FB FBR HIGH VOLTAGE, HIGH CURENT, STANDARD & FAST RECOVERY, SILICON RECTIFIER DIODES Up to 250 nanosec. max recovery Exceptionally low leakage Avalanche characteristics EDI T YPE # PRV VOLTS REVERSE RECOVERY TIME FB4 4,000 Not Applicable FB5 FBR3 5,000 3,000 Not Applicable 250 Nanoseconds Max FBR3.5 3,500 250 Nanoseconds Max FBR4 4,000 250 Nanoseconds Max Electrical Characteristics (at TA = 25°C Unless Otherwise Specified) ELECTRICAL CHARACTERISTIC AVERAGE FORWA RD CURRENT, I O (With Proper Heat sink) AVERAGE FORWA RD CURRENT, I O (Circuit Board Mounted) MAX FORWARD VOLTAGE DROP (@ 20 Amps), MAX SURGE CURRENT (1/2 CYCLE, 60 Hz) MAX DC REVERSE CURRENT (25ºC) OPERATING TEMPERATURE RANGE STORAGE TEMPERATURE RANGE FB Series FBR Series 4.0 A 3.0 A 2.0 A 1.5 A 5.0 V 6.5 V 800 A 800 A 5.0 ìA 5.0 ìA -55 To 150ºC -55 To 150ºC NOTES: It is recommended that a proper heat sink be used on the terminals of this device between the body and the soldering point to prevent damage from excess heat. EDI reserves the right to change these specifications at any time without notice. ELECTRONIC DEVICES, INC. DESIGNERS AND MANUFACTURERS OF SOLID STATE DEVICES SINCE 1951. 21 GRAY OAKS AVENUE * YONKERS. NEW YORK 10710 914-965-4400 EE-mail:[email protected] *Wwebsite: http://www.edidiodes.com * FAX 914-965-5531 * 1-800-678-0828 FB FBR NOTE: Maximum lead and terminal temperature for soldering: 1/4 inch from case, for 5 seconds at 250°C TEST CIRCUIT EDI reserves the right to change these specifications at any time without notice. ELECTRONIC DEVICES, INC. DESIGNERS AND MANUFACTURERS OF SOLID STATE DEVICES SINCE 1951. 21 GRAY OAKS AVENUE * YONKERS. NEW YORK 10710 914-965-4400 EE-mail:[email protected] *Wwebsite: http://www.edidiodes.com * FAX 914-965-5531 * 1-800-678-0828