOTONICS K.K. www.hamamatsu.com HAMAMATSU PHOTONICS K.K., Electron Tube Division 314-5, Shimokanzo, Iwata City, Shizuoka Pref., 438-0193, Japan, Telephone: (81)539/62-5248, Fax: (81)539/62-2205 U.S.A.: Hamamatsu Corporation: 360 Foothill Road, P. O. Box 6910, Bridgewater. N.J. 08807-0910, U.S.A., Telephone: (1)908-231-0960, Fax: (1)908-231-1218 E-mail: [email protected] Germany: Hamamatsu Photonics Deutschland GmbH: Arzbergerstr. 10, D-82211 Herrsching am Ammersee, Germany, Telephone: (49)8152-375-0, Fax: (49)8152-2658 E-mail: [email protected] France: Hamamatsu Photonics France S.A.R.L.: 19, Rue du Saule Trapu, Parc du Moulin de Massy, 91882 Massy Cedex, France, Telephone: (33)1 69 53 71 00, Fax: (33)1 69 53 71 10 E-mail: [email protected] United Kingdom: Hamamatsu Photonics UK Limited: 2 Howard Court, 10 Tewin Road Welwyn Garden City Hertfordshire AL7 1BW, United Kingdom, Telephone: 44-(0)1707-294888, Fax: 44(0)1707-325777 E-mail: [email protected] North Europe: Hamamatsu Photonics Norden AB: Smidesvägen 12, SE-171-41 SOLNA, Sweden, Telephone: (46)8-509-031-00, Fax: (46)8-509-031-01 E-mail: [email protected] TACC1050E01 Italy: Hamamatsu Photonics Italia: S.R.L.: Strada della Moia, 1/E, 20020 Arese, (Milano), Italy, Telephone: (39)02-935 81 733, Fax: (39)02-935 81 741 E-mail: [email protected] OCT. 2011. IP