THE CONNOR-WINFIELD CORP. 2111 COMPREHENSIVE DRIVE. AURORA, IL 60505. FAX (630) 581-5040. PHONE (630) 851-4722. www.conwin.com PRODUCT D ATA SHEET CRYSTAL CONTROLLED OSCILLATORS 14 PIN 3.3V ECL CLOCK OSCILLATOR ABSOLUTE MAXIMUM RATINGS PARAMETER UNITS Storage Temperature Supply Voltage (Vcc) MINIMUM NOMINAL MAXIMUM UNITS -40 - 85 °C -0.5 - 7.0 Vdc MODEL SPECIFICATIONS: MODEL EE14-511 NOTE TABLE 2.0 Center Frequency Total Frequency Tolerance (Fo) 13 -25 - 165 25 MHz ppm EE14-511, EE14-521, EE14-531, EE14-541 1 DESCRIPTION MODEL EE14-521 Center Frequency Total Frequency Tolerance (Fo) 13 -50 - 165 50 MHz ppm 1 13 -100 - 165 100 MHz ppm 1 13 -20 - 165 20 MHz ppm 1 MINIMUM NOMINAL MAXIMUM UNITS NOTE 13 -20 0 - MHz ppm °C 1 - 165 20 70 Vdc MODEL EE14-531 Center Frequency Total Frequency Tolerance (Fo) MODEL EE14-541 Center Frequency Total Frequency Tolerance (Fo) OPERATING SPECIFICATIONS TABLE 3.0 PARAMETER Center Frequency Total Frequency Tolerance Operating Temperature Range (Fo) Supply Voltage (Vcc) 3.135 3.3 3.465 Supply Current (Icc) - - 60 mA Jitter (BW=10Hz to 20MHz) - - 5 pS RMS Jitter (BW=12kHz to 20MHz) SSB Phase Noise at 100Hz offset SSB Phase Noise at 1KHz offset SSB Phase Noise at 10KHz offset SSB Phase Noise at 100KHz offset - -60 -100 -130 -140 1 - pS RMS dBc/Hz dBc/Hz dBc/Hz dBc/Hz MINIMUM NOMINAL MAXIMUM UNITS NOTE 2.275 45 - 50 - 50 1.68 55 1 Ohms Vdc Vdc % nS 2 PECL OUTPUT CHARACTERISTICS (High) (Low) (Voh) (Vol) Duty Cycle Rise / Fall Time 20% to 80% PACKAGE CHARACTERISTICS Package PROCESS RECOMMENDATIONS Solder Reflow Wash The Connor-Winfield EE14-5xx series are fixed frequency Crystal Controlled Oscillators (XO) designed for applications requiring low jitter and a tight frequency stability. Operating at 3.3V supply voltage, the EE14-5xx series provides LVPECL Differential outputs. FEATURES 3.3V OPERATION LOW JITTER <1pS RMS LVPECL DIFFERENTIAL OUTPUTS TABLE 4.0 PARAMETER LOAD Voltage CW 0107 EE14-511 125.00M TABLE 1.0 OVERALL FREQUENCY TOLERANCE: MODEL EE14-511 ±25ppm MODEL EE14-521 ±50ppm MODEL EE14-531 ±100ppm MODEL EE14-541 ±20ppm 3 TEMPERATURE RANGE: 0 to 70°C TABLE 5.0 Non-hermetic package consisting of an FR4 substrat e with grounded metal cover. TABLE 6.0 The component solder used internal to this device has a m elting point of 221°C. The peak temperature inside the device should be less than or equal to 220°C for a maximum of 10 seconds Ultrasonic cleaning is not recommended. Notes 1) Inclusive of calibration tolerance @ 25°C, frequency vs. temperature, frequency vs. chang e in supply voltage, frequency vs. load variations, shock and vibration and 10 years aging. 2) Output must be terminated into 50 ohms to V cc – 2V or Thevenin equivalent. 3) Duty Cycle measured at 1.977V ORDERING INFORMATION EE14-511 - 125.00 MHz LVPECL CLOCK SERIES CENTER FREQUENCY Specifications subject to change without notice. DATA SHEET #: INT Ec061 PAGE 1 OF 2 REV: 12 DATE: 11/4/02 aCopyright 2001 Connor-Winfield all rights reserved. THE CONNOR-WINFIELD CORP. 2111 COMPREHENSIVE DRIVE. AURORA, IL 60505. FAX (630) 581-5040. PHONE (630) 851-4722. www.conwin.com PRODUCT D ATA SHEET CRYSTAL CONTROLLED OSCILLATORS .260 (6.60mm) COMP OUT Vee (Case Ground) OUTPUT Vcc Dimensional Tolerance: ±.005 (.127mm) ±.02 (.508mm) Specifications subject to change without notice. DATA SHEET #: INT Ec061 PAGE 2 OF 2 REV: 12 DATE: 11/4/02 aCopyright 2001 Connor-Winfield all rights reserved.