DG81C sub miniature automotive power relay • Sub miniature - only 15.7 x 12.3 x 13.8mm • Up to 2 x 35A SPST-NO-DM • For indicators, hazard warning & ABS • Cost effective • RoHS Compliant Contacts Contact number & arrangement SPST-NO-DM (1 Form U) Contact material AgNi0.15; AgSnOInO; AgCdO Max. switching voltage Min. switching current / voltage DC 16VDC (consult factory for 24VDC) 1mA/5VDC (AgNi0.15), 0.5A/12VDC (AgSnOInO) Rated load DC1 2 x 30A Max. continuous current DC1 2 x 30A (2 mins) Max. switching current Make 2 x 35A (Lamp load inrush) Break 2x 12.5A Initial resistance 100mΩ, max. at 0.1A/6VDC Coil Rated voltage DC 6...12V Must release voltage See coil table 1 Operating range of supply voltage See coil table 1 Rated power consumption DC 0.85W Insulation Insulation resistance 100MΩ at 500VDC, 50%RH Dielectric strength coil to contact 500Vrms, 1min contact to contact 500Vrms, 1min General Data Operating time (typical) mS 10 Release time (typical) mS 5 Electrical Life ops 1 x 105 Mechanical life ops 1 x 107 Dimensions Weight L x W x H 15.7 x 12.3 x 13.8mm 6g approx. Ambient temperature storage -40 to 100°C operating -40 to 85°C Shock resistance Functional: 10g 11mS; Destructive: 100g Vibration resistance DA 1.5mm 10-55Hz Page 1 of 2 Ref: DG81C 121913JHM www.aecsensors.com Sales Department Tel: (888) 847-6552 DG81C sub miniature automotive power relay Coil Data Table 1 Coil Voltage Code Nominal Voltage (VDC) Coil Resistance (Ω) ±10% Must operate voltage max. (VDC) Must release voltage min. (VDC) 1006 6 42 3.5 0.5 1009 9 94 5.2 0.7 1010 10 117 6.3 0.8 1012 12 167 7.3 1.0 Ordering codes Contact material Type D G 8 1 C - Contact arrangement 8 U Cover protection and mounting - 5 Coil code - Contact material 20 - AgNi (90/10) 70 - AgSnOInO 80 - AgNi (0.15) See coil table 1 Contact arrangement 8U - SPST-NO-DM Cover protection category 2 - in cover, flux tight - IP40 3 - in cover, sealed - IP67 Connection mode 5 - for PCB Overall Dimensions, PCB Mounting Holes & Wiring Diagram Dimensions in mm Notes: 1) All parameters, unless otherwise specified, are measured at an ambient temperature of 23°C. 2) Maximum make current refers to inrush current of lamp load. 3) Electrical life obtained at lamp load, at resistive load 2 x 6A, 14VDC with 1ms ON, 14ms OFF. 4) Electrical life is strongly dependent of switching frequency, ON/Off ratio, environmental conditions and load type. Specifications are subject to change without notice. E&OE. Page 2 of 2 Ref: DG81C 092310JHM www.aecsensors.com Sales Department Tel: (888) 847-6552