UNISONIC TECHNOLOGIES CO., LTD MMDT2227 Preliminary DUAL TRANSISTOR NPN & PNP GENERAL PURPOSE AMPLIFIER DESCRIPTION The UTC MMDT2227 is an NPN & PNP general purpose amplifier. it’s suitable for a medium power amplifier and switch requiring collector currents up to 500mA. FEATURES * Low VCE(SAT), VCE(SAT)=0.4V (typ.)@IC /IB=150mA/15mA, VCE(SAT)=1.4V (typ.) @IC/IB = 300mA/30mA * High collector current gain under high collector current condition EQUIVALENT CIRCUIT ORDERING INFORMATION Ordering Number Lead Free Halogen Free MMDT2227L-AL6-R MMDT2227G-AL6-R Package SOT-363 1 E1 Pin Assignment 2 3 4 5 B1 C2 E2 B2 6 C1 Packing Tape Reel MARKING www.unisonic.com.tw Copyright © 2011 Unisonic Technologies Co., Ltd 1 of 3 QW-R218-019.a MMDT2227 Preliminary DUAL TRANSISTOR ABSOLUTE MAXIMUM RATINGS* (TA=25°C , unless otherwise specified)(Note 2) PARAMETER SYMBOL RATINGS TR1 30 60 5.0 500 UNIT TR2 -30 -60 -5.0 -500 Collector-Emitter Voltage VCEO V Collector-Base Voltage VCBO V Emitter-Base Voltage VEBO V Collector Current - Continuous IC mA Total Device Dissipation 300 mW PD Derate above 25°C 2.4 mW/°C Junction Temperature TJ +150 °C Storage Temperature TSTG -55 ~ +150 °C Notes: 1. Absolute maximum ratings are those values beyond which the device could be permanently damaged. 1. Absolute maximum ratings are stress ratings only and functional device operation is not implied. 2. These ratings are limiting values above which the serviceability of any semiconductor device may be impaired. THERMAL DATA PARAMETER Junction to Case SYMBOL θJC RATINGS 415 UNIT °С/W ELECTRICAL CHARACTERISTICS (TA =25°C unless otherwise specified) TR1 PARAMETER OFF CHARACTERISTICS Collector-Emitter Breakdown Voltage Collector-Base Breakdown Voltage Emitter-Base Breakdown Voltage Collector Cutoff Current Emitter Cutoff Current ON CHARACTERISTICS DC Current Gain SYMBOL V(BR)CEO V(BR)CBO V(BR)EBO ICBO IEBO hFE Collector-Emitter Saturation Voltage (Note) VCE(SAT) Base-Emitter Saturation Voltage (Note) SMALL SIGNAL CHARACTERISTICS Current Gain - Bandwidth Product Output Capacitance Input Capacitance VBE(SAT) fT COBO CIBO TEST CONDITIONS IC=10mA, IB=0 (Note) IC=10 µA, IE=0 IE=10µA, IC=0 VCB= 50V, IE=0 VEB=3.0V, IC=0 30 60 5.0 IC=1.0mA, VCE=10V IC=10mA, VCE=10V IC=150mA, VCE= 1 V (Note) IC=300mA, VCE=10V (Note) IC=150mA, IB=15mA IC=300mA, IB=30mA IC=150mA, IB=15mA 50 75 100 30 IC= 50mA, VCE=20V, f =100MHz VCB=10 V, IE=0, f=100 kHz VEB=2.0V, IC=0, f=100 kHz IC=100µA, VCE=10V, Noise Figure NF RS=1.0kΩ, f =1.0kHz Note: Pulse Test: Pulse Width ≤ 300μs, Duty Cycle ≤ 2.0% UNISONIC TECHNOLOGIES CO., LTD www.unisonic.com.tw MIN TYP MAX UNIT 30 30 V V V nA nA 0.4 1.4 1.3 V V V 250 4.0 12 MHz pF pF 2.0 dB 2 of 3 QW-R218-019.a MMDT2227 Preliminary DUAL TRANSISTOR ELECTRICAL CHARACTERISTICS (TA =25°C unless otherwise specified) TR2 PARAMETER OFF CHARACTERISTICS Collector-Emitter Breakdown Voltage Collector-Base Breakdown Voltage Emitter-Base Breakdown Voltage Collector Cutoff Current Emitter Cutoff Current ON CHARACTERISTICS DC Current Gain SYMBOL V(BR)CEO V(BR)CBO V(BR)EBO ICBO IEBO hFE Collector-Emitter Saturation Voltage (Note) VCE(SAT) Base-Emitter Saturation Voltage (Note) SMALL SIGNAL CHARACTERISTICS Current Gain - Bandwidth Product Output Capacitance Input Capacitance VBE(SAT) fT COBO CIBO TEST CONDITIONS MIN TYP MAX UNIT IC=-10mA, IB=0 (Note) IC=-10 µA, IE=0 IE=-10µA, IC=0 VCB= -50V, IE=0 VEB=-3.0V, IC=0 -30 -60 -5.0 IC=-1.0mA, VCE=-10V IC=-10mA, VCE=-10V IC=-150mA, VCE= -1V (Note) IC=-300mA, VCE=-10V (Note) IC=-150mA, IB=-15mA IC=-300mA, IB=-30mA IC=-150mA, IB=-15mA -50 -75 -100 -30 IC= -50mA,VCE=-20V,f =100MHz VCB=-10V, IE=0, f=100 kHz VEB=-2.0V, IC=0, f=100 kHz IC=-100µA, VCE=-10V, Noise Figure NF RS=-1.0kΩ, f =1.0kHz Note: Pulse Test: Pulse Width ≤ 300μs, Duty Cycle ≤ 2.0% -30 -30 V V V nA nA -0.4 -1.4 -1.3 V V V 250 4.0 12 MHz pF pF 2.0 dB UTC assumes no responsibility for equipment failures that result from using products at values that exceed, even momentarily, rated values (such as maximum ratings, operating condition ranges, or other parameters) listed in products specifications of any and all UTC products described or contained herein. UTC products are not designed for use in life support appliances, devices or systems where malfunction of these products can be reasonably expected to result in personal injury. Reproduction in whole or in part is prohibited without the prior written consent of the copyright owner. The information presented in this document does not form part of any quotation or contract, is believed to be accurate and reliable and may be changed without notice. UNISONIC TECHNOLOGIES CO., LTD www.unisonic.com.tw 3 of 3 QW-R218-019.a