RoHS LRC10 Low Resistance Chip Inductors 0.126±0.012 (3.20±0.30) Dimensions: 0.071±0.008 (1.80±0.20) 0.063±0.008 (1.60±0.20) Inches (mm) 0.126±0.012 (3.20±0.30) 0.090±0.008 (2.29±0.20) 0.059 (1.50) 0.063±0.008 (1.60±0.20) 0.069 (1.75) 0.039 (0.99) Features • Miniature SMT wire-wound open magnetic path construction inductors with low DCR, high current capacity Allied Part Number Inductance (µh) Tolerance (%) Test Freq. (MHz) SRF Min. (MHz) DCR Max. (Ω) Rated Current (mA) LRC10-R12M-RC .12 20 1 250 .12 970 LRC10-R22M-RC .22 20 1 250 .15 850 LRC10-R47M-RC .47 20 1 180 .22 700 LRC10-1R0M-RC 1.0 20 1 100 .38 510 LRC10-2R2M-RC 2.2 20 1 50 .55 430 LRC10-4R7M-RC 4.7 20 1 31 .85 340 LRC10-100K-RC 10 10 1 20 1.8 230 LRC10-220K-RC 22 10 1 14 4.0 160 LRC10-470K-RC 47 10 1 10 10.5 100 LRC10-101K-RC 100 10 1 7 16.0 80 and high impedance characteristics. • Excellent solder heat resistance for flow and reflow soldering methods. • Excellent for use as choke coils in DC/DC converter and DC power supply circuits. Electrical Inductance Range: .12µh to 100µh. Tolerance: For 20% use M, 10% use K and 5% use J as part number suffix. Test Frequency: Inductance measured at 1MHz on HP4192A. Operating Temp. Range: i-25° to +85°C.ll Rated Current: Based on Temperature rise not to exceed 35ºC. Inductance Drop 10% typical. Resistance to Soldering Heat: Pre heat: 150ºC ± 10ºC / 1-2 min. Solder temp: 260ºC ± 5ºC for 10 sec. ± 1 sec. Physical Packaging: 2000 pieces per 7 inch reel. 7500 pieces per 13 inch reel. Available in tighter tolerances. All specifications subject to change without notice. 714-665-1140 ALLIED COMPONENTS INTERNATIONAL Revised 03-25-08 www.alliedcomponents.com