GP30N THRU GP30Y SINTERED GLASS JUNCTION PLASTIC RECTIFIER VOLTAGE:1100V to 1600V CURRENT: 3.0A FEATURE DO-201AD High temperature metallurgically bonded construction Sintered glass cavity free junction Capability of meeting environmental standard of MIL-S-19500 High temperature soldering guaranteed 350°C /10sec/0.375”lead length at 5 lbs tension Operate at Ta =55°C with no thermal run away Typical Ir<0.1µA MECHANICAL DATA Terminal:Plated axial leads solderable per MIL-STD 202E, method 208C Case:Molded with UL-94 Class V-0 recognized Flame Retardant Epoxy Polarity:color band denotes cathode Mounting position:any Dimensions in inches and (millimeters) MAXIMUM RATINGS AND ELECTRICAL CHARACTERISTICS (single-phase, half-wave, 60HZ, resistive or inductive load rating at 25°C, unless otherwise stated, for capacitive load, derate current by 20%) Maximum Recurrent Peak Reverse Voltage Maximum RMS Voltage Maximum DC blocking Voltage Maximum Average Forward Rectified Current 3/8”lead length at Ta =55°C Peak Forward Surge Current 8.3ms single Half sine-wave superimposed on rated load Maximum Instantaneous Forward Voltage at 3.0A Maximum full load reverse current full cycle Average at 55°C SYMBOL GP 30N GP 30Q GP 30T GP 30V GP 30W GP 30Y units Vrrm Vrms Vdc 1100 770 1100 1200 840 1200 1300 910 1300 1400 980 1400 1500 1050 1500 1600 1120 1600 V V V If(av) 3.0 A Ifsm 125.0 A Vf 1.2 V Ir(av) 100.0 µA Ir 5.0 100.0 Maximum DC Reverse Current Ta =25°C at rated DC blocking voltage Ta =150°C Typical Reverse Recovery Time (Note 1) Trr 3.0 µA µA µS Typical Junction Capacitance Cj 40.0 pF R(ja) 20.0 Tstg, Tj -65 to +175 °C /W °C Typical Thermal Resistance (Note 2) (Note 3) Storage and Operating Junction Temperature Note: 1. Reverse Recovery Condition If =0.5A, Ir =1.0A, Irr =0.25A 2. Measured at 1.0 MHz and applied reverse voltage of 4.0Vdc 3. Thermal Resistance from Junction to Ambient at 3/8”lead length, P.C. Board Mounted Rev.A1 www.gulfsemi.com RATINGS AND CHARACTERISTIC CURVES GP30N THRU GP30Y 1 Rev.A1 www.gulfsemi.com