Surface Mount Bridge Rectifier MB2M --- MB10M FEATURES • Plastic package has Underwriters Laboratory Flammability Classification 94V-0 • Glass passivated chip junctions • High surge overload rating: 35A peak C0.5 .193(4.9) .177(4.5) • Saves space on printed circuit boards ~ ~ + - • Recommended for non-automotive applications Mechanical Data .165(4.2) .146(3.7) .106(2.7) .090(2.3) .217(5.5) .177(4.5) .051(1.3) .035(0.9) .031(0.8) .019(0.5) .014(.35) .006(.15) .031(0.8) • Case: Molded plastic body over passivated junctions .019(0.5) .106(2.7) .090(2.3) • Terminals: Plated leads solderable per MIL-STD-750,Method 2026 a .m Maximum Ratings and Electrical Characteristics Parameter Maximum RMS voltage Maximum DC blocking voltage MB2M MB4M MB6M MB8M MB10M Units VRRM 200 400 600 800 1000 Volts VRMS 140 280 420 560 700 Volts VDC 200 400 600 800 1000 Volts IF(AV) on aluminum substrate IFSM Rating for fusing (t < 8.3ms) I2t Maximum instantaneous forward voltage drop per leg at 0.4A AT = 25oC rated DC blocking voltage per leg AT = 125oC Typical thermal resistance per leg Typical junction capacitance per leg (3) Operating junction and storage temperature range MAKO Semiconductor Co., Limited 0.5 (1) 0.8 (2) Amp 35.0 Amps hk superimposed on rated load (JEDEC Method) Maximum DC reverse current at unless otherwise noted) Symbols on glass-epoxy P.C.B. Peak forward surge current 8.3 ms single half sine-wave . Dimensions in inches and (millimeters) i. em Maximum average forward output rectified current (see Fig.1) (Ta=25 s ko Maximum repetitive peak reverse voltage . MBM w ww • Mounting Position: Any .256(6.5) .217(5.5) .106(2.7) 090(2 3) 5.0 A2sec VF 1.0 Volt IR 5.0 uA 100 RθJA 85 (1) RθJA 70 (2) RθJL 20 (1) CJ 13 pF T J ,TSTG -55 to +150 oC 4008-378-873 oC/W www.makosemi.hk Page:P2-P1 Surface Mount Bridge Rectifier MB2M --- MB10M CHARACTERISTIC CURVES hk i. em s ko a .m w ww MAKO Semiconductor Co., Limited 4008-378-873 www.makosemi.hk Page:P2-P2