DPA Series • 16 Pin DIP SSR • Ratings to 1A @ 280 VAC • SCR output • Voltage or current-control input • Zero-crossing (resistive loads) output PRODUCT SELECTION Control Voltage 3.5-10 VDC 10-35 mA DPA4119 DPA4111 DPA6119 DPA6111 DPA41xx DPA61xx 20-140 400 0.01 500 1.0 0.025 30 1.2 0.5 20-280 600 0.01 500 1.0 0.025 30 1.2 0.5 DPAxx11 DPAxx19 10-35 mA 1.0 mA 1/2 Cycle 1/2 Cycle 3.5-10 VDC 1.0 VDC 15 mAdc 270 Ohm 1/2 Cycle 1/2 Cycle AVAILABLE OPTIONS OUTPUT SPECIFICATIONS (1) Description Operating Voltage (47-63Hz) [Vrms] Transient Overvoltage [Vpk] Maximum Off-State Leakage Current @ Rated Voltage [mArms] Minimum Off-State dv/dt @ Maximum Rated Voltage [V/µsec] (3) Maximum Load Current [Arms] Minimum Load Current [Arms] Maximum Surge Current (16.6ms) [Apk] Maximum On-State Voltage Drop @ Rated Current [Vpk] Minimum Power Factor (with Maximum Load) INPUT SPECIFICATIONS (1) Description Control Voltage Range Control Current Range Must Turn Off-State Current Must Turn Off-State Voltage Typical Input Current @ 5 VDC Nominal Input Impedance Maximum Turn-On Time [msec] Maximum Turn-Off Time [msec] GENERAL SPECIFICATIONS Description Parameters Dielectric Strength, Input/Output/Base (50/60Hz)(2) Minimum Insulation Resistance (@ 500 VDC)(2) 3750 Vrms 109 Ohm Maximum Capacitance, Input/Output Ambient Operating Temperature Range Ambient Storage Temperature Range Weight (typical) Encapsulation 2.0 pF -30 to 80°C -30 to 125°C 0.1 oz. (2.9g) Thermally Conductive Epoxy GENERAL NOTES 1) All parameters at 25°C unless otherwise specified. 2) Dielectric and insulation resistance are measured between input and output 3) Off-State dv/dt test method per EIA/NARM standard RS MECHANICAL SPECIFICATIONS PIN 8: AC LOAD PIN 10: AC LOAD PIN 16: +DC CONTROL PIN 1: -DC CONTROL THERMAL DERATE INFORMATION AGENCY APPROVALS UL E116950 CSA LR81689 120210 WIRING DIAGRAM ANNEX - ENVIROMENTAL INFORMATION