GW42 series VCXO [ Voltage Controlled Crystal Oscillators ] 3.3 V SMD CMOS output 11.4 x 9.6 x 2.5 mm Phase Jitter < 4.3 ps [ 200.1 ~ 800.0 MHz ] Applications : ● high-Q fundamental crystals and multiplier circuits with moderate jitter. General Specifications Paramenters Electrical Spec. Input Voltage ( V DD) 3.3 V ± 5 % Frequency Range 200.1 ~ 800.0 MHz Output Wave Form CMOS output Initial Freq. Accuracy ( at 25 °C ) To tune to the nomial frequency with Vc = 1.65V ± 0.15V Output Logic High " 1 " 90% VDD ( min. ) Output Logic Low " 0 " 10% VDD ( max. ) Frequency Deviation Range Standard : ± 80 ppm ( min. ) Control Voltage Center / Control Voltage Range 1.65 VDC / 0.3 V to 3.0 V Integrated Phase Jitter ( 12 KHz to 20 MHz ) . 2.6 ps ( typical ) ; 4.0 ps ( max.) for 155.520 MHz Output Load 15 pF Rise Time ( Tr ) / Fall Time ( Tf ) 2.4 nSec. ( typical ) . Measured between 0.3V to 3.0V ( 15pF load ) Duty Cycle 50% ± 10% [ 50% ± 5% is also available ] Current Consumption 200 ~ 800 MHz : 50 mA ( max.) Start - Up Time (Ts) 10 m sec. ( max.) ; 5 m sec.( typical ) Input Impedance 2 MΩ ( min.) Storage Temperature - 50°C to 100°C Aging ± 3 ppm per year (max.) Frequency Stability over Operating Temperature Range Frequency Stability (1) Codes ± 25 ppm ± 50 ppm ± 100 ppm Commercial ( -10°C to +70°C ) A B C Industrial ( -40°C to +85°C ) D E F Phase Noise ( typical ) [ 155.520 MHz ] General Specifications Offset dBc / Hz 10 Hz 100 Hz -65 -95 If non-standard , please enter the desired stability after the " C " or " I " For example : " C20 " ±20 ppm over -10°C to +70°C ; " I20 " ± 20 ppm over -40°C to +85°C 1K Hz 10 KHz 100KHz 1 MHz 10 MHz -120 -125 -121 -125 -140 ( Unit : mm ) Mercury www .mercury-crystal.com ■Taiwan : (886)-2-2406-2779 / [email protected] ■U.S.A: (1)-909-466-0427 / [email protected] ■China : (86)-512-5763-8100 / [email protected]