PAIRUI BBQ48-33V45 Dc-dc converter Datasheet

DC-DC Converter
Bricks, Open/Enclosed
BBQ SERIES, 1/4 BRICK, UP TO 250W
FEATURES:
5 years warranty
Output current up to 50A
1500Vdc isolation voltage
Efficiency up to 93%
Operating temperature range -40°C to +85°C
Under voltage, over current, short circuit,
over voltage protection
Remote on/off
Adjustable output voltage
Model
BBQ48-33V40
BBQ48-33V45
BBQ48-33V50
BBQ48-50V40
Input voltage
(Vdc)
Output voltage
(Vdc)
Output current
(A)
Efficiency
Typ.
3.3
40.0
90%
3.3
45.0
93%
3.3
50.0
93%
5.0
40.0
91%
48(36~72)
Notes:
1. Other input and output models may available on request;
2. You may request for the models with heatsink, plus “R” in the suffix, e.g. BBQ48-33V40R.
ELECTRICAL
Input voltage range
48Vdc
Remote control
Negative logic
Output power
Input voltage range
Output voltage
Single output
Output voltage accuracy
Input voltage range
Output voltage adjustable
Positive logic
±10%
Line regulation
Full load
±0.2%
Load regulation
10%-100% full load
±0.5%
Dynamic response
(transient/recovery time)
36-72Vdc
OFF: High level or left close
ON: Low level or grounded
130-200W
3.3/5Vdc
±1%
25%-50%-75% load capability
Ripple and noise
Parallel test, 20MHz wide range
Operating frequency
Typical value
Isolation voltage
70mVp-p max.
300KHz typ.
Input to output
1500Vdc
Input to case
1050Vdc
Output to case
www.pairuigroup.com
∆Vo/∆t: ±4.0%/500μs
Page:
500Vdc
1/4
Date: 01/23/2014
DC-DC Converter
Bricks, Open/Enclosed
BBQ SERIES, 1/4 BRICK, UP TO 250W
ELECTRICAL
Isolation resistance
---
10MΩ
Safety
---
Temperature coefficient
---
Operating temperature range
Auxiliary heat sink
Storage temperature range
---
Over temperature protection
Typical
Under voltage protection
---
Yes
Over current protection
---
Yes
Short circuit protection
---
Yes
Over voltage protection
---
Yes
Relative humidity
---
95% max.
Packing
---
Hole package
MTBF
Bellcore TR-332, 25°C
IEC-60950-1, UL-60950-1
EN-60950-1, GB4943
200ppm
-40°C to +85°C
-40°C to +125°C
110°C typ.
2x106Hrs
Notes: Unless otherwise specified, all the parameters of the test conditions are as follows: ambient temperature
25 , the nominal input voltage, pure resistive nominal load.
℃
MECHANICAL
WITHOUT HEATSINK
www.pairuigroup.com
WITH HEATSINK
Page:
2/4
Date: 01/23/2014
DC-DC Converter
Bricks, Open/Enclosed
BBQ SERIES, 1/4 BRICK, UP TO 250W
MECHANICAL
PCB LAYOUT
CONNECTION
PIN #
SINGLE
1
-Vin
2
REM
3
+Vin
4
GND
5
-S
6
TRIM
7
+S
8
+Vo1
9
+Vo1
10
GND
Note:
* Unit is mm(inch).
DERATING CURVE
www.pairuigroup.com
EFFICIENCY CURVE
Page:
3/4
Date: 01/23/2014
DC-DC Converter
Bricks, Open/Enclosed
BBQ SERIES, 1/4 BRICK, UP TO 250W
NOTES
RECOMMENDED TEST AND APPLICATION CIRCUIT
1. TVS&FUSE be helpful with over voltage protection and inrush limiting. Recommended FUSE better be 1.5~2times of
the rated current .
2. The input filter capacitor C6 could select the aluminum electrolytic capacitors or tantalum capacitors, and the
withstand voltage should be greater than the highest input voltage. Recommended capacitor should be between
22μF~100μF.
3. C1,C2 for the input filter capacitor,0.1~1μF high-frequency ceramics capacitor or chip capacitor are recommended.
The withstand voltage of output filter C5, C7 should be greater than the highest output voltage. Recommended
capacitor of C7 better within 100μF and C5 connected with the chip to reduce the input voltage peak, recommended
0.1~1μF high-frequency ceramics capacitor or chip capacitor.
www.pairuigroup.com
Page:
4/4
Date: 01/23/2014
Similar pages