OptoSupply OSXXXDE5E1E VER.C.2 Xeon power white led Datasheet

Xeon 5 Power White LED
OSXXXDE5E1E
VER C.2
3.6
■ Features
●
Highest Luminous Flux
●
Super Energy Efficiency
●
Long Lifetime Operation
●
Superior ESD protection
●
Superior UV Resistance
BackView
■ Applications
●
Read lights (car, bus, aircraft)
●
Portable (flashlight, bicycle)
●
Bollards / Security / Garden
●
Traffic signaling / Beacons
●
In door / Out door Commercial lights
●
ESD Protection Diode
Unit:mm
Tolerance:±0.30mm
Automotive Ext
■ Absolute
(Ta=25℃)
Maximum Rating
Item
Symbol
■Directivity
Value
White/ Warm white
Unit
DC Forward Current
IF
1600
mA
Pulse Forward Current*
IFP
2000
mA
Reverse Voltage
VR
5
V
Power Dissipation
PD
7200
mW
Operating Temperature
Topr
-30 ~ +85
℃
Storage Temperature
Tstg
-40~ +100
℃
Lead Soldering Temperature
Tsol
260℃/5sec
℃
*Pulse width Max.10ms
■ Electrical
Cathode
Anode
0
0
Duty ratio max 1/10
(Ta=25℃)
VF (V)
-Optical Characteristics
Part Number
Color
OSW4XDE5E1E
Pure White
W4
OSM5XDE5E1E
Warm White
M5
IR(µA)
Min. Typ. Max.
Max.
IF=1400mA
VR=5V
3.3
3.3
3.5
3.5
4.5
10
4.5
10
CCT
(K)
Typ
λD(nm)
Luminous Flux
Φv (lm)
Min. Typ.
(deg)
Max.
Min. Typ. Max.
IF=1400mA
6500
300
320
-
X=0.31 ,Y=0.33
3000
280
300
-
X=0.44,Y=0.41
Note: Don’t drive at rated current more than 5s without heat sink for Xeon 5 emitter series.
LED & Application Technologies
http://www.optosupply.com
2θ1/2
VER A.0
140
Xeon 5 Power White LED
OSXXXDE5E1E
VER C.1
■ Handling of Silicone Lens LEDs
Notes for handling of silicone lens LEDs
● Please do not use a force of over 3kgf impact or pressure on the silicone lens, otherwise it will cause a catastrophic
failure.
● The LEDs should only be picked up by making contact with the sides of the LED body.
● Avoid touching the silicone lens especially by sharp tools such as Tweezers.
● Avoid leaving fingerprints on the silicone lens.
● Please store the LEDs away from dusty areas or seal the product against dust.
● When populating boards in SMT production, there are basically no restrictions regarding the form of the pick and
place nozzle, except that mechanical pressure on the silicone lens must be prevented.
● Please do not mold over the silicone lens with another resin. (epoxy, urethane, etc)
LED & Application Technologies
http://www.optosupply.com
VER A.0
Similar pages