AM100/150 THRU AM1010/1510 1.0 TO 1.5 AMPERE SILICON MINIATURE SINGLE-PHASE BRIDGE VOLTAGE - 50 to 1000 Volts CURRENT - 1.0~1.5 Amperes AM FEATURES l Ratings to 1000V PRV l Surge overload rating— 30/50 amperes peak l Ideal for printed circuit board l Reliable construction utilizing molded plastic l Mounting position: Any MECHANICAL DATA Case: Reliable low cost construction utilizing molded plastic technique results in inexpensive product Terminals: Lead solderable per MIL-STD-202, Method 208 Polarity: Polarity symbols marking on body Weight: 0.05 ounce, 1.3 grams Available with 0.50 inch leads (P/N add suffix “S”) MAXIMUM RATINGS AND ELECTRICAL CHARACTERISTICS Ratings at 25 ambient temperature unless otherwise specified. Single phase, half wave, 60Hz, Resistive or inductive load. For capacitive load, derate current by 20%. Maximum Recurrent Peak Reverse Voltage Maximum RMS Bridge input Voltage Maximum DC Blocking Voltage Maximum Average Forward Rectified AM100 Current at TA=50 AM150 Peak Forward Surge Current, 8.3ms single AM100 half sine-wave superimposed on rated load AM150 Maximum Forward Voltage Drop per Bridge Element at 1.0A DC Maximum Reverse Current at Rated TA= 25 DC Blocking Voltage per element TA=100 2 I t Rating for fusing ( t< 8.35ms) Typical Junction capacitance per leg (Note 1) CJ Typical Thermal resistance per leg (Note 2) R JA Typical Thermal resistance per leg (Note 2) R JL Operating Temperature Range TJ Storage Temperature Range TA AM100 AM101 AM102 AM104 AM106 AM108 AM1010 UNITS AM150 AM151 AM152 AM154 AM156 AM158 AM1510 V 50 100 200 400 600 800 1000 V 35 70 140 280 420 560 700 V 50 100 200 400 600 800 1000 A 1.0 1.5 A 30.0 50.0 1.0 V 10.0 1.0 10 24 36 13 -55 to +125 -55 to +150 A mA 2 AS PF /W NOTES: 1. Measured at 1 MHz and applied reverse voltage of 4.0 Volts 2. Thermal resistance from junction to ambient and from junction to lead mounted on P.C.B. with 0.47×0.47”(12×12mm) copper pads RATING AND CHARACTERISTIC CURVES AM100/150 THRU AM1010/1510 Fig. 1-MAXIMUM NON-REPETITIVE SURGE CURRENT Fig. 2-DERATING CURVE FOR OUTPUT RECTIFIED CURRENT Fig. 3-TYPICAL FORWARD CHARACTERISTICS Fig. 4-TYPICAL REVERSE CHARACTERISTICS