M ICROWAVE A Division of Crystek Corporation PERFORMANCE SPECIFICATION 2X Fundamental MIN TYP Lower Frequency: Upper Frequency: MAX UNITS 5340 MHz 4.5 VDC 5490 MHz Tuning Voltage: 0.5 Supply Voltage: 4.75 5.0 5.25 VDC Output Power: +0.5 +3.0 +5.5 dBm Supply Current: 15 25 mA Harmonic, F*(0.5): -30 -20 dBc Harmonic, F*(1.5): -35 -25 dBc Harmonic, F*(2.0): -30 -20 dBc Pushing: 1.5 3.0 MHz/V Pulling, all Phases: 0.5 1.0 MHz pk-pk -99 dBc/Hz Tuning Sensitivity: 52 Phase Noise @ 10kHz offset: -102 Load Impedance: MHz/V 50 Input Capacitance: 10 pF Operating Temperature Range: -40 +85 °C Storage Temperature Range: -45 +90 °C Phase Noise (1 Hz BW, Typical) Tuning Curve (Typical) Page 1 of 2 CRYSTEK CORPORATION 12730 Commonwealth Drive • Fort Myers, Florida 33913 Phone: 239-561-3311 • 800-237-3061 Fax: 239-561-1025 • www.crystek.com M ICROWAVE A Division of Crystek Corporation 2X Fundamental SIDE VIEW BOTTOM VIEW Gold Finish 0.465 SQ (11.81 SQ) Solder Mask 0.220 (5.59) 0.030 (0.76) 0.100 (2.54) 0.052 (1.32) 0.180 0.280 0.380 12 11 10 9 0.500 (12.70) 0.415 13 0.315 14 0.215 15 0.115 16 0.000 1 0.000 TOP ORIENTATION MARK 8 0.405 7 0.305 6 0.205 5 0.105 Pad Connection 2 10 14 Others Vt RF-OUTPUT Vcc GROUND PAD LOCATION 2 3 4 0.415 CRYSTEK CVCO55CXT 5340-5490 YYWW 0.500 (12.70) 0.500 0.215 TOP VIEW 0.080 0.040 (1.02) 0.115 [Vt] 0.315 [Vcc] Unless otherwise specified, Dimensions are in: IN (mm) Pad Location Dimensions are in: Inches 0.500 [RF] TAPE AND REEL 0.059 Ø TYP (1.50 Ø) TYP 0.157±0.004 (4.00±0.10) 0.945±0.012 (24.00±0.30) DIRECTION OF FEED 0.630±0.004 (16.00±0.10) Drawing not to scale Product Control: Crystek Part Number: CVCO55CXT-5340-5490 Release Date: 17-Apr-08 Revision Level: A Responsible: C. Vales CRYSTEK CORPORATION Specification is subject to change without notice Page 2 of 2 12730 Commonwealth Drive • Fort Myers, Florida 33913 Phone: 239-561-3311 • 800-237-3061 Fax: 239-561-1025 • www.crystek.com