AEJ36 Series AC-DC Power Supplies XP Power 36 Watts • Energy Efficiency Level VI • European CoC Tier 2 • <0.075 W Standby Power • Single Outputs 5 to 48 V • Class II • -20 °C to 60 °C Operation • Universal Input • 3 Year Warranty Dimensions: AEJ36: 4.37 x 2.01 x 0.78” (111.0 x 51.0 x 20.0 mm) Models & Ratings Output Power Output Voltage Output Current 20 W 27 W 30 W 5.0 V 9.0 V 12.0 V 15.0 V 24.0 V 48.0 V 4.00 A 3.00 A 2.50 A 2.40 A 1.50 A 0.75 A 36 W Total Regulation Efficiency(1) ±5% 83.6% 87.3% 87.7% 88.3% 88.3% 88.3% Model Number AEJ36US05 AEJ36US09 AEJ36US12 AEJ36US15 AEJ36US24 AEJ36US48 Notes 1. Typical average of efficiencies measured at 25%, 50%, 75% and 100% load and 230 VAC input. Mechanical Details Cable Length: 5 V: 28” (720 mm) 18 AWG Others: 48” (1220 mm) 18 AWG 1.97 (50.0) IEC320-C8 0.78 (20.0) 4.33 (110.0) 0.47 (12.00) Notes 1. All dimensions shown in inches (mm). 2. Weight: 0.38 lbs (190 g) approx. 3. Tolerance is ±0.02 (±0.5) maximum, except output cable length which is ±2” (±50 mm) 1 4. Output connector is 5.5 mm dia. outer barrel, inner dia. is 2.5 mm with a center + and outer shell - polarity. www.xppower.com AEJ36 Series AC-DC Power Supplies Input Characteristic Minimum Notes & Conditions Maximum Units 264 VAC 63 60 0.075 Hz A A W Max. 48 ±2 Units VDC % 3 20 Full load and 115 VAC ±1 ±6 s ms ms % % Transient Response 5 % Maximum deviation, recovering to less than 1% within 500 µs for 25% step load Ripple and Noise 1 % pk-pk 175 143 % % % Input Voltage 90 Input Frequency Input Current Inrush Current No Load Input Power Input Protection 47 Typical 1.0 Measured at 100VAC 230 VAC, cold start at 25 °C T2.0A/250 VAC internal fuse in line Output Characteristic Output Voltage Initial Set Accuracy Minimum Load Start Up Delay Start Up Rise Time Hold Up Time Line Regulation Total Regulation Min. 5 Typ. 8 5 115 117 Trip and restart (hiccup), auto resetting 0.05 Overshoot Overload Protection Overvoltage Protection Short Circuit Protection Temperature Coefficient Notes & Conditions See Models and Ratings table At 60% load No minimum load required Measured with 20 MHz Bandwidth and 10 µF electrolytic in parallel with 0.1 µF ceramic capacitor. At turn on / turn off Recycle mains to reset %/°C Environmental Characteristic Operating Temperature Cooling Operating Humidity Storage Temperature Operating Altitude Shock Vibration Minimum -20 Natural convection 5 -20 Typical Maximum +60 Units °C 90 %RH +85 °C 2000 m IEC68-2-27, 30 g, 11 ms half sine, 3 times in each of 6 axes IEC68-2-6, 10-500 Hz, 2 g 10 mins/sweep, 60 mins for each of 3 axes Notes & Conditions Derate from 100% load at 40 °C to 60% load at 60 °C Non-condensing Derating Curve Output Power (%) 100 80 60 40 20 -20 40 Ambient Temperature (ºC) www.xppower.com 60 2 AEJ36 Series AC-DC Power Supplies General Characteristic Minimum Typical Maximum Units 88 Efficiency Isolation: Input to Output % 4242 See Models and Ratings table and curves. VDC Switching Frequency 67 kHz Power Density 5.4 W/in3 0.38 (190) lb (g) Mean Time Between Failure 283 kHrs Weight Notes & Conditions 48 V version, MIL-HDBK-217F at 25 °C GB, 115 VAC Efficiency Curves AEJ36US12 100% 90% Efficiency 80% 115Vac input 70% 230Vac input 60% 50% 10 20 30 40 50 60 70 80 90 100 Load (%) AEJ36US24 100% Efficiency 90% 80% 115Vac input 70% 230Vac input 60% 50% 10 20 30 40 50 60 70 80 90 100 Load (%) EMC: Emissions Phenomenon Emissions Harmonic Current Voltage Flicker Standard EN55022 EN61000-3-2 EN61000-3-3 Test Level Level B Class A www.xppower.com Notes & Conditions Conducted & Radiated 3 AEJ36 Series AC-DC Power Supplies EMC: Immunity Phenomenon Standard ESD Radiated EFT/Burst Surge Conducted Magnetic Fields EN61000-4-2 EN61000-4-3 EN61000-4-4 EN61000-4-5 EN61000-4-6 EN61000-4-8 Dips and Interruptions EN61000-4-11 Test Level Criteria ±8 kV Air, ±4 kV contact 3 V/m 2 2 3V 3 A/m Dip: 30% 500 ms Dip: 60% 100 ms Int: 100% 5000 ms Int: 100% 10 ms A A A A A A A A B A Notes & Conditions Line to Neutral Safety Approvals Safety Agency Safety Standard UL Notes & Conditions UL60950-1 TUV EN60950-1 CB IEC60950-1 Mechanical Details Cable Length: 5 V: 28” (720 mm) 18 AWG Others: 48” (1220 mm) 18 AWG 1.97 (50.0) IEC320-C8 0.78 (20.0) 4.33 (110.0) 0.47 (12.00) Notes 1. All dimensions shown in inches (mm). 2. Weight: 0.38 lbs (190 g) approx. 3. Tolerance is ±0.02 (±0.5) maximum, except output cable length which is ±2” (±50 mm) 4. Output connector is 5.5 mm dia. outer barrel, inner dia. is 2.5 mm with a center + and outer shell - polarity. www.xppower.com 28 April 16