PC PSU FSP350-60HCN DESCRIPTION This is the specification of Model FSP350-60HC N; AC -line powered switching power supply with active PFC (Power Factor C orrection) circuit, meet EN61000-3-2. Also, +5Vsb power is less than 0.5Winput at power off mode (PS_ON input at high state) which is comply with ErP Lot 6 year 2013 requirement. APPLICATION Desktop SAFETY STANDARD APPAOVAL W ATTAGE Wattage: 350W DIMENSION Dimension: 140mm(L) x 150mm(W) x 86mm(H) PRODUCT HIGHLIGHT Efficiency Level: Erp Lot: Input Voltage: 78% <0.5W 230V 200-240 Vac 47-63 Hz 230V@ < 2.5 Amps - rms TEMP.Range: MTBF: OUTPUT SPECIFICATION Output Rise Time: Efficiency: 78% PWOK Delay Time: 500ms > PWOK > 100ms EMC Performance: EN55022 class B EN55024 EN 61000-3-2 EN 61000-3-3 ENVIRONMENTAL SPECIFICATION INPUT SPECIFICATION Input Range: Input Frequency: Input Current: GENERAL SPECIFICATION + 3.3Vdc : 20ms Maximum + 5Vdc : 20ms Maximum + 12Vdc : 20ms Maximum + 5Vsb : 20ms Maximum - 12Vdc : 20ms Maximum *Output Voltage and C urrent Rating +3.3V Ripple-Noise(R-P) mV 50mV Regulation Load % ±5% Output Max.(A) 21A Output Min.(A) 0.1A +5V 50mV ±5% 20A 0.2A +12V1 120mV ±5% 15A 0.1A +12V2 120mV ±5% 15A 0.5A Operating Temperature:10°C to +40°C Storage Temperature: -20°C to + 80℃ The power supply reliability, when calculated by MIL-HDBK-217;latest revision, are exceed 100,000 hours with all output at typical load and an ambient temperature of 25℃. -12V 120mV ±10% 0.5A 0A NOTES (1 ) +3.3V & +5V total output not exceed 105W. ( 2 ) Maximum combined current for the +12V outputs shall be 28A . ( 3 ) +12V2 Peak current is 18A (less then 10m Sec.) , minimum voltage during peak is >11.0Vdc. ( 4 ) +5Vsb Peak current is 3.5A(less then 500m Sec.) , minimum voltage during peak is > 4.5Vdc. This content is subject to change, please refer to specification for m ore detail. FSP reserve the right to change the content without prior notice +5Vsb 50mV ±5% 2.5A 0A