Green Power Solutions Srl Web: www.gpsemi.it e-mail: [email protected] Phone: +39-011-988 2251 Fax: +39-011-988 1358 http://gpsemi.it/pdf/GPTP2220.pdf GPTP2220 PHASE CONTROLLED SCR High reliability operation DC power supply AC drives VOLTAGE UP TO 1600 V (*) AVERAGE CURRENT 2200 A SURGE CURRENT BLOCKING CHARACTERISTICS Characteristic Conditions 32 kA Value VRRM Repetitive peak reverse voltage 1600 V VRSM Non-repetitive peak reverse voltage 1700 V VDRM Repetitive peak off-state voltage IDRM IRRM Repetitive peak off-state current, max. Repetitive peak reverse current, max. 1600 V VDRM, single phase, half wave, Tj = Tjmax VRRM, single phase, half wave, Tj = Tjmax 75 mA 75 mA ON-STATE CHARACTERISTICS IT(AV) Average on-state current Sine wave,180° conduction, Th = 55 °C 2200 A IT(RMS) R.M.S. on-state current 3456 A ITSM Surge on-state current Sine wave,180° conduction, Th = 55 °C Non rep. half sine wave, 50 Hz, VR = 0 V, Tj = Tjmax I²t VT(TO) I² t for fusing coordination Threshold voltage Tj = Tjmax 0.85 V rT On-state slope resistance Tj = Tjmax 0.122 mW VTM Peak on-state voltage, max IH IL Holding current, max Latching current, typ On-state current IT = 2000 A , Tj = 25 °C Tj = 25 °C Tj = 25 °C 32 kA 5120 kA²s 1.15 V 300 mA 700 mA TRIGGERING CHARACTERISTICS VGT Gate trigger voltage Tj = 25 °C, VD = 5 V IGT Gate trigger current Tj = 25 °C, VD = 5 V 300 mA VGD Non-trigger voltage VD = 67% VRRM, Tj = Tjmax 0.25 V PGM Peak gate power dissipation Pulse width 100 µs 150 W PG(AV) Average gate power dissipation IFGM Peak gate current 10 A VFGM VRGM Peak gate voltage (forward) Peak gate voltage (reverse) 10 V 12 V 2.5 V 2 W SWITCHING CHARACTERISTICS di/dt Critical rate of rise of on-state current Tj = Tjmax 200 A/µs dV/dt tq Critical rate of rise of off-state voltage Tj = Tjmax 1000 V/µs Turn-off time, typ Tj = Tjmax, IT = 1000 A, di/dt = -20 A/µs µs VR = 50 V, VD = 67% VDRM, dV/dt = 20 V/µs THERMAL AND MECHANICAL CHARACTERISTICS Rth(j-c) Thermal resistance (junction to case) Double side cooled 0.015 °C/W Rth(c-h) Thermal resistance (case to heatsink) Double side cooled 0.006 °C/W Tjmax Max operating junction temperature Tstg Storage temperature -40 / 125 °C F Clamping force ± 5% Mass 23 kN 500 g (*) 1800 V available upon request - Contact Factory Document GPTP2220T003 125 °C PHASE CONTROLLED SCR Current rating - sine wave GPTP2220 Power loss - sine wave 120 3500 110 3000 100 2500 90 2000 180° PF [W] Heatsink temperature [°C] 130 80 90° 120° 60° 30° 1500 1000 70 500 60 30° 50 0 400 800 60° 90° 1200 1600 120° 180° 2000 0 0 2400 400 800 1200 1600 2000 2400 IT[A] IT [A] Maximum surge current d.s. cooled On-state voltage drop 35 30 20 [A] ITIT[A] ITSM [A] 25 15 10 5 0 1 10 100 5000 5000 4500 4500 4000 4000 3500 3500 3000 3000 2500 2500 2000 2000 1500 1500 1000 1000 500 500 00 0.5 0 Tj=Tjmax 0.5 1 Tj=Tjmax 1.5 1 VVTT [V] [V] Number of cycle current pulses [n] ZTH(j-c) [°C / W] Thermal impedance (j-c) 0.016 0.014 0.012 0.01 0.008 0.006 0.004 0.002 0 0.001 0.01 0.1 1 10 100 Time [s] Ordering information GPTP2220-VVGL VV: blocking voltage / 100 (e.g. 16 for 1600 V) G: trigger lead type (S = straight T = twisted blank = no leads) L: trigger lead lenght x 100mm (3 - 4 - 5 - 7 blank = no leads) dimensions mm In the interest of product improvement Green Power Solutions reserves the right to change any specification given in this data sheet without notice. Document GPTP2220T003 1.5 2