SINGLE PHASE GLASS PASSIVATED BRIDGE RECTIFIER CURRENT Plastic package has UL Flammability Glassification 94V-0 Glass passivated chip junctions High case dielectric strength of 1500 VRMS High surge current capability High temperature soldering guaranteed 260℃/10 seconds, 0.375”(9.5mm) lead length 29.7-30.3 4.4-4.8 O 3.4-3.8 - 3 .4 O MECHANICAL DATA • • • 2.5±0.2 2.0-2.4 Case: molded plastic body Terminal: Plated leads solderable per MIL-STD-750 Method 2026 Mounting position: Any (Note 3) Mounting Torque: 6 in – 1bs max. Weight: 0.26 ounce, 7.4 gram 2.7-3.1 3.8-4.2 17.0-18.0 • • 10.8-11.2 .1 φ3 19.7-20.3 3.0×45 5.0 • • • • 20.0 Amperes GBJ FEATURES • 50 to 1000 Volts VOLTAGE RANGE GBJ20005 THRU GBJ2010 0.6-0.8 0.9-1.1 9.8-10.2 7.3-7.7 7.3-7.7 MAXIMUM RATINGS AND ELECTRICAL CHARACTERISTICS • • • Ratings at 25℃ ambient temperature unless otherwise specified Single Phase, half wave, 60Hz, resistive or inductive load For capacitive load derate current by 20% GBJ SYMBOLS GBJ Maximum Reverse Peak Repetitive Voltage Maximum RMS Voltage Maximum DC Blocking Voltage Maximum Average Forward Rectified Current, At TC=100℃ (Note 1) Peak Forward Surge Current 8.3ms single half sine wave superimposed on rated load (JEDEC Method) Rating for Fusing (t<8.3ms) Maximum Instantaneous Forward Voltage drop Per bridge element 10.0A Maximum DC Reverse Current at rated DC blocking voltage per element Typical Thermal Resistance (Note 2) Operating Junction Temperature Range Storage Temperature Range TA=25℃ TA=125℃ VRRM VRMS VDC GBJ GBJ GBJ GBJ GBJ 20005 2001 2002 2004 2006 2008 2010 50 35 50 100 70 100 200 140 200 400 280 400 20 3.5 600 420 600 800 560 800 1000 700 100 I(AV) UNIT Volts Volts Volts Amps IFSM 240 Amps I2 t 239 A2s VF 1.0 Volts 10 500 22 (-55 to +150) (-55 to +150) IR RJA TJ TSTG Notes: 1. Unit case mounted on 300mm×300mm×1.6mm A1. Plate heatdink 2. Unit mounted on P.B.C. without heatsink 3. Recommended mounting position is to bolt down on heatsink with silicone thermal compound for maximum heat Transfer with #6 screws E-mail: [email protected] Web Site: www.cnmic.com μA ℃/W ℃ ℃ SINGLE PHASE GLASS PASSIVATED BRIDGE RECTIFIER 50 to 1000Volts VOLTAGE RANGE GBJ20005 THRU GBJ2010 CURRENT 20.0 Amperes RATINGS AND CHARACTERISTIC CURVES GB20005 THRU GBJ2010 FIG. 1- DERATING CURVE OUTPUT RECTIFIED CURRENT FIG. 2- MAXIMUM NON-REPETITIVE PEAK FORWARD SURGE CURRENT PER LEG 400 Heat-Sink Mounting. Tc PEAK FORWARD SURGE, CURRENT,(A) AVERAGE FORWARD OUTPUT CURRENT (A) 20 15 10 P.C.B. Mounting 5 350 300 200 150 100 50 1.0 Cycle 0 0 25 50 75 100 125 0 150 1 10 FIG. 3- TYPICAL FORWORD CHARACTERISTICS PER LGE FIG. 4- TYPICAL REVERSE CHARACTERISTICS PER LEG 1000 T A=125℃ INSTANTANEOUS REVERSE CURRENT, (A) INSTANTANEOUS FORWARD CURRENT, (A) 100 10 1 0.1 0.01 0.6 0.8 1.0 1.2 100 10 1 T A=25℃ 0.1 0 1.4 20 40 60 80 100 INSTANTANEOUS FORWARD VOLTAGE,(V) PERCENT OF RATED PEAK REVERSE VOLTAGE,(V) FIG. 5- TYPICAL JUNCTION CAPACITANCE PER LEG FIG. 6- TYPICAL TRANSIENT THERMAL IMPEDANCE 10 TRANSIENT THERMAL IMPEDANCE (℃ /W) 1000 JUNCTION CAPACITANCE, (pF) 100 NUMBER OF CYCLES AT 60 Hz TEMPERATURE, ℃ 100 10 1 1 10 100 1 0.1 0.01 REVRESE VOLTAGE,(V) E-mail: [email protected] 0.1 1 T, HEATING TIME (SEC.) Web Site: www.cnmic.com 10