BH1415F Audio ICs Wireless Audio Link IC BH1415F The BH1415F is a FM stereo transmitter IC that transmits simple configuration. The IC consists of a stereo modulator for generating stereo composite signals and a FM transmitter for broadcasting a FM signal on the air. The stereo modulator generates a composite signal which consists of the MAIN, SUB, and pilot signal from a 38kHz oscillator. The FM transmitter radiates FM wave on the air by modulating the carrier signal with a composite signal. !Applications CD changer, Car TV, Car navigation, Wireless speakers, Personal computer (sound board), Game machine !Features 1) It is possible to improve the timbre because it has the pre-emphasis circuit, limiter circuit, and the low-pass filter circuit. 2) Built-in pilot-tone system FM stereo modulator circuit. 3) The transmission frequency is stable because it has a PLL system FM transmitter circuit. 4) PLL data input (CE, CK, DA) by serial input. !Absolute maximum ratings (Ta = 25°C, In measurement circuit.) Parameter Supply voltage Data input voltage Phase comparator output voltage Power dissipation Storage temperature Symbol Limits Unit VCC +7.0 V Pin8,12 VIN-D −0.3 to VCC+0.3 V Pin15,16,17,18 VOUT-P −0.3 to VCC+0.3 V Pin7 ∗ Pd 450 Tstg −55 to +125 Conditions mW °C ∗ Derating : 4.5mW/°C for operation above Ta=25°C. !Recommended operating conditions (Ta = 25°C) Symbol Min. Typ. Max. Unit Operating supply voltage VCC 4.0 − 6.0 V Operating temperature Topr −40 − +85 °C Audio input level VIN-A − − −10 dBV Pin1,22 Audio input frequency band fIN-A 20 − 15k Hz Pin1,22 Pre-emphasis time constant set up range Parameter Conditions Pin8,12 t PRE − − 155 µsec Pin2,21 Transmission frequency fTX 70 − 120 MHz Pin9,11 Control terminal "H" level input voltage VIH 0.8VCC − VCC V Pin15,16,17,18 Control terminal "L" level input voltage VIL GND − 0.2VCC V Pin15,16,17,18 1/3 1 2 3 4 5 6 7 8 9 10 11 R-ch INPUT PRE-EMPHASIS TIME CONSTANT LPF TIME CONSTANT FILTER COMPOSITE SIGNAL OUTPUT GND PLL PHASE DETECTOR OUTPUT VCC RF OSCILLATOR RF GND RF OUTPUT PRE-EMPHASIS TIME CONSTANT LPF TIME CONSTANT PILOT SIGNAL ADJUST AUDIO MUTING DATA CLOCK CHIP ENABLE X'tal OSCILLATOR X'tal OSCILLATOR 22 21 20 19 18 17 16 15 14 13 Pre-emphasis and Limiter + − MPX VCC 2 1 50 + LPF 1 2 Phase detector + OSC GND VCC PLL VCC L-ch INPUT BH1415F Audio ICs !Block diagram PLL VCC 12 − LPF Shift register MUTE 1 4 1 19 Program counter RF RF GND 2/3 BH1415F Audio ICs No. Control unit / Data (2) Contents • It changes a stereo and monaural operation. MULTIPLEXER MONO MONO PD0, PD1 Monaural operation L+R , Pilot OFF 1 Stereo operation ωs L+R+(L-R),sinωst+Psin 2 t Charge pump output PD0 PD1 0 0 Usual operation 0 1 Compulsion by Low 1 0 Compulsion by High 1 1 High impedance • It is data for the LSI test. TEST MODE (3) 0 • It controls charge pump output by the phase comparator compulsorily. PHASE DETECTOR (2) Condition of the composite signal • Always in T0 Input "1". T0, T1 • Always in T1 Input "0". !External dimensions (Units : mm) 13.6 ± 0.2 5.4 ± 0.2 0.15 ± 0.1 1.8 ± 0.1 12 1 0.11 7.8 ± 0.3 22 11 1.27 0.4 ± 0.1 0.3Min. 0.15 SOP22 3/3 Appendix Notes No technical content pages of this document may be reproduced in any form or transmitted by any means without prior permission of ROHM CO.,LTD. The contents described herein are subject to change without notice. The specifications for the product described in this document are for reference only. Upon actual use, therefore, please request that specifications to be separately delivered. Application circuit diagrams and circuit constants contained herein are shown as examples of standard use and operation. Please pay careful attention to the peripheral conditions when designing circuits and deciding upon circuit constants in the set. Any data, including, but not limited to application circuit diagrams information, described herein are intended only as illustrations of such devices and not as the specifications for such devices. ROHM CO.,LTD. disclaims any warranty that any use of such devices shall be free from infringement of any third party's intellectual property rights or other proprietary rights, and further, assumes no liability of whatsoever nature in the event of any such infringement, or arising from or connected with or related to the use of such devices. Upon the sale of any such devices, other than for buyer's right to use such devices itself, resell or otherwise dispose of the same, no express or implied right or license to practice or commercially exploit any intellectual property rights or other proprietary rights owned or controlled by ROHM CO., LTD. is granted to any such buyer. Products listed in this document use silicon as a basic material. Products listed in this document are no antiradiation design. The products listed in this document are designed to be used with ordinary electronic equipment or devices (such as audio visual equipment, office-automation equipment, communications devices, electrical appliances and electronic toys). Should you intend to use these products with equipment or devices which require an extremely high level of reliability and the malfunction of with would directly endanger human life (such as medical instruments, transportation equipment, aerospace machinery, nuclear-reactor controllers, fuel controllers and other safety devices), please be sure to consult with our sales representative in advance. About Export Control Order in Japan Products described herein are the objects of controlled goods in Annex 1 (Item 16) of Export Trade Control Order in Japan. In case of export from Japan, please confirm if it applies to "objective" criteria or an "informed" (by MITI clause) on the basis of "catch all controls for Non-Proliferation of Weapons of Mass Destruction. Appendix1-Rev1.0