CP300 THRU CP3010 SINGLE-PHASE SILICON BRIDGE-P.C. MTG 2A, HEAT-SINK MTG 3A VOLTAGE - 50 to 1000 Volts CURRENT - 3.0 Amperes CP-3 FEATURES l Surge overload rating—50 Amperes peak l Low forward voltage drop and reverse leakage l Small size, simple installation l Plastic package has Underwriter Laboratory Flammability Classification 94V-O l Reliable low cost construction utilizing molded plastic technique MECHANICAL DATA Terminals: Leads solderable per MIL-STD-202, Method 208 Weight: 0.08 ounce, 2.5 grams MAXIMUM RATINGS AND ELECTRICAL CHARACTERISTICS At 25 ambient temperature unless otherwise noted; resistive or inductive load at 60Hz. Max Recurrent Peak Rev Voltage Max Bridge Input Voltage RMS Max Average Rectified Output at TC=50 * See Fig.2 at TA=25 ** Peak One Cycle Surge Overload Current Max Forward Voltage Drop per element at 1.5A DC & 25 . See Fig.3 Max Rev Leakage at Rated DC Blocking Voltage per element at 25 See Fig.4 at 100 I2t Rating for fusing ( t<8.3ms) CP300 CP301 CP302 CP304 CP306 50 35 100 70 200 140 400 280 3.0 2.0 50 1.0 600 420 Typical Junction capacitance per leg(Note 4)CJ Typical Thermal Resistance per leg(Note 2) R JA (Note 3) R JL Operating Temperature Range Storage Temperature Range CP308 CP3010 UNITS 800 560 10.0 1.0 15.0 21.0 12.0 8.0 -55 TO +125 -55 TO +150 NOTES: 1. Bolt down on heat-sink with silicon thermal compound between bridge and mounting surface for maximum heat transfer with #6 screw. 2. Unit mounted on 4.0×4.0×0.11” thick (10.5×10.5×0.3cm) AL. Plate. 3. Unit mounted on P.C.B at 0.375”(9.5mm) lead length with 0.5×0.5” (12×12mm) copper pads. 4. Measured at 1 MHz and applied reverse voltage of 4.0 Volts. 1000 700 V V A A V A mA A2Sec PF /W RATING AND CHARACTERISTIC CURVES CP300 THRU CP3010 Fig. 1-NON-RECURRENT SURGE RATING Fig. 2-DERATING CURVE FOR OUTPUT RECTIFIED CURRENT Fig. 3-TYPICAL FORWARD CHARACTERISTICS Fig. 4- TYPICAL FORWARD CHARACTERISTICS