NES-50 50W Single Output Switching Power Supply series Features : Universal AC input/Full range Protections:Short circuit/Over load/Over voltage Cooling by free air convection 100% full load burn-in test 2 years warranty SPECIFICATION MODEL OUTPUT NES-50-5 NES-50-12 NES-50-15 NES-50-24 DC VOLTAGE 5V 12V 15V 24V 48V RATED CURRENT 10A 4.2A 3.4A 2.2A 1.1A CURRENT RANGE 0 ~ 10A 0 ~ 4.2A 0 ~ 3.4A 0 ~ 2.2A 0 ~ 1.1A RATED POWER 50W 50.4W 51W 52.8W 52.8W RIPPLE & NOISE (max.) Note.2 80mVp-p 120mVp-p 150mVp-p 200mVp-p 240mVp-p VOLTAGE ADJ. RANGE 10.8 ~ 13.2V 13.5 ~ 16.5V 21.6 ~ 26.4V 43.2 ~ 52.8V VOLTAGE TOLERANCE Note.3 INPUT 1.0% 0.5% 0.5% 0.5% 0.5% LOAD REGULATION Note.5 0.5% 0.5% 0.5% 0.5% 0.5% SETUP, RISE TIME 500ms, 30ms/230VAC HOLD TIME (Typ.) 50ms/230VAC VOLTAGE RANGE 85 ~ 264VAC FREQUENCY RANGE 47 ~ 63Hz EFFICIENCY(Typ.) 79% AC CURRENT (Typ.) INRUSH CURRENT (Typ.) 1.1A/115VAC 0.65A/230VAC COLD START 45A OVER VOLTAGE WORKING TEMP. WORKING HUMIDITY ENVIRONMENT STORAGE TEMP., HUMIDITY TEMP. COEFFICIENT VIBRATION SAFETY STANDARDS WITHSTAND VOLTAGE SAFETY & ISOLATION RESISTANCE 1200ms, 30ms/115VAC at full load 10ms/115VAC at full load 120 ~ 370VDC 82% 83% 86% 87% <2mA / 240VAC 110 ~ 150% rated output power Protection type : Hiccup mode, recovers automatically after fault condition is removed 5.75 ~ 6.75V 13.8 ~ 16.2V 17.25 ~ 20.25V 27.6 ~ 32.4V 55.2 ~ 64.8V Protection type : Shut down o/p voltage, re-power on to recover -20 ~ +60 (Refer to output load derating curve) 20 ~ 90% RH non-condensing -40 ~ +85 , 10 ~ 95% RH 0.03%/ (0 ~ 45 ) 10 ~ 500Hz, 2G 10min./1cycle, period for 60min. each along X, Y, Z axes UL60950-1, CB(IEC60950-1),GB4943 approved I/P-O/P:3KVAC I/P-FG:1.5KVAC O/P-FG:0.5KVAC I/P-O/P, I/P-FG, O/P-FG:100M Ohms/500VDC EMI CONDUCTION & RADIATION Compliance to EN55022 (CISPR22) Class B,GB9254 CLASS B HARMONIC CURRENT Compliance to EN61000-3-2,-3 EMS IMMUNITY Compliance to EN61000-4-2, 3, 4, 5, 6, 8,11, ENV50204, EN55024, EN61000-6-1 Light industry level, criteria A MTBF 374.2K hrs min. MIL-HDBK-217F (25 129*98*38mm (L*W*H) 0.41Kg; 30pcs/13.3Kg/0.72CUFT DIMENSION PACKING NOTE 1.0% 0.5% OVER LOAD OTHERS 1.0% Note.4 PROTECTION (Note 6) 1.0% LINE REGULATION LEAKAGE CURRENT EMC 4.75 ~ 5.5V 2.0% NES-50-48 ) 1. All parameters NOT specially mentioned are measured at 230VAC input, rated load and 25 of ambient temperature. 2. Ripple & noise are measured at 20MHz of bandwidth by using a 12" twisted pair-wire terminated with a 0.1uf & 47uf parallel capacitor. 3. Tolerance : includes set up tolerance, line regulation and load regulation. 4. Line regulation is measured from low line to high line at rated load. 5. Load regulation is measured from 0% to 100% rated load. 6. The power supply is considered a component which will be installed into a final equipment. The final equipment must be re-confirmed that it still meets EMC directives. For guidance on how to perform these EMC tests, please refer to EMI testing of component power supplies. (as available on http://www.meanwell.com) File Name:NES-50-SPEC 2011-01-28 NES-50 50W Single Output Switching Power Supply Mechanical Specification Case No. 903 series Unit:mm 31 3.5 7 122.5 9.5 1 2 2- M 3 33 85.5 8.2 4 98 3 5 +V ADJ. 3 .5 73.5 4.5 129 6.5 32 3 38 3.5 9.5 3-M 28.5 Assignment DC OUTPUT -V DC OUTPUT +V 18 Pin No. 4 5 18.5 Assignment AC/L AC/N FG 3.5 Pin No. 1 2 3 9 Terminal Pin. No Assignment 120 77 Block Diagram fosc : 60KHz RECTIFIERS & FILTER EMI FILTER I/P POWER SWITCHING RECTIFIERS & FILTER +V -V DETECTION CIRCUIT FG O.L.P. CONTROL O.V.P. Derating Curve Output Derating VS Input Voltage Ta=25 100 100 90 80 80 70 LOAD (%) LOAD (%) 60 40 20 -20 0 10 20 30 40 AMBIENT TEMPERATURE ( 50 ) 60 70 (HORIZONTAL) 60 50 40 85 95 100 115 120 140 160 180 200 220 240 264 INPUT VOLTAGE (VAC) 60Hz File Name:NES-50-SPEC 2011-01-28