FAST RECOVER RECTIFIER VOLTAGE RANGE CURRENT FR601 THRU FR607 50 to 1000 Volts 6.0Ampere R-6 FEATURES • • • • • .052(1.3) .048(1.2) Low coat construction Fast switching for high efficency. Low reverse leakage High forward surge current capability High temperature soldering guaranteed: 260℃/10 secods/.375”(9.5mm)lead length at 5 lbs(2.3kg) tension DIA. 1.0(25.4) MIN. .360(9.1) .340(8.6) .360(9.1) .340(8.6) MECHANICAL DATA • • • • • • DIA. 1.0(25.4) MIN. Case: Transfer molded plastic Epoxy: UL94V-O rate flame retardant Polarity: Color band denotes cathode end Lead: Plated axial lead, solderable per MIL-STD-202E method 208C Mounting position: Any Weight: 0.042ounce, 1.19 grams Dimensions in inches and (millimeters) MAXIMUM RATINGS AND ELECTRICAL CHARACTERISTICS • • • Ratings at 25OC ambient temperature unless otherwise specified Single Phase, half wave, 60Hz, resistive or inductive load For capacitive load derate current by 20% SYMBOLS VRRM VRMS VDC Maximum Repetitive Peak Reverse Voltage Maximum RMS Voltage Maximum DC Blocking Voltage Maximum Average Forward Rectified Current 0.375”(9.5mm) lead length at T A= 75℃ Peak Forward Surge Current 8.3mS single half sine wave superimposed on rated load (JEDEC method) Maximum Instantaneous Forward Voltage @ 6.0A Maximum DC Reverse Current at Rated DC Blocking Voltage TA = 25℃ TA = 100℃ Maximum Reverse Recovery Time (Note 3) T J=25℃ Typical Junction Capacitance (Note 1) FR 601 50 35 50 FR 602 100 70 100 FR 603 200 140 200 FR 604 400 280 400 FR 605 600 420 600 FR 606 800 560 800 FR 607 1000 700 1000 UNITS Volts Volts Volts I(AV) 6.0 Amp IFSM 300 Amps VF 1.3 10 500 Volts IR trr CJ 150 µA 250 500 150 ns pF Typical Thermal Resistance (Note 2) RθJA 10 ℃/W Operating Junction Temperature Range TJ TSTG (-55 to +150) (-55 to +150) ℃ Storage Temperature Range Notes: 1.Measured at 1.0MHz and Applied Reverse Voltage of 4.0Volits. 2 Thermal Resistance from junction to Ambient at .375”(9.5mm)lead length, P.C.board mounted. 3.Reverse Recovery Test Conditions:If=0.5mA,Ir=1.0mA,Irr=0.25A E-mail: [email protected] Web Site: www.cnmic.com ℃ FAST RECOVER RECTIFIER VOLTAGE RANGE CURRENT FR601 THRU FR607 50 to 1000 Volts 6.0Ampere RATING AND CHRACTERISTIC CURVES FR601 THRU FR607 FIG.2-MAXIMUM NON-REPETITIVE PEAK FORWARD SURGE CURRENT FIG.1-TYPICAL FORWARD CURRENT DERATING CURVE 8.3ms Single Half Sine-Wave (JEDEC Method) Tj=Tjmax 4.0 2.0 Single Phase Half Wave 60Hz Resistive or Inductive Load 0.375"(9.5mm)Lead Length 200 CURRENT, (A) PEAK FORWARD SURGE 300 (A) AVERAGE FORWARD CURRENT, 6.0 100 1 Cycle 0 0 50 25 100 75 150 125 0 175 2 1 AMBIENT TEMPERATURE, (° C) 6 4 8 10 40 20 60 80 100 NUMBER OF CYCLES AT 60 Hz FIG.3-TYPICAL INSTANTANEOUS FORWARD CHARACTERISTICS FIG.4-TYPICAL REVERSE CHARACTERISTICS 1000 10 INSTANTANEOUS REVERSE CURRENT, (uA) T j =100° C (A) INSTANTANEOUS FORWARD CURRENT, 20 100 10 Tj =25° C Pulse Width=300us 1% Duty Cycle 1.0 0.1 0.6 0.8 1.0 1.2 1.4 1.6 1.8 1.0 0.1 T j=25° C 0.01 0 2.0 40 20 60 80 100 120 140 PERCENT OF RATED PEAK INSTANTANEOUS FORWARD VOLTAGE,(V) REVERSE VOLTAGE,(%) FIG.5-TYPICAL JUNCTION CAPACITANCE FIG.6-TYPICAL THERMAL RESISTANCE VS LEAD LENGTH 1000 (°C/W) 100 60 50 40 RθJL THERMAL RESISTANCE, JUNCTION CAPACITANCE,(pF) 70 Single Lead to heat Sinl Insignificant Heat Flow Throrgh Other Lead 30 20 TJ=25° C F=1MHz Vsig=50mVp-p 10 Both Leads to Heat Sinl, Equal Length 10 0.1 1.0 10 100 0 0 REVERSE VOLTAGE,(V) E-mail: [email protected] 0.2 0.4 0.6 0.8 EQUAL LEAD LENGTH TO HEAT SINK(IN) Web Site: www.cnmic.com 1.0