ETC1 LL1517 Audio output transformer Datasheet

Tibeliusgatan 7
S-761 50 NORRTÄLJE
SWEDEN
Phone
Fax
International
+46 - 176 13930
+46 - 176 13935
Domestic
0176-13930
0176-13935
Audio Output Transformer
LL1517
LL1517 is an audio output transformer for balanced or unbalanced drive. The transformer is built from two threesection coils, with primaries and secondaries separated by electrostatic shields, and a audio C-core of our own
production. The transformer is housed in a mu-metal housing.
The LL1517 has sufficient low copper resistance to meet broadcast specifications in a conventional drive
configuration, but is (as all output transformers) ideally used with mixed feedback drive circuits. (See separate
paper for mixed feedback design principles).
Turns ratio:
Dims (Length x Width x Height above PCB (mm)):
Pin layout (viewed from component side) and winding schematics:
6
12
5
11
4
3
LL1517
(top view)
1
8
1
7
7
2
9
2
1+1:1+1
47 x 34 x 18
3
8
6
12
5
4
11
9
Spacing between pins:
Spacing between rows of pins:
Weight:
Core:
Housing:
Rec. PCB hole diameter:
Static resistance of each primary:
Static resistance of each secondary:
Leakage inductance of secondaries (sec. in series):
No-load impedance:
Optimum source impedance:
Balance of output (according to IRT, source < 10 Ω , Load 600 Ω):
Maximum output level before saturation (sec. in series, load 600 Ω)
Distortion (achieved with mixed feedback drive circuit, load 600 Ω)
Frequency response (source 10 Ω, load 600 Ω):
Loss across transformer (at midband with 600 Ω load):
Isolation between primary and secondary windings / between
windings and core:
Suggested use
6
4 kV / 2 kV
12
11
5
4
5.08 mm (0.2")
35.56 mm (1.4")
105 g
Audio C-core
Mu-metal
1.5 mm
9.2 Ω
9.5 Ω
0.3 mH
>1kΩ @ 50 Hz, +20 dBU
Minus 18 Ω (See above)
> 60 dB
+ 24 dBU @ 30 Hz
< 0.03 % @ 20 dBU, 30Hz
10 Hz -- 80 kHz +/- 0.3 dB
0.3 dB
LL1517
3
9
2
8
1
7
R980616