GP30A THRU GP30M SINTERED GLASS JUNCTION PLASTIC RECTIFIER VOLTAGE:50 TO 1000V CURRENT: 3.0A FEATURE DO-201AD High temperature metallurgically bonded construction Sintered glass cavity free junction Capability of meeting environmental standard of MIL-S-19500 High temperature soldering guaranteed 350°C /10sec/0.375”lead length at 5 lbs tension Operate at Ta =55°C with no thermal run away Typical Ir<0.1µA MECHANICAL DATA Terminal: Plated axial leads solderable per MIL-STD 202E, method 208C Case: Molded with UL-94 Class V-0 recognized Flame Retardant Epoxy Polarity: color band denotes cathode Mounting position: any Dimensions in inches and (millimeters) MAXIMUM RATINGS AND ELECTRICAL CHARACTERISTICS (single-phase, half-wave, 60HZ, resistive or inductive load rating at 25°C, unless otherwise stated, for capacitive load, derate current by 20%) SYMBOL GP 30A GP 30B GP 30D GP 30G GP 30J GP 30K GP 30M units Maximum Recurrent Peak Reverse Voltage Maximum RMS Voltage Maximum DC blocking Voltage Vrrm Vrms Vdc 50 35 50 100 70 100 200 140 200 400 280 400 600 420 600 800 560 800 1000 700 1000 V V V Maximum Average Forward Rectified Current 3/8”lead length at Ta =55°C If(av) 3.0 A Peak Forward Surge Current 8.3ms single Half sine-wave superimposed on rated load Ifsm 125.0 A Maximum Instantaneous Forward Voltage at 3.0A Vf Maximum full load reverse current full cycle Average at 55°C Ir(av) 100.0 Maximum DC Reverse Current Ta =25°C at rated DC blocking voltage Ta =150°C Typical Reverse Recovery Time (Note 1) Typical Junction Capacitance Typical Thermal Resistance (Note 2) (Note 3) Storage and Operating Junction Temperature 1.2 1.1 Ir 5.0 100.0 Trr 3.0 V µA µA µA µS Cj 40.0 pF R(ja) 20.0 Tstg, Tj -65 to +175 °C /W °C Note: 1. Reverse Recovery Condition If =0.5A, Ir =1.0A, Irr =0.25A 2. Measured at 1.0 MHz and applied reverse voltage of 4.0Vdc 3. Thermal Resistance from Junction to Ambient at 3/8”lead length, P.C. Board Mounted Rev.A4 www.gulfsemi.com RATINGS AND CHARACTERISTIC CURVES GP30A THRU GP30M 1 1 Rev.A4 www.gulfsemi.com