GBU10A THRU GBU10M SINGLE PHASE GLASS PASSIVATED BRIDGE RECTIFIER Voltage: 50 to 1000V Current: 10.0A Features GBU Ideal for printed circuit board Glass passivated chip junction High case dielectric strength High surge overload rating This series is UL listed under Recognized Component Index, file number E230084 Mechanical Data Terminal: Plated leads solderable per MIL-STD 202E, method 208C Case: UL-94 Class V-0 recognized Flame Retardant Epoxy Polarity: Polarity symbol marked on body Dimensions in millimeters MAXIMUM RATINGS AND ELECTRICAL CHARACTERISTICS (single-phase, half -wave, 60HZ, resistive or inductive load rating at 25°C, unless otherwise stated, for capacitive load, derate current by 20%) Symbol GBU 10A GBU 10B GBU 10D GBU 10G GBU 10J GBU 10K GBU 10M units Maximum repetitive peak reverse voltage Vrrm 50 100 200 400 600 800 1000 V Maximum RMS voltage Vrms 35 70 140 280 420 560 700 V Maximum DC blocking voltage Vdc 50 100 200 400 600 800 1000 V Maximum average forward rectified output current at Tc = 100℃ (Note 1) Peak forward surge current single sine-wave superimposed on rated load (JEDEC Method) If(av) 10.0 A Ifsm 220 A Maximum instantaneous forward voltage drop per leg at 5A Vf 1.0 V Rating for fusing (t < 8.3ms) I2t 200 A2Sec Ir 5.0 500 µA Maximum DC reverse current at rated DC blocking voltage per leg Ta = 25°C Ta = 125°C Typical junction capacitance per leg at 4V,1MHz Maximum thermal resistance per leg Operating junction and storage temperature range Cj (Note1) (Note2) 211 94 Rth(ja) Rth(jc) ℃/W Tj, Tstg -55 to +150 ℃ Note: 1. Unit mounted in free air no heat sink on P.C.B. 0.5 x 0.5” (12 x12 mm) copper pads, 0.375”(9.5mm) lead length 2. Device mounted on 4 x 6 x 0.25" Al-plate heatsink Rev.A1 pF 21 2.0 www.gulfsemi.com RATINGS AND CHARACTERISTIC CURVES GBU10A THRU GBU10M Rev.A1 www.gulfsemi.com