TOSHIBA TC75S58AFC

TC75S58AFE/AFC
TC75S58AFE,TC75S58AFC
Single Comparator(Open-Drain Output)
The TC75S58AFE and TC75S58AFC are CMOS general-purpose
single comparators. The devices can operate from a single supply
voltage and are designed for a lower supply-current than
conventional general-purpose bipolar comparators. The output is
designed for Open-Drain Output and can supply a higher voltage
than the power supply. Therefore, it is possible to pull-up the
voltage to a level higher than that of the power supply. The
Open-Drain Output can be wired-OR with another Open-Drain
Output circuit.
TC75S58AFE
* Output voltage should not exceed the maximum rating
TC75S58AFC
Feature
•
Low Supply Current: IDD = 10 μA (Typ.)
•
Single Power Supply Operation
•
Wide Common Mode Input : VSS~VDD − 0.9 V
•
Open-Drain Output Circuit
•
Low Input Bias Current
•
Small Package
CSON6-P-0.45
Weight
SON5-P-0.50
: 0.003 g (Typ.)
CSON6-P-0.45 : 0.002 g (Typ.)
Marking (top view)
Pin Assignment (top view)
TC75S58AFE
TC75S58AFE
5
4
VDD
OUT
5
4
TG
1
2
1
IN (−)
3
TC75S58AFC
5
4
TG
1
3
IN (+)
TC75S58AFC
Marking
6
2
VSS
2
VDD
NC
6
5
4
1
2
3
OUT
Monthly Indication
3
IN (-)
1
Vss
IN (+)
2007-10-01
TC75S58AFE/AFC
Absolute Maximum Ratings (Ta = 25°C)
Characteristics
Supply Voltage
Differential Input Voltage
Input Voltage
Symbol
Rating
Unit
VDD, VSS
±3.5 or 7
V
DVIN
±7
V
VIN
VSS~VDD
V
Output Current
IO
±35
mA
Output Voltage
VO
VSS ~ VSS + 7
V
Power Dissipation
PD
Operating Temperature
Topr
−40~85
°C
Storage Temperature
Tstg
−55~125
°C
TC75S58AFE
100
TC75S58AFC
100(Note1)
mW
Note: Due to the CMOS structure, this device may be susceptible to latch-up . To prevent latch-up, please take the
following precautions;
•
Ensure that no I/O pin’s voltage level ever exceeds Vdd or drops below Vss.
power-on timing.
In addition, check the
•
Do not subject the device to excessive noise.
(Note1):FR4 in board implementation
(25.4mm × 25.4mm × 1.6t, Cu Pad: 0.4mm2)
2
2007-10-01
TC75S58AFE/AFC
Electrical Characteristics (VDD = 5 V, VSS = GND, Ta = 25°C)
Symbol
Test
Circuit
Test Condition
Min.
Typ.
Max.
Unit
Input Offset Voltage
VIO
⎯
⎯
⎯
±1
±7
mV
Input Offset Current
IIO
⎯
⎯
⎯
1
⎯
pA
II
⎯
⎯
⎯
1
⎯
pA
Characteristics
Input Bias Current
Common Mode Input Voltage
CMVIN
Supply Current
IDD
(注)
⎯
⎯
0
⎯
4.1
V
⎯
⎯
⎯
11
22
μA
⎯
⎯
94
⎯
dB
Voltage Gain
GV
⎯
Sink Current
Isink
⎯
VOL = 0.5 V
13
25
⎯
mA
Output Leakage Current
ILEAK
⎯
VDD = 5 V , VO = 5 V
⎯
5
⎯
nA
Off-State Leakage Current
IOFF
⎯
VDD = 0 V , VO = 5 V
⎯
5
⎯
nA
Output-Low Voltage
VOL
⎯
Isink = 5.0 mA
⎯
0.1
0.3
V
Operating Supply Voltage Range
VDD
⎯
1.8
⎯
7.0
V
tPLH (1)
⎯
Over Drive = 100 mV
⎯
800
⎯
tPLH (2)
⎯
TTL Step Input
⎯
620
⎯
tPHL (1)
⎯
Over Drive = 100 mV
⎯
230
⎯
tPHL (2)
⎯
TTL Step Input
⎯
350
⎯
tTLH
⎯
Over Drive = 100 mV
⎯
190
⎯
tTHL
⎯
Over Drive = 100 mV
⎯
6
⎯
Propagation Delay
(Turn On)
Propagation Delay
(Turn Off)
Response Time
⎯
ns
ns
ns
Electrical Characteristics (VDD = 3 V, VSS = GND, Ta = 25°C)
Symbol
Test
Circuit
Test Condition
Min.
Typ.
Max.
Unit
Input Offset Voltage
VIO
⎯
⎯
⎯
±1
±7
mV
Input Offset Current
IIO
⎯
⎯
⎯
1
⎯
pA
II
⎯
⎯
⎯
1
⎯
pA
CMVIN
⎯
⎯
0
⎯
2.1
V
⎯
⎯
⎯
10
20
μA
Characteristics
Input Bias Current
Common Mode Input Voltage
Supply Current
IDD (Note)
Isink
⎯
VOL = 0.5 V
6
18
⎯
mA
Output Leakage Current
ILEAK
⎯
VDD = 3 V , VO = 3 V
⎯
5
⎯
nA
Off-State Leakage Current
IOFF
⎯
VDD = 0 V , VO = 3 V
⎯
5
⎯
nA
Output-Low Voltage
VOL
⎯
Isink = 5.0 mA
⎯
0.15
0.35
V
Propagation Delay
(Turn On)
tPLH
⎯
Over Drive = 100 mV
⎯
590
⎯
ns
Propagation Delay
(Turn Off)
tPHL
⎯
Over Drive = 100 mV
⎯
230
⎯
ns
tTLH
⎯
Over Drive = 100 mV
⎯
170
⎯
tTHL
⎯
Over Drive = 100 mV
⎯
5
⎯
Sink Current
Response Time
ns
Note:The current consumption of this device increases as its operating frequency increases. Note that the power
dissipation should not exceed the allowable power.
3
2007-10-01
TC75S58AFE/AFC
IDD – f
1000
VDD = 3 V
Supply Current
IDD
(μA)
VSS = GND
Ta = 25°C
100
10
1
0.001
0.01
0.1
1
Frequency f
10
100
1000
10
100
1000
(kHz)
IDD – f
1000
VDD = 5 V
Supply Current
IDD
(μA)
VSS = GND
Ta = 25°C
100
10
1
0.001
0.01
0.1
1
Frequency f
4
(kHz)
2007-10-01
TC75S58AFE/AFC
VOL – Isink
VOL – Isink
5.0
VOL (V)
VDD = 3 V
2.5
VSS = GND
Ta = 25°C
2.0
Output-Low Voltage
Output-Low Voltage
VOL (V)
3.0
1.5
1.0
0.5
0.0
0
5
10
15
25
20
Sink Current
Isink
30
35
4.5
4.0
(mA)
VSS = GND
Ta = 25°C
3.5
3.0
2.5
2.0
1.5
1.0
0.5
0.0
0
40
VDD = 5 V
5
10
15
Sink Current
20
25
Isink
30
35
40
(mA)
PD – Ta
300
This
(mW)
PD
Power Dissipation
data
was
obtained
unmounted standalone IC.
from
an
If the IC is
mounted on a PCB, its power dissipation
will be greater.
Note that, depending on
the PCB’s thermal characteristics, the
200
curves may differ substantially from those
shown.
100
0
−40
0
40
Ambient Temperature
80
Ta
120
(°C)
5
2007-10-01
TC75S58AFE/AFC
Package Dimension
Weight: 0.003 g (Typ.)
6
2007-10-01
TC75S58AFE/AFC
Package Dimension
CSON6-P-0.45
Weight: 0.002 g (Typ.)
7
2007-10-01
TC75S58AFE/AFC
RESTRICTIONS ON PRODUCT USE
20070701-EN
• The information contained herein is subject to change without notice.
• TOSHIBA is continually working to improve the quality and reliability of its products. Nevertheless, semiconductor
devices in general can malfunction or fail due to their inherent electrical sensitivity and vulnerability to physical
stress. It is the responsibility of the buyer, when utilizing TOSHIBA products, to comply with the standards of
safety in making a safe design for the entire system, and to avoid situations in which a malfunction or failure of
such TOSHIBA products could cause loss of human life, bodily injury or damage to property.
In developing your designs, please ensure that TOSHIBA products are used within specified operating ranges as
set forth in the most recent TOSHIBA products specifications. Also, please keep in mind the precautions and
conditions set forth in the “Handling Guide for Semiconductor Devices,” or “TOSHIBA Semiconductor Reliability
Handbook” etc.
• The TOSHIBA products listed in this document are intended for usage in general electronics applications
(computer, personal equipment, office equipment, measuring equipment, industrial robotics, domestic appliances,
etc.).These TOSHIBA products are neither intended nor warranted for usage in equipment that requires
extraordinarily high quality and/or reliability or a malfunction or failure of which may cause loss of human life or
bodily injury (“Unintended Usage”). Unintended Usage include atomic energy control instruments, airplane or
spaceship instruments, transportation instruments, traffic signal instruments, combustion control instruments,
medical instruments, all types of safety devices, etc.. Unintended Usage of TOSHIBA products listed in his
document shall be made at the customer’s own risk.
• The products described in this document shall not be used or embedded to any downstream products of which
manufacture, use and/or sale are prohibited under any applicable laws and regulations.
• Please contact your sales representative for product-by-product details in this document regarding RoHS
compatibility. Please use these products in this document in compliance with all applicable laws and regulations
that regulate the inclusion or use of controlled substances. Toshiba assumes no liability for damage or losses
occurring as a result of noncompliance with applicable laws and regulations.
8
2007-10-01