DC/DC Converters CTDD3220DF-D1.5K-3MW Series 4:1 Wide Input Isolated & Regulated 3W Output, Dual Output Not shown at actual size. ctparts.com SPECIFICATIONS Vin Nom. (VDC) Input Range (VDC) Vin Max.* (VDC) Vout (VDC) CTDD3220DF-2405-D1.5K-3MW CTDD3220DF-2412-D1.5K-3MW CTDD3220DF-2415-D1.5K-3MW 24 24 24 9-36 9-36 9-36 40 40 40 ±5 ±12 ±15 CTDD3220DF-4805-D1.5K-3MW CTDD3220DF-4812-D1.5K-3MW CTDD3220DF-4815-D1.5K-3MW 48 48 48 18-72 18-72 18-72 80 80 80 ±5 ±12 ±15 Part Number Iout Max. (mA) Iout Min. (mA) Effi. Typ. (%) ±300 ±125 ±100 ±30 ±12 ±10 74 81 81 ±300 ±125 ±100 ±30 ±12 ±10 77 84 82 *If Input voltage above specified may cause permanent damage to the device ISOLATION SPECIFICATIONS RoHS Compliant Item Test Condition MIN Isolation Voltage Flash tested for 1 minute 1500 VDC Test at 500VDC 1000 MΩ Isolation Resistance TYP MAX Units OUTPUT SPECIFICATIONS Item Test Condition 3W Output Power FEATURES Efficiency: To 82% Temperature Range: -40°C to +85°C Isolation: 1.5KVDC Package: Metal SUS Miscellaneous: Wide (4:1) Input Range. Dual Output. No heat sink required. Continuous Short Circuit Protection. Samples available. Units 3 W ±3 % Load regulation From 10% to 100% load ±2 % Line regulation Input Voltage from low to high ±1 % Temperature drift (Vout) Refer to Temp. Derating Graph 0.03 %/°C Ripple 20Hz to 300KHz Bandwidth 40 mVp-p Noise DC-20MHz Bandwidth Switching frequency ±1 MAX Refer to Recommended Circuit 100 mVp-p 100-650(PFM) KHz Isolation Capacitance 150 PF Note: 1. All specifications measured at TA=25°C, humidity<75%, nominal input voltage and rated output unless otherwise specified. TYPICAL CHARACTERISTICS Temperature Derating Graph 120 Output Power (%) Output Short Circuit Protection: Continuous Temperature Rise at Full Load: 30°C (Typ.) Cooling: Free air convection Operating Temperature Range: -40°C to +85°C Storage Temperature Range: -55°C to +125°C Lead Temperature: 300°C (1.5mm from case for 10 seconds) Storage Humidity Range: < 95% Case Material: Metal SUS MTBF: >1,000,000 hours Miscellaneous: RoHS Compliant. 100 80 60 Safe Operating Area 40 20 0 -40 0 120 40 71 85 (°C) Operating Temperature 01.31.07 Technologies TYP 0.3 Voltage accuracy CHARACTERISTICS CENTRAL MIN Manufacturer of Passive and Discrete Semiconductor Components 800-684-5322 Inside US 949-453-1811 Outside US Copyright © 2006 by CT Magnetics, DBA Central Technologies. All rights reserved. CT Magnetics reserves the right to make improvements or change specifications without notice DC/DC Converters ctparts.com CTDD3220DF-D1.5K-3MW Series Wide Input Isolated & Regulated 3W Output, Dual Output OUTLINE DIMENSIONS & RECOMMENDED FOOTPRINT DETAILS CTDD3220DF-D1.5K-3MW Package 1 Bottom View Side View 31.80 10.0 2 0.50 10 11 12 15.24 20.30 24 23 15 13 2.00 5.08 4.00 27.94 Note: All pins on a 2.54mm pitch; all pin diameters are 0.50mm; all dimensions in mm. (Tolerance:±0.10) PIN CONNECTIONS Bottom View 1 2 10 11 12 24 23 15 13 Pin Function 1, 2 10, 11 12 13 15 23, 24 VIN 0V NC -Vo +Vo GND RECOMMENDED CIRCUIT All the CTDD3220DF-D1.5K-3MW Series have been tested according to the following recommended testing circuit before leaving factory. This series should be tested under load. Never be tested under no load (See figure 1 & 2). If you want to further decrease the input/output ripple, you can increase capacitance properly or choose capacitors with low ESR. However, the capacitance should not be too high. (See table 1) External Capacitor Table (table 1) Figure 2 5V & 12V 24V & 48V C in C out (-40+85°C) lp Figure 1 100µF 100µF (electrolytic capacitor) 47µF (tantalum capacitor) Vin +Cin 10µF DC DC Cout + Cout + Vo+ 0V Input Current (A) Vin C out (0+70°C) Vo- GND Input Voltage (V) Technologies 01.31.07 CENTRAL Input Voltage Range Manufacturer of Passive and Discrete Semiconductor Components 800-684-5322 Inside US 949-453-1811 Outside US Copyright © 2006 by CT Magnetics, DBA Central Technologies. All rights reserved. CT Magnetics reserves the right to make improvements or change specifications without notice