HIGH EFFICIENCY GLASS PASSIVATED RECTIFIER HER601G THRU HER607G VOLTAGE RANGE 50 to 1000 Volts CURRENT 6.0 Ampere FEATURES • • • • • • R-6 Glass passivated chip junction Low power loss, high efficiency Low leakage High speed switching High surge capacity High temperature soldering guaranteed 260℃/10 seconds,0.375″(9.5mm) lead length MECHANICAL DATA • • • • • • Case: Transfer molded plastic Epoxy: UL94V-0 rate flame retardant Polarity: Color band denotes cathode end Lead: Plated axial lead, solderable per MIL-STD-202E method 208C Mounting position: Any Weight: 0.07ounce, 2.0 gram Dimensions in inches and (millimeters) MAXIMUM RATINGS AND ELECTRICAL CHARACTERISTICS • • • Ratings at 25℃ ambient temperature unless otherwise specified Single Phase, half wave, 60Hz, resistive or inductive load For capacitive load derate current by 20% HER HER SYMBOLS 601G 602G Maximum Repetitive Peak Reverse Voltage VRRM 50 100 Maximum RMS Voltage VRMS 35 70 Maximum DC Blocking Voltage VDC 50 100 Maximum Average Forward Rectified Current 0.375″(9.5mm) lead length at T A =50℃ Peak Forward Surge Current 8.3ms single half sine-wave superimposed on rated load (JEDEC method) HER 603G 200 140 200 HER 604G 300 210 300 I(AV) HER 605G 400 280 400 HER 606G 600 420 600 HER 607G 800 560 800 6.0 IFSM Volts Volts Volts Amps 200 150 VF Maximum DC Reverse Current at rated TA = 25℃ DC Blocking Voltage at TA = 125℃ IR 10 500 µA IR(AV) 150 µA Typical Junction Capacitance (NOTE 2) Typical Thermal Resistance (NOTE 1) Operating Junction Temperature Range Storage Temperature Range trr CJ RθJA TJ TSTG 1.3 70 100 40 20 (-55 to +150) (-55 to +150) Notes: 1. Thermal Resistance from Junction to ambient with 0.375″(9.5mm) lead length, PCB mounted. 2. Measured at 1.0MHz and applied reverse voltage of 4.0V E-mail: [email protected] 1.5 Amps Maximum Instantaneous Forward Voltage at 6.0A Maximum Full Load Reverse Current, full cycle average 0.375″(9.5mm) lead length at TL =55℃ Maximum Reverse Recovery Time Test conditions IF =0.5A, IR =1.0A, IRR =0.25A, 1.0 UNIT Web Site: www.cnmic.com 1.7 Volts nS pF ℃/W ℃ ℃ HIGH EFFICIENCY GLASS PASSIVATED RECTIFIER HER601G THRU HER607G VOLTAGE RANGE 50 to 1000 Volts CURRENT 6.0 Ampere FIG.1-TYPICAL FORWARD CURRENT FIG.2-MAXIMUM NON-REPETITIVE PEAK DERATING CURVE FORWARD SURGE CURRENT PEAK FORWARD SURGE 6.0 2.0 Single Phase Half Wave 60Hz Resistive or Inductive Load 0.375″(9.5mm) Lead Length 200 CURRENT, (A) 4.0 (A) AVERAGE FORWARD CURRENT, RATING AND CHRACTERISTIC CURVES HER601G THRU HER607G 8.3ms Single Half Sine-Wave (JEDEC Method) T= Tjmax HE 100 HE R6 R6 0 1 Cycle 01G 6 G -H 0 0 25 100 75 50 125 175 150 -H E ER R6 05G 607 G 0 1 2 AMBIENT TEMPERATURE, (° C) 4 6 8 10 40 20 60 100 NUMBER OF CYCLES AT 60 Hz FIG.3-TYPICAL INSTANTANEOUS FORWARD CHARACTERISTICS FIG.4-TYPICAL REVERSE CHARACTERISTICS V 80 0V 60 0V 1.0 0.1 TJ =25° C Pulse Width=300us 1% Duty Cycle 100 10 (μA) INSTANTANEOUS REVERSE CURRENT, V 00 0 -4 30 50 - 200 10 (A) INSTANTANEOUS FORWARD CURRENT, 100 TJ =100° C 1.0 TJ =25° C 0.01 0.4 0.6 0.8 1.0 1.2 1.4 1.6 0.1 1.8 0 20 INSTANTANEOUS FORWARD VOLTAGE,(V) 40 60 80 100 120 140 PERCENT OF RATED PEAK REVERSE VOLTAGE,(%) FIG.5-TYPICAL JUNCTION CAPACITANCE JUNCTION CAPACITANCE,(pF) 1000 F1G.6-TEST CIRCUIT DIAGRAM AND REVERSE RECOVERY TIME CHARACTERISTIC Trr 50Ω 10Ω NONINDUCTIVE NONINDUCTIVE +0.5A (-) 100 (+) 25 Vdc (approx.) (-) TJ =25° C f=1MHz Vsig=50mVp-p 1.0 1Ω NON INDUCTIVE PULSE GENERATIOR (NOTE 2) 0 -0.25A (+) OSCILLOSCOPE (NOTE 1) -1.0A 1cm 10 0.1 D.U.T. 10 100 REVERSE VOLTAGE,(V) E-mail: [email protected] NOTES : 1.Rise Time=7ns mas. Input Impedance= 1 magohm. 22pF 2.Rise time=10ns max. Source Impedance= 50 ohms Web Site: www.cnmic.com SET TIME BASE FOR 50/100ns/cm