MBR3035(45)CT MBRF3035(45)CT MBRB3035(45)CT Series Dual Schottky Barrier Rectifiers FEATURES Reverse voltage 35 to 45 V Forward current 3.0 A Plastic package has Underwriters Laboratory Flammability Classification 94V-0 Dual rectifier construction, positive center tap Metal silicon junction, majority carrier conduction Low power loss, high efficiency Guard ring for over voltage protection For use in low voltage, high frequency inverters, free wheeling, and polarity protection applications MECHANICAL DATA Case: JEDEC TO-220AB, ITO-220AB, TO263AB molded plastic body Terminals: Plated leads, solder-able per MILSTD-750, Method 2026 High temperature soldering guaranteed: 250oC/10 seconds, 0.25" (6.35mm) from case (TO-220AB, ITO-220AB) at terminals (TO236AB) Polarity: As marked Mounting Position: Any Mounting Torque: 10 in-lbs maximum Weight: 0.08 ounce, 2.24 grams PACKAGE DIMENSIONS TO-220AB 12/24/2006 Rev. 1.01 www.SiliconStandard.com 1 MBR3035(45)CT MBRF3035(45)CT MBRB3035(45)CT Series ITO-220AB Mounting Pad Layout TO-263AB TO-263AB(D2PAK) 12/24/2006 Rev. 1.01 www.SiliconStandard.com 2 MBR3035(45)CT MBRF3035(45)CT MBRB3035(45)CT Series ELECTRICAL CHARACTERISTICS AND MAXIMUM RATINGS Unless otherwise specified, these specifications apply over the operating ambient temperature of 25℃. Notes: 1. Clip mounting (on case), where lead does not overlap heat sink with 0.110" offset 2. Clip mounting (on case), where leads do overlap heat sink Screw mounting with 4-40 screw, where washer diameter is < 4.9 mm (0.19") 3. Pulse test: 300us pulse width, 1% duty cycle 12/24/2006 Rev. 1.01 www.SiliconStandard.com 3 MBR3035(45)CT MBRF3035(45)CT MBRB3035(45)CT Series RATINGS AND CHARACTERISTIC CURVES (TA = 25℃ unless otherwise specified) 12/24/2006 Rev. 1.01 www.SiliconStandard.com 4 MBR3035(45)CT MBRF3035(45)CT MBRB3035(45)CT Series Disclaimer Information furnished by Silicon Standard Corporation is believed to be accurate and reliable. However, Silicon Standard Corporation makes no guarantee or warranty, expressed or implied, as to the reliability, accuracy, timeliness or completeness of such information and assumes no responsibility for its use, or for infringement of any patent or other intellectual property rights of third parties that may result from its use. Silicon Standard reserves the right to make changes as it deems necessary to any products described herein for any reason, including without limitation enhancement in reliability, functionality or design. No license is granted, whether expressly or by implication, in relation to the use of any products described herein or to the use of any information provided herein, under any patent or other intellectual property rights of Silicon Standard Corporation or any third parties. 12/24/2006 Rev. 1.01 www.SiliconStandard.com 5