Frontier Electronics Corp. 667 E. COCHRAN STREET, SIMI VALLEY, CA 93065 TEL: (805) 522-9998 FAX: (805) 522-9989 E-mail: [email protected] Web: http://www.frontierusa.com 1A SURFACE MOUNT FAST RECOVERY RECTIFIERS FFM101M-LFR THRU FFM107M-LFR .161(4.1) .146(3.7) FEATURES z FOR SURFACE MOUNTED APPLICATIONS z LOW PROFILE PACKAGE z BUILT-IN STRAIN RELIEF z EASY PICK AND PLACE z PLASTIC MATERIAL USED CARRIES UNDERWRITERS LABORATORY CLASSIFICATION 94 V-0 z FAST SWITCHING z HIGH TEMPERATURE SOLDERING 250°C/10 SECONDS AT TERMINALS z ROHS .071(1.8 ) .055(1.4 ) .0012(0.3) Typ. .126(3.2) .110(2.8) .063(1.6) .055(1.4) MECHANICAL DATA z CASE: MOLDED PLASTIC SOD-123, SOD-123, DIMENSIONS IN INCHES AND (MILLIMETERS) z TERMINALS: SOLDER PLATED z POLARITY: INDICATED BY CATHODE BAND z WEIGHT: 0.04 GRAMS .035(0.9) Typ. .035(0.9) Typ. MAXIMUM RATINGS AND ELECTRICAL CHARACTERISTICS RATINGS AT 25°C AMBIENT TEMPERATURE UNLESS OTHERWISE SPECIFIED SINGLE PHASE, HALF WAVE, 60 HZ, RESISTIVE OR INDUCTIVE LOAD. FOR CAPACITIVE LOAD, DERATE CURRENT BY 20% RATINGS MAXIMUM RECURRENT PEAK REVERSE VOLTAGE MAXIMUM RMS VOLTAGE MAXIMUM DC BLOCKING VOLTAGE MAXIMUM AVERAGE FORWARD RECTIFIED CURRENT AT TL=90°C SYMBOL VRRM VRMS VDC FFM101M-LF FFM102M-LF FFM103M-LF FFM104M-LF FFM105M-LF FFM106M-LF FFM107M-LF UNITS R R R R R R R 50 100 200 400 600 800 1000 V 35 70 140 280 420 560 700 V 50 100 200 400 600 800 1000 V IO 1.0 A IFSM 30 A CJ θJL 15 PF 30 °C/W STORAGE TEMPERATURE RANGE TSTG -55 TO + 150 ℃ OPERATING TEMPERATURE RANGE TOP -55 TO + 125 ℃ MAXIMUM OVERLOAD SURGE 8.3ms SINGLE HALF SINE-WAVE TYPICAL JUNCTION CAPACITANCE (NOTE 1) TYPICAL THERMAL RESISTANCE (NOTE 2) ELECTRICAL CHARACTERISTICS (AT TA =25°C UNLESS OTHERWISE NOTED) CHARACTERISTICS SYMBOL FFM101M-LF FFM102M-LF FFM103M-LF FFM104M-LF FFM105M-LF FFM106M-LF FFM107M-LF UNITS R R R R R R R MAXIMUM FORWARD VOLTAGE AT 1.0A AND 25℃ VF 1.3 V MAXIMUM REVERSE CURRENT AT 25℃ IR 5 μA MAXIMUM REVERSE RECOVERY TIME (NOTE 3) MARKING NOTE: TRR 150 F1 F2 250 F3 F4 F5 500 F6 1. MEASURED AT 1.0 MHZ AND APPLIED REVERSE VOLTAGE OF 4.0 V 2. THERMAL RESISTANCE FROM JUNCTION TO TERMINAL 5.0mm2 (.013 mm THICK) LAND AREAS 3. REVERSE RECOVERY TEST CONDITIONS: IF=0.5A, IR=1.0A, IRR=0.25A FFM101M-LFR THRU FFM107M-LFR Page: 1 nS F7 RATINGS AND CHARACTERISTIC CURVE FFM101M-LFR THRU FFM107M-LFR FIG. 1-TEST CIRCUIT DIAGRAM AND REVERSE RECOVERY TIME CHARACTERISTIC 10Ω NO INDUCTIVE 50Ω NO INDUCTIVE Trr +0.5A (-) D.U.T. 0 PULSE GENERATOR ( NOTE 2 ) (+) 25 Vdc (approx) 1Ω NON INDUCTIVE (-) OSCILLOSCOPE ( NOTE 1 ) -0.25A (+) -1.0A 1cm NOTE: 1. RISE TIME=7ns MAX. INPUT IMPEDANCE=1 MOhms 22PF 2. RISE TIME =10ns MAX. SOURCE IMPEDANCE=50 OHMS SET TIME BASE FOR 10/20 ns/cm SINGLE PHASE HALF WAVE 60Hz RESISTIVE OR INDUCTIVE LOAD 1.0 0.8 0.6 0.4 P.C.B MOUNTED ON 0.3×0.3”(8.0×8.0mm) COPPER PAD AREAS 0.2 0 0 20 40 60 80 100 120 140 160 180 200 LEAD TEMPERATURE (OC) FIG. 3-TYPICAL JUNCTION CAPACITANCE Fig. 5-MAXIMUM FORWARD SURGE CURRENT PEAK FORWARD SURGE CURRENT AMPERES Io-AVERAGE RECTIFIED CURRENT (A) Fig. 2-MAXIMUM CURRENT DERATING CURVE 30 TA=75oC 8.3ms SINGLE HALF SINE-WAVE JEDEC METHOD 20 10 1.0 CYCLE 0 1 10 100 NUMBER OF CYCLES AT 60 HZ 20 10 FIG. 6-TYPICAL INSTANTANEOUS FORWARD CHARACTERISTICS f = 1 MHz Vsig = 50 mVp-p 1 1 10 100 INSTANTANEOUS REVERSE CURRENT, MICRO AMPERES(uA) REVERSE VOLTAGE, VOLTS 100 FIG. 4-TYPICAL REVERSE CHARACTERISTICS 10 TJ=100oC 1.0 0.1 TJ=25oC INSTANTANEOUS FORWARD CURRENT, IF(A) CAPACITANCE, pF Tj=25oC 10 1.0 Tj=25oC PULSE WIDTH =300us 1% DUTY CYCLE 0.1 .4 .01 .6 .8 1.0 1.2 1.4 1.6 INSTANTANEOUS FORWARD VOLTAGE, (V) 0 20 40 60 80 100 120 140 PERCENT OF RATED PEAK REVERSE VOLTAGE FFM101M-LFR THRU FFM107M-LFR Page: 2