IPC PSU FSP220-20FGBBD DESCRIPTION FSP220-20FGBBD is an industrial level of switching power supply. The power supply comes to offer the total power capacity up to 220 Watts, and uses unique active PFC (Power Factor C orrection) circuit design with its high-load electrical components, makes it to be perfectly used in an industrial environment. In addition, with its full range of input and output electrical features, the power supply is ideally the best choice for PoE Switch, PoE NVR, communication or any other networking applications to use. The product also complies with the latest safety and EMC standards, which is perfectly to meet various regulations worldwide. SAFETY STANDARD APPAOVAL APPLICATION For PoE Switch, PoE NVR and networking system. OUTPUT SPECIFICATION Hold up Time: FEATURES 80 Plus Bronze Low Ripple & Noise Output over voltage protection Short circuit protection on all outputs Resettable power shut down INTERNAL 4 cm fan 100% burn-in under high ambient temperature(50℃) Vacuum-impregnated transformer MTBF:100K hours at 25℃ 100% Hi-pot tested Line input fuse protection Output Rise Time: Ripple & Noise: Short Circuit Protection: ENVIRONMENTAL SPECIFICATION TEMP.Range: W ATTAGE Wattage: 220W MTBF: DIMENSION Dimension: 150mm(L) x 81.5mm(W) x 40.5mm(H) PRODUCT HIGHLIGHT Efficiency Level: 115V/60Hz 20mSec. Minimum@100% Load, 230V/50Hz 20mSec. Minimum,@100% Load 115V-rms/230V-rms +12V: 20ms Maximum 115V-rms/230V-rms +53V: 20ms Maximum 12V1:140mV p-p 53V:400mV p-p load < 0.05 Ohm Storage Temperature: 20°C to + 80℃ The power supply have a minimum predicted MTBF(MIL-HDBK-217) of 100,000 hours of continuous operation at 25℃, maximum-output load, and nominal AC inout voltage. 80 Plus Bronze INPUT SPECIFICATION Input Range: Input Frequency: Input Current: 90-264 Vac 47-63 Hz 115V@ 5.5 Amps-rms maximum 230V@ 3.2 Amps-rms maximum GENERAL SPECIFICATION Effciency: Voltage Regulation: 90% 115VAC +12V: ±5% *Output Voltage and C urrent Rating Ripple-Noise(R-P) mV Regulation Load % Output Max.(A) Output Min.(A) +12V1 140mV ±5% 6A 0A +53V 400mV ±5% 2.8A 0A NOTES Total output for this subject power supply is 220 watts. Ripple and noise measurements shall be made under all specified load conditions through a single pole low pass filter with 20MHz cutoff frequency. Outputs shall bypassed at the connector with a 0.1uF ceramic disk capacitor and a 10uF electrolytic capacitor to simulate system loading. This content is subject to change, please refer to specification for m ore detail. FSP reserve the right to change the content without prior notice