RF AMPLIFIER MODEL TM3110PM Available as: Features Typical Intermodulation Performance at 25 ºC Superior Phase Noise Performance High Output Power: +30 dBm Typical Operating Temp. -55 ºC to +85 ºC Environmental Screening Available Second Order Harmonic Intercept Point ...... +66 dBm (Typ.) Second Order Two Tone Intercept Point ....... +63 dBm (Typ.) Third Order Two Tone Intercept Point ........... +45 dBm (Typ.) Absolute Maximum (No Damage) Ratings Ambient Operating Temperature ................ -55ºC to +100 ºC Storage Temperature ................................. -62ºC to +125 ºC Case Temperature .................................................. +125 ºC DC Voltage .......................................................... +17 Volts Continuous RF Input Power .................................. +15 dBm Short Term RF Input Power ........... 100 mW (1 Minute Max.) Maximum Peak Power .................... 0.2 Watt (3 µsec Max.) Specifications CHARACTERISTIC Frequency (MHz) TYPICAL Ta= 25 ºC MIN/MAX Ta = -55 ºC to +85 ºC 10 - 200 MHz 10 - 200 MHz Gain (dB) 15.5 15 Min. Power @ 1 dB Comp. (dBm) +30 +29 Min. -17 1.8:1 1.8:1 3.5 -16 Max. 2.0:1 Max. 2.0:1 Max. 4.5 Max. +15 240 +15 250 Max. Reverse Isolation (dB) VSWR In Out Noise Figure (dB) Power Vdc mA TM3110PM, 4 Pin TO-8 (T4) TN3110PM, 4 Pin Surface Mount (SM3) BX3110PM, Connectorized Housing (H1) Guaranteed @ 25 ºC (160 MHz) Phase Noise Performance (dBc/Hz)* Frequency Typical -160 -170 -175 -180 -180 100 Hz 1 kHz 10 kHz 100 kHz 1 MHz Note: Care should always be taken to effectively ground the case of each unit. Guarantee -155 -165 -170 -175 -175 *Note: Phase Noise Performance typically tested at midband. Bandedge performance may vary. Typical Performance Data Gain (dB) 18 Reverse Isolation (dB) 0 17 -10 16 -20 15 -30 14 Start 10 MHz +32 Stop 200 MH z 1 dB Comp. (dBm) +30 4 +29 +28 3 2.0 Input VSWR Stop 200 MHz Start 10 MHz Noise Figure (dB) Stop 2 00 MHz -1 70 -19 0 10 0 2 Start 10 MHz Output VSWR Stop 2 00 MHz Legend Stop 20 0 MHz +25 ºC 1.5 Start 1 0 MHz 1k 10 k 100k 1M Typical Residual Phase Noise Test Conditions: Carrier Frequency: 160 MHz Power Output +29.0 dBm Temperature: 25 oC 1.75 Sta rt 10 MH z -1 60 -1 80 2.0 1.75 1.5 -1 50 6 5 Sta rt 10 MH z -1 40 -40 +31 Phase Noise (dBc/Hz) -13 0 Stop 2 00 MHz Agilent ES5500 System +85 ºC - - - - - - -55 ºC Spectrum Microwave · 2144 Franklin Drive N.E. · Palm Bay, Florida 32905 · PH (888) 553-7531 · Fax (888) 553-7532 Rev. 4/26/10 www.SpectrumMicrowave.com Spectrum Microwave · 2707 Black Lake Place · Philadelphia, Pennsylvania 19154 · PH (215) 464-4000 · Fax (215) 464-4001