FHC6 SERIES The FHC6 series of active hybrid filters have been designed for oversampled NTSC, PAL or 601 pre and post applications. All FHC6 filters have the same tightly specified passband, transition and stopband characteristics and provide access for DC offset control. Sinx/x correction (if required) and gain are accurately set at the factory to the customer's requirements. The modules have high input and low output impedance and can drive 75Ω terminated loads. BASIC SPECIFICATION Input Impedance Output Impedance Passband Passband Amplitude Ripple Start of Stopband Stopband rejection Insertion Delay at 200 kHz Group Delay Ripple 2.0 MΩ typical < 1Ω (op-amp driver output) 6.0 MHz ± 0.05 dB 21.0 MHz 45 dB min 45 ns nominal 12 ns max to 6.0 MHz 2.5 ns max to 3.58 MHz ± 5V 8 mA per rail at ± 5V supply 0.1% 0.1° Yes DR00185A Power supply Typical Current Differential Gain Differential Phase Aqueous Washable Package OPTIONS FHC6-AA FHC6-BA FHC6-CA FHC6-DA FHC6-EA FHC6-FA Passband shape sinx/x sinx/x sinx/x sinx/x flat flat Sampling frequency 27.0 MHz 27.0 MHz 28.6 MHz 28.6 MHz - - Gain (± 0.1 dB) 0 dB 6 dB 0 dB 6 dB 0 dB 6 dB Note: if your requirement is not covered by the above options just let us know and we will customise a filter design to your individual specifications. © Faraday Technology. As part of continual product improvement the specifications, details and dimensions shown in this publication are subject to change without notice FARA093d Page 1 of 2 Jan-00(B) PACKAGE DETAIL Faraday Technology Ltd. Croft Road Industrial Estate, Newcastle, Staffordshire ST5 0QZ. England. FARA093d Tel: Fax: Email: Web site: Page 2 of 2 + 44 (0)1782 661501 + 44 (0)1782 630101 [email protected] http://www.faradaytech.co.uk Jan-00(B)