Series AMEPR30NC-Z up to 700mA | AC-DC LED driver FEATURES: Constant Current LED Driver Low Output Current Ripple 3 in 1 Dimming (0-10V/PWM/Resistor) Short Circuit, Open Circuit, Over Temperature Protection Models Single output Model Max Output Power (W) Output Voltage Range (V) 21.0 25.2 29.4 24-42 24-42 24-42 AMEPR30NC-4250Z AMEPR30NC-4260Z AMEPR30NC-4270Z Output Current (mA) 500 600 700 • • • • No Flicker, IP62 Low THD Active Power Factor Correction 5 Year Warranty Input Voltage (VAC/Hz) Efficiency (%) 90-305/47-63 90-305/47-63 90-305/47-63 79 80 81 NOTE: All specifications in this datasheet are measured at an ambient temperature of 25°C, humidity <75%, nominal input voltage and at rated output load unless otherwise specified. Input Specifications Parameters Input Current Inrush current <2ms Leakage current Input dissipation Power Factor Input Fuse Start-up Time Conditions Typical Maximum Units 90 VAC, full load 115 VAC, cold start 305 VAC, cold start 0.43 50 60 0.75 1.9 3.0 0.98 0.72 250V/2A 1.5 1.0 Arms No Load, 115Vac Output Short, 230Vac 115 VAC, full load 277 VAC, full load 115 VAC, full load 277 VAC, full load A mA W W Sec. Sec. Output Specifications Parameters Conditions Typical Current accuracy Maximum Units ±5 % Line regulation LL to HL ±1 % Load regulation Full Output Voltage Range ±1 210 % Ripple & Noise Output Current Ripple Current Overshoot Hold-up time Minimum Load Voltage Dimming Output Current Dimming Voltage Dimming PWM Freq. Recommended Dimming Resistor Full load LL to HL, full load at cold start >1 See Models Table Above 10 DIM+ to DIM- short 0-10V dimming PWM dimming Variable Resistor dimming 420 35 10 mV p-p mA % of Iout ms 30 12 3 36 mA V kHz kOhm Isolation Specifications Parameters Isolation Voltage Isolation Resistance Isolation Capacitance www.aimtec.com F 052.1e R4 Conditions Typical I/P – O/P I/P – FG O/P – FG I/P – O/P, 500Vdc >100MΩ 150 Tel: +1 514 620 2722 1 of 8 Rated Units 3750 2000 500 VAC VAC VAC VAC pF Toll free: + 1 888 9 AIMTEC (924 6832) North America only Series AMEPR30NC-Z up to 700mA | AC-DC LED driver General Specifications Parameters Conditions Switching frequency Over current protection Over voltage protection Short circuit protection Open circuit protection Over Temperature Protection Operating temperature Maximum case temperature Storage temperature Temperature coefficient Cooling Humidity Case material Weight Dimensions (L X W+ X H) MTBF Typical Maximum Units 138 KHz Refer to Constant Current vs. Constant Voltage Mode curve Refer to Constant Current vs. Constant Voltage Mode curve Continuous, Hiccup Mode, Auto recovery Continuous Clamping, Constant Output Voltage Threshold – Shutdown Output +103 Hysteresis – Auto Recovery +85 Without derating -30 to +50 -30 to +80 -40 to +85 oC oC oC oC oC 0.05 % / oC 90 % RH Free Air Convection Plastic 180 6.61 X 1.85 X 0.98 inches 168.0 X 47.0 X 25.0 mm 450,000 hrs (MIL-HDBK-217F at +25°C) g Safety Specifications Parameters Standards Electromagnetic Interference Harmonic Current Emissions Voltage fluctuations and flicker Electrostatic Discharge Immunity RF, Electromagnetic Field Immunity Electrical Fast Transient / Burst Immunity Surge Immunity RF, Conducted Disturbance Immunity Power frequency Magnetic Field Immunity Voltage dips, Short Interruptions Immunity Electromagnetic Immunity Requirements Applies to Lighting Equipment Wire connection: EN55015 / FCC Part 15, Class B EN61000-3-2, Class B EN61000-3-3 EN61000-4-2, 8kV Air, 4kV Contact, Level 3, Criteria A EN61000-4-3, Test-RS Level 3, Criteria A EN61000-4-4, Burst EFT Level 3, Criteria A EN61000-4-5, Line to Neutral 2kV, Line/Neutral to PE 4kV EN61000-4-6. Test-CS Level 3, Criteria A EN61000-4-8, Test 3A/m, Criteria A EN61000-4-11, Criteria B EN61547 Block diagram Recommended Wire gauge Connection 20-24 20-24 14-26 14-26 14-26 14-26 AC L AC N LED+ LEDDIM+ DIM- AC-L LED+ 1st LED AC LED LED LEDAC-N DIM+ R DIM+ www.aimtec.com F 052.1e R4 Tel: +1 514 620 2722 2 of 8 10V 0-10V Toll free: + 1 888 9 AIMTEC (924 6832) North America only Series AMEPR30NC-Z up to 700mA | AC-DC LED driver Dimensions 47.0 1.85 25.0 0.98 168.0 6.61 Side View1 25.0 0.98 168.0 6.61 Side View2 47.0 1.85 SCREW HOLE 25.0 0.98 LINE SLOT Efficiency vs. Input Voltage & Output Voltage (Constant current load) AMEPR30NC-4250Z 95.00% 90.00% Efficiency 85.00% 80.00% 115 VAC 75.00% 230 VAC 70.00% 277 VAC 65.00% 24 27 30 33 36 39 42 Output Voltage(V) www.aimtec.com F 052.1e R4 Tel: +1 514 620 2722 3 of 8 Toll free: + 1 888 9 AIMTEC (924 6832) North America only Series AMEPR30NC-Z up to 700mA | AC-DC LED driver AMEPR30NC-4260Z AMEPR30NC-4260Z 95.00% 90.00% Efficiency 85.00% 115 VAC 80.00% 230 VAC 75.00% 277 VAC 70.00% 65.00% 24 27 30 33 36 39 42 Output Voltage (V) AMEPR30NC-4270Z 95.00% 90.00% Efficiency 85.00% 115 VAC 80.00% 230 VAC 75.00% 277 VAC 70.00% 65.00% 24 27 30 33 36 39 42 Output Voltage(V) www.aimtec.com F 052.1e R4 Tel: +1 514 620 2722 4 of 8 Toll free: + 1 888 9 AIMTEC (924 6832) North America only Series AMEPR30NC-Z up to 700mA | AC-DC LED driver PFC Value vs. Output Load Voltage (constant current mode) AMEPR30NC-4250Z 1.200 PF 0.900 115 VAC 0.600 230 VAC 277 VAC 0.300 0.000 24 27 30 33 36 39 42 Output Voltage (V) AMEPR30NC-4260Z 1.200 PF 0.900 115 VAC 0.600 230 VAC 0.300 277 VAC 0.000 24 27 30 33 36 39 42 Output Voltage (V) www.aimtec.com F 052.1e R4 Tel: +1 514 620 2722 5 of 8 Toll free: + 1 888 9 AIMTEC (924 6832) North America only Series AMEPR30NC-Z up to 700mA | AC-DC LED driver AMEPR30NC-4270Z 1.200 PF 0.900 115 VAC 0.600 230 VAC 0.300 277 VAC 0.000 24 27 30 33 36 39 42 Output Voltage (V) Constant Current vs. Constant Voltage Mode AMEPR30NC-4250Z Constant Current vs. Constant 115/230/277 VAC 0.600 Voltage Output Current (A) 0.500 0.400 0.300 0.200 0.100 0.000 24 www.aimtec.com F 052.1e R4 27 30 33 36 39 42 Output Voltage (V) 45 48 51 Tel: +1 514 620 2722 6 of 8 Toll free: + 1 888 9 AIMTEC (924 6832) North America only Series AMEPR30NC-Z up to 700mA | AC-DC LED driver AMEPR30NC-4260Z Constant Current vs. Constant 115/230/277 VAC 0.700 Voltage Output Current (A) 0.600 0.500 0.400 0.300 0.200 0.100 0.000 24 27 30 33 36 39 42 Output Voltage (V) 45 48 51 AMEPR30NC-4270Z Constant Current vs. Constant 115/230/277 VAC 0.800 Voltage Output Current (A) 0.700 0.600 0.500 0.400 0.300 0.200 0.100 0.000 24 27 30 33 36 39 42 45 48 51 Output Voltage (V) www.aimtec.com F 052.1e R4 Tel: +1 514 620 2722 7 of 8 Toll free: + 1 888 9 AIMTEC (924 6832) North America only Series AMEPR30NC-Z up to 700mA | AC-DC LED driver Dimming Resistor/Dimming Voltage vs. Percentage of Output Current Output Current vs. Dimming Resistance/Voltage Percentage of rated output current 120.00% 115/230/277 VAC 110.00% 100.00% 90.00% 80.00% 70.00% 60.00% 50.00% 40.00% 30.00% 20.00% 10.00% 0.00% Dimming Resistance(kΩ)/Dimming Voltage(V) Percentage of rated output current 10V PWM duty cycle vs Percentage of Output Current 115/230/277 VAC 120.00% 110.00% 100.00% 90.00% 80.00% 70.00% 60.00% 50.00% 40.00% 30.00% 20.00% 10.00% 0.00% 0 10 20 30 40 50 60 70 10V PWM Duty Cycle (%) 80 90 100 NOTE: 1. Datasheets are updated as needed and as such, specifications are subject to change without notice. Once printed or downloaded, datasheets are no longer controlled by Aimtec; refer to www.aimtec.com for the most current product specifications. 2. Product labels shown, including safety agency certifications on labels, may vary based on the date manufactured. 3. Mechanical drawings and specifications are for reference only. 4. All specifications are measured at an ambient temperature of 25°C, humidity<75%, nominal input voltage and at rated output load unless otherwise specified. 5. Aimtec may not have conducted destructive testing or chemical analysis on all internal components and chemicals at the time of publishing this document. CAS numbers and other limited information are considered proprietary and may not be available for release. 6. This product is not designed for use in critical life support systems, equipment used in hazardous environments, nuclear control systems or other such applications which necessitate specific safety and regulatory standards other the ones listed in this datasheet. 7. Warranty is in accordance with Aimtec’s standard Terms of Sale available at www.aimtec.com. www.aimtec.com F 052.1e R4 Tel: +1 514 620 2722 8 of 8 Toll free: + 1 888 9 AIMTEC (924 6832) North America only