BLED-12W Series Budget Series Switch Mode LED Drivers Constant Current with Isolation Black Magic Thermal Advantage™ Plastic Housing Electrical Specifications Input Voltage Range: 100-277 Vac Nom. (90-305 V Min/Max) Frequency: 50/60 Hz Nom. (47-63 Hz Min/Max) Power Factor: >0.90 @ full load, 120V; >0.80 @ full load, 277V Inrush Current: <10.0 A max @ 230 Vac, cold start 25ºC Input Current: 0.18 A max @ 120 Vac; 0.10 A max @ 230 Vac Maximum Power: 12W Line Regulation: ± 4% Load Regulation: ± 5% THD: < _ 20% @ full load Leakage Current: 300 µA Typical Hold Up Time: Half Cycle Start-up Time: < 1.0 S Output Protection: Over-Voltage, Over-Current, Short Circuit (auto-recovery) Environmental Specifications Minimum Starting Temp: -30ºC Storage Temperature: -40ºC to +85ºC Maximum Case Temp. 90°C Humidity: 5% to 95% Cooling: Convection Sound Rating: Class A Vibration Frequency: 5 to 55 Hz/2g, 30 minutes MTBF: 580,000 Hours @ full load, 40ºC per MIL-217F Notice 2 Impact Resistance: 1g/s Weight: 3.9 oz. (110 g) • Smaller footprint than our standard drivers • Total Power: 12 Watts • Input Voltage: 100-277 Vac • Indoor Applications, IP64 • UL Dry or Damp Location Rated • 2 year Warranty Constant Current - Product Specifications Model Number Output Current Output Voltage (mA ±5%) Range (Vdc) Max. Output Typical Power (W) Efficiency BLED12W-150-C0080 80 90-150 12 89% BLED12W-100-C0120 120 60-100 12 89% BLED12W-048-C0250 250 28-48 12 88% BLED12W-043-C0280 280 26-43 12 87% BLED12W-036-C0350 350 21-36 12.6 86% BLED12W-024-C0500 500 15-24 12 85% BLED12W-018-C0660 660 11-18 12 84% BLED12W-016-C0800 800 10-16 12.8 83% BLED12W-012-C1000 1000 7-12 12 82% Class 2: US/Canada US Only E332160 Note: LED drivers are designed and intended to operate LED loads only. Non-LED loading may be outside the specified design limits of our LED drivers, and therefore cannot be covered by any warranty. If you desire to use our LED drivers to operate non-LED loads please contact us to discuss compatibility. Specifications subject to change without notice. Rev 8-12-15 Thomas Research Products • 1215 Bowes Rd • Elgin, IL 60123 • T 847-515-3057 • F 847-515-3047 • www.trpssl.com BLED12W Series SSL Solutions Faster Than The Speed Of Light® Pg 2 of 2 0.14 [3.5] 2 x Ø 0.137 [3.5] HOT SPOT 5.91 Min [150 Min] 5.91 Min [150 Min] 0.39±0.04 [10.0±1] Output Red (+) Blue (-) 1.5 [38.1] WIRE SPECS: Input Leads: 18 AWG, rated 600 V, 105C, min. Output Leads: 18 AWG, rated 300 V, 105C, min. All wires are stranded with solder dipped ends. 4 0.98 [25] Input White (N) Black (L) 0.51 [13] 3.0 [75.9] 0.14 [3.5] 0.7 [18] 0.65 [16.5] 0.39±0.04 [10.0±1] Dimensions - mm 1.23 [31.2] Lifetime / Case Temperature 135 Safety and EMC Compliance UL/CUL CE FCC, 47CFR Part 15 EN61000-3-2 EN61000-3-3 Lifetime (kHrs) 120 105 90 75 UL8750, CSA-C22.2 EN61347 Class B Class C 60 45 30 15 0 40 45 50 55 60 65 70 75 80 Case Hotspot Temperature (°C) 85 90 Note: Life calculations are based on reliability with confidence using a 90% confidence level and <5% failure rate. At a confidence level of 90% it is expected that <5% of the parts will fail at the rated life provided. (Failure is defined as a driver drifting outside specification, rather than fail to operate) UL Conditions of Acceptability See website for additional information Note: Disconnect power to LED driver for at least 30 seconds before connecting or disconnecting Driver output and LED Engine. This prevents potential arcing transients that can damage the Engine and Driver. See Hot Plugging in our Driver Application Guide for more information. Thomas Research Products • 1215 Bowes Rd • Elgin, IL 60123 • T 847-515-3057 • F 847-515-3047 • www.trpssl.com