FR201 G TH R U FR207 G R GLASS PASSIVATED FAST RECOVERY RECTIFIER Reverse Voltage: 50 to 1000 Volts Forward Current:2.0Amperes S E M I C O N D U C T O R FEATURES DO-15 Low leakage Low forward voltage drop High current capability High current surge High reliability 1.0(25.4) MIN 0.144(3.6) 0.104(2.6) DIA High temperature soldering guaranteed:260°C/10 seconds at terminals Component in accordance to RoHS 2011/65/EU 0.300(7.60) 0.230(5.60) MECHANICAL DATA Case: JEDEC DO-15 molded plastic body Terminals: Plated axial leads, solderable per MIL-STD-750,Method 2026 1.0(25.4) MIN Polarity: Color band denotes cathode end 0.034(0.85) 0.024(0.62) DIA Mounting Position: Any Weight: 0.014ounce, 0.39 gram Dimensions in inches and (millimeters) MAXIMUM RATINGS AND ELECTRICAL CHARACTERISTICS (Rating at 25°C ambient temperature unless otherwise specified.Single phase ,half wave ,60HZ,resistive or inductive load. For capacitive load,derate current by 20%.) Symbols Maximum Recurrent Peak Reverse Voltage Maximum RMS Voltage Maximum DC Blocking Voltage VRRM VRMS VDC FR 201G FR 202G FR 203G FR 204G FR 205G FR 206G FR 207G 50 100 200 400 600 800 1000 35 70 140 280 420 560 700 50 100 200 400 600 800 1000 Units Volts Volts Volts Maximum Average Forward Rectified Current I(AV) 2.0 Peak Forward Surge Current 8.3ms single half sine-wave superimposed on rated load (JEDEC method) IFSM 60 Amps VF 1.3 Volts Maximum Instantaneous Forward Voltage at 2.0 A Maximum DC Reverse Current at rated DC blocking voltage TA=25°C 5.0 Maximum reverse recovery time(Note1) Typical junction capacitance(Note2) Operating junction and storage temperature range μA IR TA=100°C Amps 100 trr CJ 150 250 30 TJ TSTG -55 to+150 -55 to+150 500 ns pF °C Note: 1.Test conditions: IF=0.5A,IR=1.0A,IRR=0.25A. 2.Measured at 1MHZ and applied reverse voltage of 4.0 Volts D.C. JINAN JINGHENG ELECTRONICS CO., LTD. 2-1 HTTP://WWW.JINGHENGGROUP.COM RATINGS AND CHARACTERISTIC CURVES FR201G THRU FR207G FIG.2-MAXIMUM NON-REPETITIVE FORWARD SURGE CURRENT 2.5 2.0 SINGIE PHASE HAIF WAVE 60HZ RESISTIVE OR INDUCTIVE LOAD 105 1.5 PEAK FORWARD SURGE CURRENT(AMPERES) AVERAGE FORWARD CURRENT (A) FIG.1-TYPICAL FORWARD CURRENT DERATING CURVE 1.0 0.5 0 0 25 50 75 100 125 150 175 AMBIENT TEMPERATURE (°C) FIG.3-TYPICAL INSTANTANEOUS FORWARD CHARACTERISTICS 90 8.3ms SINGLE HALF SINE-WAVE (JEDEC Method) 75 60 45 30 15 1 2 4 6 8 10 20 40 60 100 NUMBER OF CYCLES AT 60Hz 10 FIG.4-TYPICAL JUNCTION CAPACITANCE 3 1 JUNCTION CAPACITANCE(pF) INSTANTANEOUS FORWARD CURRENT( AMPERES) 0 20 0.3 0.1 TJ=25°C Pulse Width=300μs 1% Duty Cycle 0.03 0.01 0.4 0.6 0.8 1.0 1.2 1.4 1.6 1.8 200 100 60 40 20 10 INSTANTANEOUS FORWARD VOLTAGE (VOLTS) TJ=25°C 6 4 2 1 0.1 0.2 0.4 1 2 4 10 20 40 REVERSE VOLTAGE. (V) FIG.5-TEST CIRCUIT DIAGRAM AND REVERSE RECOVERY TIME CHARACTERISTIC 10Ω 50Ω NONINDUCTIVE D.U.T. (+) trr NONINDUCTIVE +0.5A PULSE GENERATOR (NOTE2) 50Vdc 0 -0.25A (ADJUSTABLE) (-) 1Ω NONINDUCTIVE OSCILLOSCOPE (NOTE1) TJ TSTG NOTES:1.Rise Time=7ns max. input lmpedance=1 megohm 22pF 2.Rise Time=10ns max. source lmpedance= 50 ohms JINAN JINGHENG ELECTRONICS CO., LTD. -1.0A 1cm SET TIME BASE FOR 50/100 ns/cm 2-2 HTTP://WWW.JINGHENGGROUP.COM 100