EC Diagonal Compact Modules Series K3G200-AD Ø 200 mm Bearing Ingress protection rating UL Chart 506 Mass M3G055-BI Temperature range (1) K3G200-AD11-02 Max back pressure 547 Current draw (1) M3G055-BI Speed (1) K3G200-AD21-01 Power input (1) cfm Frequency Motor Voltage range Type Voltage Nominal Data VAC VAC Hz W rpm A in. H20 °C lbs 230V 200...240 50/60 80 3100 0.7 0.884 -25...60 4.41 Ball IP54 Yes A 115V 100...130 50/60 65 2850 1.0 0.723 -25...60 4.41 Ball IP54 Yes B Phase Air flow Highlights: – Control Input: 0-10 VDC/PWM – Output: 10 VDC, max 1.1 mA – Tach Output – Over-temperature protected electronics/motor – Soft start, motor current limit – Locked rotor protection Material: Impeller: PA composite Housing: PP composite Mounting position: Any Condensate discharge holes: None, open rotor Direction of rotation: Clockwise, seen on rotor 1~ 1~ (1) Nominal data at maximum load. Curves in. wg Air performance measured as per: ISO 5801, Installation category A, without protection against accidental contact. 1.60 1.40 1.20 Suction-side noise levels: LWA as per ISO 13347, LPA measured at 1m distance to fan axis. A 1.00 The values given are valid under the measuring conditions mentioned and may vary accoring to the actual installation situation. 4 B 0.80 8 With any deviation to the standard set-up, the specific values have to be checked and reviewed once installed or fitted. 3 0.60 7 0.40 6 pfs 0.20 0.00 0 q 100 200 300 400 2 For detailed information on the measuring set-up, please contact ebm-papst. 5 500 1 cfm 600 n Pe I LpAin LwAin rpm W A dB(A) dB(A) A 1 3160 69 0.63 64 72 A 2 3120 75 0.68 62 70 A 3 3100 80 0.70 61 69 A 4 3100 76 0.69 61 69 A 5 2945 59 0.96 62 70 A 6 2885 62 1.00 61 69 A 7 2850 65 1.00 59 68 A 8 2845 64 1.00 59 68 A 9 A 10 A 11 A 12 A 13 A 14 A 15 A 16 K3G200-ADXX-XX Dimensions shown in millimeters Connection screen Conn. Designation Color Function / assignment CON10 L black Power supply for voltage range refer to rating plate CON11 N blue Neutral conductor CON12 PE green/yellow Protective earth 1 GND blue GND - Connection for control interface 2 0- 10V PWM yellow Control input 0 - 10 V or PWM, electrically isolated 3 10V/ max 1.1mA red Voltage output 10 V / 1.1 mA, electrically isolated 4 Tach white Tach output: open collector, 1 pulse per revolution, electrically isolated, Isink max = 10 mA