MB3505 THRU MB3510 SINGLE-PHASE GLASS PASSIVATED SILICON BRIDGE RECTIFIER VOLTAGE RANGE 50 to 1000 Volts CURRENT 35 Amperes d e u n i nt FEATURES * * * * Superior thermal desing 400 amperes surge rating 1/4" universal faston terminal Hole thru for #8 screw o c is D MECHANICAL DATA * Epoxy : Device has UL flammability classification 94V-0 * UL listed the recongnized component director, file #94233 MB-35 DISCONTINUED- "This series is replaced by the MP35 series that meets to the same fit and function parameters. The MP35 series is preferred for PCB assembly.＂ MAXIMUM RATINGS AND ELECTRICAL CHARACTERISTICS Ratings at 25 o C ambient temperature unless otherwise specified. Single phase, half wave, 60 Hz, resistive or inductive load. MB-35W For capacitive load, derate current by 20%. MAXIMUM RATINGS (@ TA=25 OC unless otherwise noted) RATINGS MB352 MB354 MB356 Maximum Recurrent Peak Reverse Voltage SYMBOL VRRM 50 100 200 400 600 800 1000 Volts Maximum RMS Voltage VRMS 35 70 140 280 420 560 700 Volts VDC 50 100 200 400 600 800 1000 Volts Maximum DC Blocking Voltage Maximum Average Forward Rectified Current at TC = 55oC Peak Forward Surge Current 8.3 ms single half sine-wave superimposed on rated load (JEDEC method) Typical Thermal Resistance (Note 2) Operating and Storage Temperature Range MB3505 MB351 MB358 MB3510 UNITS IO 35.0 Amps IFSM 400 Amps RqJC 1.4 RqJA 16 T J, TSTG O -55 to + 150 C/W 0 C ELECTRICAL CHARACTERISTICS (@TA=25 C unless otherwise noted) O CHARACTERISTICS SYMBOL Maximum Instantaneous Forward Voltage at 17.5A DC Maximum DC Reverse Current at Rated DC Blocking Voltage NOTES : VF @TA = 25oC @TA = 100oC 1. Suffix "W" for wire type. 2. Typical Thermal Resistance: Heat-sink case mounted. 3. “Fully ROHS compliant”, “100% Sn plating (Pb-free)”. IR MB3505 MB351 MB352 MB354 1.1 5.0 500 MB356 MB358 MB3510 UNITS Volts uAmps 2007-5 AVERAGE FORWARD CURRENT, (A) 42 35 28 21 14 Single Phase Half Wave 60Hz Inductive or Resistive Load 0.375" (9.5mm) Lead Length 7 0 0 50 100 150 INSTANTANEOUS FORWARD CURRENT, (uA) RATING AND CHARACTERISTICS CURVES ( MB3505 THRU MB3510 ) 1000 TA = 100 OC 100 TA = 75 OC 10 TA = 25 OC 1 0.1 0 500 60 80 100 120 PERCENT OF RATED PEAK REVERSE VOLTAGE, (%) FIG.2 TYPICAL REVERSE CHARACTERISTICS 10 TJ = 25 OC Pulse width=300mS 1% Duty Cycle 0 40 CASE TEMPERATURE, ( C) 100 1 20 FIG.1 TYPICAL FORWARD CURRENT DERATING CURVE PEAK FORWARD SURGE CURRENT, (A) INSTANTANEOUS REVERSE CURRENT, (A) O 0.5 1.0 1.5 2.0 2.5 3.0 3.5 4.0 4.5 600 140 8.3mS Single Half Sine-Wave JEDEC Method 500 400 300 200 100 0 1 2 5 10 20 50 100 INSTANTANEOUS FORWARD VOLTAGE, (V) NUMBER OF CYCLES AT 60Hz FIG.3 TYPICAL INSTANTANEOUS FORWARD CHARACTERISTICS FIG.4 MAXIMUM NON-REPETITIVE FORWARD SURGE CURRENT .452 MAX. (11.5) .480 (12.2) .425 (10.8) 1.181 (30.0) 1.102 (28.0) .673 (17.1) .633 (16.1) AC .732 (18.6) .692 (17.6) AC .582 (14.8) .543 (13.8) MB-35 .452 MAX. (11.5) .042 (1.1) DIA. .080 (2.0) TYP. 1.181 (30.0) 1.102 (28.0) HOLE FOR NO. 8 SCREW 1.181 (30.0) 1.102 (28.0) .673 (17.1) .633 (16.1) .591 MAX. (15.0) 1.181 (30.0) 1.102 (28.0) AC .732 (18.6) .692 (17.6) AC .033x.250 (0.8x6.4) HOLE FOR NO. 8 SCREW .732 (18.6) .692 (17.6) MB-35W .468 (11.9) .429 (10.9) DISCLAIMER NOTICE Rectron Inc reserves the right to make changes without notice to any product specification herein, to make corrections, modifications, enhancements or other changes. Rectron Inc or anyone on its behalf assumes no responsibility or liability for any errors or inaccuracies. Data sheet specifications and its information contained are intended to provide a product description only. "Typical" parameters which may be included on RECTRON data sheets and/ or specifications can and do vary in different applications and actual performance may vary over time. Rectron Inc does not assume any liability arising out of the application or use of any product or circuit. Rectron products are not designed, intended or authorized for use in medical, life-saving implant or other applications intended for life-sustaining or other related applications where a failure or malfunction of component or circuitry may directly or indirectly cause injury or threaten a life without expressed written approval of Rectron Inc. Customers using or selling Rectron components for use in such applications do so at their own risk and shall agree to fully indemnify Rectron Inc and its subsidiaries harmless against all claims, damages and expenditures.