CYStech Electronics Corp. Spec. No. : C564QD Issued Date : 2012.12.11 Revised Date : Page No. : 1/10 Quadruple Operational Comparator LM324QD Description The LM324QD consists of four independent high gain, internally frequency compensated operational amplifiers which are designed specifically to operate from a single power supply over a wide range of voltages. Operation from split power supplies is also possible and the low power supply current drain is independent of the magnitude of the power supply voltage. Features • Wide range of supply voltages •Low supply current drain independent of supply voltage • Low input biasing current •Low input offset voltage and offset current • Differential input voltage range equal to the power supply voltage • Input common-mode voltage range includes ground • DC voltage gain 100V/mV typ •Internally frequency compensation Applications • General purpose amplifier • Transducer amplifier • DC gain block LM324QD CYStek Product Specification Spec. No. : C564QD Issued Date : 2012.12.11 Revised Date : Page No. : 2/10 CYStech Electronics Corp. Pin Configurations Absolute Maximum Rating(Ta=25℃) Parameter Power Supply Voltages Single Supply Split Supplies Symbol Value Unit VCC VCC, VEE 32 ±16 V Input Differential Voltage Range VIDR ±32 V Input Common Mode Voltage Range VICR -0.3 ~ +32 Operating Temperature Topr 0 ~ +70 V ℃ Storage Temperature Tstg -65 ~ +150 ℃ Electrical Characteristics (VCC=5V,Ta=25°C, VEE=GND, unless otherwise specified.) Parameter Input Offset Voltage Test Condition Symbol Min. 25°C VCC=5 to 30V VIC=VICR min, VO=1.4V 0~70°C VIO - 3 - 7 9 mV 0~70°C αVIO - 7 - μV/°C 25°C 0~70°C IIO - 2 - 50 150 nA 0~70°C αIIO - 10 - pA/°C -250 -500 nA Average temperature coefficient of input offset voltage Input Offset Current VO=1.4V Average temperature coefficient of input offset current Input Bias Current VO=1.4V Input Common-Mode Voltage VCC=5V to 30V LM324QD 25°C 0~70°C 25°C 0~70°C IIB VICR Typ. Max. Unit -20 0 to VCC-1.5 0 to VCC-2 - V CYStek Product Specification Spec. No. : C564QD Issued Date : 2012.12.11 Revised Date : Page No. : 3/10 CYStech Electronics Corp. Power Supply Current (four amplifiers) Large Signal Differential Voltage Amplification High Level Output Voltage Low Level Output Voltage Common Mode Rejection Ratio Power Supply Rejection Ratio Channel Crosstalk Attenuation Short Circuit Output Current Output Current 0~70°C RO=2.5V, no load VCC=30V, VO=0.5VCC, no load VCC=15V, VO(p)=1V to 11V, RL≥2kΩ 25°C 0~70°C RL=2kΩ 25°C VCC=30V, RL=2kΩ 0~70°C VCC=30V, RL=10kΩ 0~70°C RL=10kΩ VCC=5V to 30V VIC=VICR min VCC=5V to 30V 0~70°C f=1kHz to 20kHz VCC at 5V, GND at -5V, VO=0V VCC=15V, VID=1V, VO=0V - 1.5 2.4 mA - 1.1 3 mA 25 15 100 - - V/mV VCC-1.5 - - 26 - - 27 28 - VOL - 5 20 mV 25°C CMRR 65 80 - dB 25°C PSRR 65 100 - dB 25°C CS - 120 - dB 25°C ISC - ±40 ±60 mA -20 -10 10 5 -30 20 - - 12 30 - 0~70°C VCC=15V, VID=-1V, VO=15V 25°C 0~70°C 25°C 0~70°C VID=-1V, VO=0.2V 25°C ICC AVD VOH IO V mA mA μA Ordering Information Device Package Shipping LM324QD-0-T3-G SOP-14 (Pb-free lead plating and halogen-free package) 2500 pcs/ Tape & Reel LM324QD CYStek Product Specification CYStech Electronics Corp. Spec. No. : C564QD Issued Date : 2012.12.11 Revised Date : Page No. : 4/10 Block Diagram, each channel LM324QD CYStek Product Specification CYStech Electronics Corp. Spec. No. : C564QD Issued Date : 2012.12.11 Revised Date : Page No. : 5/10 Characteristic Curves, each channel LM324QD CYStek Product Specification CYStech Electronics Corp. Spec. No. : C564QD Issued Date : 2012.12.11 Revised Date : Page No. : 6/10 Characteristic Curves, each channel(Cont.) LM324QD CYStek Product Specification CYStech Electronics Corp. Spec. No. : C564QD Issued Date : 2012.12.11 Revised Date : Page No. : 7/10 Reel Dimension Carrier Tape Dimension LM324QD CYStek Product Specification CYStech Electronics Corp. Spec. No. : C564QD Issued Date : 2012.12.11 Revised Date : Page No. : 8/10 Recommended wave soldering condition Product Pb-free devices Peak Temperature 260 +0/-5 °C Soldering Time 5 +1/-1 seconds Recommended temperature profile for IR reflow Profile feature Average ramp-up rate (Tsmax to Tp) Preheat −Temperature Min(TS min) −Temperature Max(TS max) −Time(ts min to ts max) Time maintained above: −Temperature (TL) − Time (tL) Peak Temperature(TP) Time within 5°C of actual peak temperature(tp) Ramp down rate Time 25 °C to peak temperature Sn-Pb eutectic Assembly Pb-free Assembly 3°C/second max. 3°C/second max. 100°C 150°C 60-120 seconds 150°C 200°C 60-180 seconds 183°C 60-150 seconds 240 +0/-5 °C 217°C 60-150 seconds 260 +0/-5 °C 10-30 seconds 20-40 seconds 6°C/second max. 6 minutes max. 6°C/second max. 8 minutes max. Note : All temperatures refer to topside of the package, measured on the package body surface. LM324QD CYStek Product Specification CYStech Electronics Corp. Spec. No. : C564QD Issued Date : 2012.12.11 Revised Date : Page No. : 9/10 SOP-14 Dimension LM324QD CYStek Product Specification CYStech Electronics Corp. Spec. No. : C564QD Issued Date : 2012.12.11 Revised Date : Page No. : 10/10 Notes: 1.Controlling dimension: millimeters. 2.Maximum lead thickness includes lead finish thickness, and minimum lead thickness is the minimum thickness of base material. 3.If there is any question with packing specification or packing method, please contact your local CYStek sales office. Material: • Lead: Pure tin plated. • Mold Compound: Epoxy resin family, flammability solid burning class: UL94V-0. Marking Date Code 14-Lead SOP-14 Plastic Package CYStek Package Code: QD Important Notice: • All rights are reserved. Reproduction in whole or in part is prohibited without the prior written approval of CYStek. • CYStek reserves the right to make changes to its products without notice. • CYStek semiconductor products are not warranted to be suitable for use in Life-Support Applications, or systems. • CYStek assumes no liability for any consequence of customer product design, infringement of patents, or application assistance. LM324QD CYStek Product Specification