MINT1022 22 Watt Single Output Series Medical - Universal Input Power Supply • 90-264 VAC Input • Overvoltage and Short Circuit Protection • Compact Size, Low Profile 2.0” x 3.5” x 0.67” • Approved to UL, CSA and EN Standards • CE Compliant (LVD, EMC, RoHS) • Low Standby Power Loss (<0.5 W) International Safety Standard Approvals Specifications All specifications are typical at nominal input, full load at 25°C unless otherwise stated Output Specifications Output Power Environmental Specifications Natural Convection Minimum Load 2 Watts continuous, 2 24 W peak for 60 seconds, 10% duty cycle Not required Total Regulation (Line and Load) 1.5%, see table Rise Time At turn-on 100 ms max. Transient Response 50% step load, 0.2A/μs % max. dev., 1.5 msec 4 max. recovery to 0.5% Temperature Coefficient +/-0.03%/° C typical Overvoltage Protection Standard - See chart Voltage Adjustability actory set with fixed F resistors to maximize reliability Input Specifications Voltage Thermal Performance Universal Input Frequency Operating ambient (see ratings chart) Non-operating 0-50° C 50-70° C ambient 0-70° C -40 to +85° C Full load. See table. derate to 50% Relative Humidity Non-condensing 0-95% RH Maximum Altitude Operating /non-operating 10,000 ft./40,000 ft. max. Vibration 5Hz-500Hz 2.5 g rms Shock Per MIL-STD-810E 516.4 part IV General Specifications Hold-up Time 120VAC, 60Hz 15ms min. at 22W output Efficiency 120VAC, 22W output 70-80% typical depending on output voltage 0-240VAC (Nominal 9 100-240VAC) Switching Frequency Fixed 5 to 100kHz, varies with line 1 and load 47-63Hz Safety Approvals UL/EN/IEC 60601-1 CSA22.2 No.601 Input Surge Current Thermistor limited 32A max. Earth leakage current 264V, 60Hz 25 μA max. (200 μA 1 single fault) Input Current 120VAC 230VAC 0.45A 0.25A Input Fuse F1 2.0 A Medical Maximum Weight 100 Grams (0.20 lbs) MTBF 25° C, ground benign, Telcordia 300,000 hours Overload and short circuit protection Fully protected Cycling type power limit SL Power Electronics Corp. • 6050 King Drive • Ventura, CA 93003 • Phone:805.486.4565 • Fax:858.712.2040 • Email:[email protected] • www.slpower.com MINT1022 22 Watt Single Output Series Medical - Universal Input Power Supply Medical Model Voltage Output Output Current Total Regulation Initial Setpoint Tolerance Ripple/ Noise OVP Setpoint MINT1022A0505I01 5V 4.40A +/-1.5% +/-2.5% 100mV 6.2+/-0.6V MINT1022A1205I01 12V 1.83A +/-1.5% +/-2.5% 120mV 14.1+/-1.1V MINT1022A2405I01 24V 0.92A +/-1.5% +/-2.5% 240mV 28+/-2.5V Notes 1. Other output voltages available by special order 2. Regulation from initial setpoint for 50% load change from 50% to 0% or 100% 3. Peak output rating is 24 Watts for 1 minute 4. 20MHz Bandwidth scope, differential mode. Measured with scope probe directly across output terminals of the power supply with load terminated with 0.1 μF 5. Heatsink temperatures should not be allowed to exceed 90° C 6. Installation data is online at www.slpower.com Condor Part Number Key M I N T 1 022 A 05 05 I 01 Medical Internal Standard Product Factory Designation No. of Outputs Output Wattage Initial Design of the Product Output Voltage Output Connector Input Connector Standard Configuration General Specifications (continued from p. 1) MC Information E Conducted emissions Radiated emissions Line freq. harmonics Voltage fluctuations ESD Contact ESD Air Radiated immunity Fast Transients (EFT) Line surge immunity EN55011 EN55011 EN61000-3-2 EN61000-3-3 EN61000-4-2 EN61000-4-2 EN61000-4-3 EN61000-4-4 EN61000-4-5 Conducted immunity Power freq. mag. field Voltage dip immunity EN61000-4-6 EN61000-4-8 EN61000-4-11 Mechanical Notes INPUT J1 MOLEX 22-43-8040 Level B Level B Complies Complies 6 kV contact 8 kV air 3 V/m 2 kV/5 kHz 1 kV diff /2 kV common mode 3 Vrms 3 A/m Consult Factory INPUT GROUND OUTPUT J1 MOLEX 22-43-8040 PIN 1 AC LINE PIN 4 AC NEUTRAL SOLDER HOLE ON BOARD J2 MOLEX 22-43-8040 PIN 1 OUTPUT 1 PIN 2 OUTPUT 1 PIN 3 COMMON PIN 4 COMMON MATING CONNECTOR (MOLEX) INPUT HOUSING 50-37-5043 OUTPUT HOUSING 50-37-5043 CONTACTS 08-70-1040 CONTACTS 08-70-1040 SL Power Electronics Corp • 6050 King Drive • Ventura, CA 93003 • Phone:805.486.4565 • Fax:805.487.8911 • Email:[email protected] • www.slpower.com Data Sheet © 2008 SL Power Electronics Corp. The information and specifications contained in this data sheet are believed to be correct at time of publication. However, SL Power accepts no responsibility for consequences arising from reproduction errors or inaccuracies. Specifications are subject to change without notice. Rev.9/08/08