CW1 Counterweight for use on cable suspended float switches. Adjustable cable pivot point Cable lock feature Inert and non-hazardous in water This counterweight is used to set or adjust the pivot point for a cable suspended float switch. The position on the cable relative to the switch can be used to adjust the liquid level differential between open and closed switch output. Most of the cable suspended float switches from Cynergy3 are supplied with these counterweights but the LITTLE-EX series of ATEX approved switches are not. Installation of counterweight on cable Remove the locking cone from the top of the counterweight moulding, but DO NOT REMOVE THE LID OF THE COUNTERWEIGHT. Fit the locking cone onto the cable Feed the cable through the counterweight body until the locking cone reaches the counterweight. Push the locking cone into the base of the counterweight to lock the counterweight on the cable at the required position. Cable Remove Cone Cynergy3 Components Ltd. 7 Cobham Road Ferndown Industrial Estate Wimborne, Dorset BH21 7PE Telephone +44 (0) 1202 897969 Push up into body Fit to cable Email:[email protected] ISO9001 C E R T I F I E D www.cynergy3.com © 2012 Cynergy3 Components, All Rights Reserved. Specifications are subject to change without prior notice. Cynergy3 Components and the Cynergy3 Components logo are trademarks of Cynergy3 Components Limited.