Shunye MP505 Press-fit motolola diode Datasheet

MP5005 THRU MP506
PRESS-FIT MOTOLOLA DIODES
特征
MP
FEATURES
.50安培工作温度为125度,无热损耗下.
50 Ampere Operation At TL=125℃ With No Thermal Runaway.
.正向压降低.Low forward voltage drop
.低漏电. Low leakage current
.高浪涌承受能力.High surge current capability
机械数据
MECHANICAL DATA
.封装:铜材质 MP封装. Case: Copper MP
.端子:镀金端子,焊接按照 MIL-STD-202,方法 208.
Terminals: Plated terminals, solderable per
MIL-STD-202, method 208.
.极性: 灌注红色环氧树脂(端子为正/P 型)
灌注黑色环氧树脂(端子为负/N 型)
Polarity : By RED Color Epoxy Potting. (Positive)
By BLACK Color Epoxy Potting. (Negative)
.重 量:6.8克.
Dimension in millimeters
Weight: 6.8grams
极限值和电参数 TA= 25℃除非另有规定. 单相,正半弦波,60HZ,阻抗或电感负载.为电容装载,减 少电流的 20%
MAXIMUM RATINGS AND ELECTRICAL CHARACTERISTICS
Rating at 25℃ Ambient temp. Unless otherwise specified.Single phase, half sine wave, 60HZ,resistive or inductive load.
For capacitive load, derate current by 20%
SYMBO
5005
L
501
MP
502
503
504
505
506
UNITS
最大峰值反向电压
Maximum Current Peak Reverse Voltage
VRRM
50
100
200
300
400
500
600
Volts
最大反向有效电压
Maximum RMS Voltage
VRMS
35
70
140
210
280
350
420
Volts
VDC
50
100
200
300
400
500
600
Volts
最大直流阻断电压
Maximum DC Blocking Voltage
最大正向平均整流电流 TL=125℃
Maximum Average Forward Rectified Current
正向峰值浪涌电流
Peak Forward Surge Current 8.3ms Single
Sine-wave on Rated Load (JEDEC Method)
50A 直流电时最大正向瞬间电压降
Maximum Instantaneous Forward Voltage
Drop at 50A DC
最大反向漏电流
Maximum DC Reverse Current TA=25℃
at Rated DC Blocking Voltage
TA=100℃
典型结电容
Typical Junction Capacitance (NOTE 1)
工作温度存储温度
Operating AND Storage Temperature Range
I(AV)
50
Amps
IFSM
500
Amps
VF
1.0
Volts
IR
5
500
uA
CJ
120
pF
TSTG/ TJ
-55 to +150
℃
NOTE: 1.Measured at 1 MHz and Applied Reverse Voltage of 4.0 Volts D.C.
www.shunyegroup.com.cn
RATING ANDCHARACTERISTIC CURVES MP5005 THRU MP506
FIG. 1 –最大正向平均电流降额
FIG. 1 –MAXIMUM AVERAGE FORWARD CURRENT
DERATING
FIG. 2 –最大非重复正向浪涌电流
FIG. 2 –MAXIMUM NON-REPETITIVE FORWARD
SURGE CURRENT
FIG. 3 –反向特性曲线(典型)
FIG. 3 – TYPICA REVERSE CHARACTERISTICS
FIG. 4–正向特性曲线(典型)
FIG.4 – TYPICA FORWARD CHARACTERISTICS
FIG.5–结电容特性曲线
FIG.5–TYPICAL JUNCTION CAPACITANCE
www.shunyegroup.com.cn
Similar pages