3.5x2.8x1.9mm Red & Green & Blue SMD LED OSTBMAS2C2A ■Outline ● High Luminous PLCC4 Top SMD LEDs ● 3.5x2.8x1.9mm Standard Directivity ● Superior Weather-resistance ● UV Resistant Silicone ● White Diffused Type Dimension 0.1Typ 2.8 1 3 4 3.5 3.2 2 1.9 0.8±0.3 2.2 3 2 1 ■Applications Toys ● Audio ● Games ● Other Lighting ■Absolute 0.95 ● 1.5 ■Features 4.Common Anode 1.Red 2.Pure Green 3.Blue Unit:mm Tolerance:±0.20mm (Ta=25℃) Value Maximum Rating Item Symbol Red G/B ■Directivity Unit DC Forward Current IF 30 30 mA Pulse Forward Current* IFP 100 100 mA Reverse Voltage VR 5 5 V Power Dissipation PD 78 108 mW Operating Temperature Topr -30 ~ +85 ℃ Storage Temperature Tstg -40~ +100 ℃ Lead Soldering Temperature Tsol 260℃/5sec - *Pulse width Max.10ms ■Electrical DC Forward Voltage Reverse Current Domi. Wavelength* Luminous Intensity* 50% Power Angle 0 0 Duty ratio max 1/10 (Ta=25℃) -Optical Characteristics Item 4 Symbol Condition Min. Typ. Max. Unit VF (Red) IF=20mA 1.8 2.1 2.6 V VF (G/B) IF=20mA 2.9 3.1 3.6 V IR VR=5V - - 10 µA λD(Red) IF=20mA 620 625 630 nm λD(Green) IF=20mA 520 525 530 nm λD(Blue) IF=20mA 465 470 475 nm Iv(Red) IF=20mA 330 500 - mcd Iv(Green) IF=20mA 330 450 - mcd Iv(Blue) IF=20mA 150 200 - mcd 2θ1/2 IF=20mA - 120 - deg *1 Tolerance of dominant wavelength is +1nm *2 Tolerance of luminous intensity is +15% LED & Application Technologies http://www.optosupply.com VER A.0 3.5x2.8x1.9mm Red & Green & Blue SMD LED OSTBMAS2C2A Soldering Heat Reliability (DIP): IR Reflow soldering Profile · Reflow soldering should not be done more than two times. · When soldering, do not put stress on the LEDs during heating. · After soldering, do not warp the circuit board. · Repairing should not be done after the LEDs have been soldered. When repairing is unavoidable, a double-head soldering iron should be used. It should be confirmed beforehand whether the characteristics of the LEDs will or will not be damaged by repairing. LED & Application Technologies http://www.optosupply.com VER A.0