Through Hole Lamp Product Data Sheet LTL-N709PP2 Spec No.: DS-20-96-0273 Effective Date: 05/08/2001 Revision: - LITE-ON DCC RELEASE BNS-OD-FC001/A4 LITE-ON Technology Corp. / Optoelectronics No.90,Chien 1 Road, Chung Ho, New Taipei City 23585, Taiwan, R.O.C. Tel: 886-2-2222-6181 Fax: 886-2-2221-1948 / 886-2-2221-0660 http://www.liteon.com/opto LITE-ON ELECTRONICS, INC. Property of Lite-On Only Features * Low power consumption. * General purpose leads. * I.C. Compatible/low current requirements. * Reliable and rugged Package Dimensions Part No. Lens Source Color LTL-N709PP2 Red Diffused Bright Red Notes: 1. All dimensions are in millimeters (inches). 2. Tolerance is ±0.25mm(.010") unless otherwise noted. 3. Protruded resin under flange is 1.0mm(.04") max. 4. Lead spacing is measured where the leads emerge from the package. 5. Specifications are subject to change without notice. Part No. : LTL-N709PP2 BNS-OD-C131/A4 Page : 1 of 4 LITE-ON ELECTRONICS, INC. Property of Lite-On Only Absolute Maximum Ratings at TA=25℃ Parameter Maximum Rating Unit 40 mW 60 mA Continuous Forward Current 15 mA Derating Linear From 50℃ 0.2 mA/℃ 5 V Power Dissipation Peak Forward Current (1/10 Duty Cycle, 0.1ms Pulse Width) Reverse Voltage Operating Temperature Range -55℃ to + 100℃ Storage Temperature Range -55℃ to + 100℃ Lead Soldering Temperature [1.6mm(.063") From Body] Part No. : LTL-N709PP2 BNS-OD-C131/A4 260℃ for 5 Seconds Page : 2 of 4 LITE-ON ELECTRONICS, INC. Property of Lite-On Only Electrical / Optical Characteristics at TA=25℃ Parameter Symbol Min. Typ. IV 1.1 3.7 mcd 2θ1/2 38 deg Peak Emission Wavelength λP 697 nm Dominant Wavelength λd 657 nm Δλ 90 nm Forward Voltage VF 2.1 Reverse Current IR Capacitance C Luminous Intensity Viewing Angle Spectral Line Half-Width 55 Max. Unit 2.6 V 100 μA pF Test Condition IF = 10mA Note 1,4 Note 2 (Fig.6) Measurement @Peak (Fig.1) Note 3 IF = 20mA VR = 5V VF = 0 , f = 1MHz Note: 1. Luminous intensity is measured with a light sensor and filter combination that approximates the CIE (Commission International De L'Eclairage) eye-response curve. 2. θ1/2 is the off-axis angle at which the luminous intensity is half the axial luminous intensity. 3. The dominant wavelength, λd is derived from the CIE chromaticity diagram and represents the single wavelength which defines the color of the device. 4. The Iv guarantee should be added ±15% . Part No. : LTL-N709PP2 BNS-OD-C131/A4 Page : 3 of 4 LITE-ON ELECTRONICS, INC. Property of Lite-On Only Typical Electrical / Optical Characteristics Curves (25℃ Ambient Temperature Unless Otherwise Noted) Part No. : LTL-N709PP2 BNS-OD-C131/A4 Page : 4 of 4